1EZ180D5

MCC Features
  omponents 21201 Itasca Street Chatsworth    !"# $ %    !"# 1EZ110D5 THRU 1EZ200D5 1.0 W Silicon Zener Diodes 100 to 200 Volts DO-41 • • • • Zener Voltage 100V to 200V Silicon Planar Power Zener Diodes Low profile package Glass passivated junction • • • Mechanical Data Case: Molded plastic, DO-41 Polarity: Color band denotes cathode end Weight: 0.012 ounce, 0.3 gram Maximum Ratings Symbol Peak Pulse Power Dissipation on TA=50 oC (1) Derate above 50 oC Junction Temperature Storage Temperature Range PD TJ TSTG Value 1.0 6.67 150 -55 to 150 Units W mW/ oC o C o C D A Cathode Mark B D Electrical Characteristics @ 25° C Unless Otherwise Specified Peak Forward Surge Current (2) Maximum Forward Voltage @ I F=200mA Symbol IFSM VF Value 10 1.2 Unit A V C NOTE: (1) Mounted on 5.0mm2 (.013mm thick) land areas. (2) Measured on 8.0ms, single half sine-wave or equivalent square wave, duty cycle=4 pulses per minute maximum. DIMENSIONS INCHES DIM M IN A B C D 0.160 0.080 0.028 1.000 MAX 0.205 0.107 0.034 ----MIN 4.10 2.00 0.71 25.40 MAX 5.20 2.70 0.86 ----Diameter Diameter MM NOTE www.mccsemi.com 1EZ110D5 thru 1EZ200D5 MCC MAXIMUM ZENER IMPEDANCE (3) ZZT Ohms 450 550 700 900 1000 1100 1150 1200 1350 1500 ZZK Ohms 4000 4500 5000 5500 6000 6500 6800 7000 7500 8000 IZK mA 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 LEAKAGE CURRENT IR ìA 5.0 5.0 5.0 5.0 5.0 5.0 5.0 5.0 5.0 5.0 VR V 83.6 91.2 98.8 106.4 114.0 121.6 129.2 136.8 144.4 152.0 TYPICAL TEMP. COEFFICIENT %/ oC +0.095 +0.095 +0.095 +0.095 +0.095 +0.095 +0.095 +0.095 +0.095 +0.100 MCC PART NUMBER 1EZ110D5 1EZ120D5 1EZ130D5 1EZ140D5 1EZ150D5 1EZ160D5 1EZ170D5 1EZ180D5 1EZ190D5 1EZ200D5 ZENER VOLTAGE @TEST CURRENT (1,2) VZ V 110 120 130 140 150 160 170 180 190 200 IZT mA 2.3 2.0 1.9 1.8 1.7 1.6 1.5 1.4 1.3 1.2 Note: (1) Specials Available Include: A: Nominal zener voltages between the voltages shown and tighter voltage Tolerances. B: Matched sets. (2) Zener Voltage (V Z) Measurement. Guarantess the zener voltage when measured at 90 seconds while maintaining the lead temperature (TL) at 30 oC + or - 1 oC, from the diode body. (3) Zener Impedance (ZZ) Derivation. The zener impedance is derived from the 60 cycle ac voltage, which results when an ac current having an rms value equal to 10% of the dc zener current (IZT or IZK) is superimposed on IZT or IZK. PD, MAXIMUM POWER DISSIPATION (WATTS) 1.25 1.0 0.75 0.50 0.25 0 0 L = LEAD LENTGH TO HEAT SINK 20 40 8 0 1 00 1 20 1 40 1 60 180 2 00 TL, LEAD TEMPERATURE Fig. 1-POWER TEMPERATURE DERATING CURVE www.mccsemi.com 1EZ110D5 thru 1EZ200D5 MCC £K VZ, TEMPERATURE COEFFICIENT(mV/W) 100 70 50 30 20 10 7.0 5.0 3.0 2.0 1.0 10 RANGE VZ @ IZT 20 30 70 VZ, ZENER VOLTAGE (VOLTS) Fig. 2-TEMPERATURE COEFFICIENTS 1000 Zz, dynamic impedance (ohms) 500 200 100 50 20 10 5.0 TJ = 25¢J IZ(ms) = 0.1IZ(dc) f = 60Hz 47V 27V 0.8V 2.0 1.0 0.1 0.2 0.5 1.0 2 .0 5.0 10 20 50 100 IZ, ZENER CURRENT (mA) Fig. 3-EFFECT OF ZENER CURRENT ON ZENER IMPEDANCE www.mccsemi.com