ER3M-HT

MCC TM Micro Commercial Components
  omponents 20736 Marilla Street Chatsworth    !"# $ %    !"# ER3A-HT THRU ER3M-HT 3.0 Amp High Efficient Rectifiers 50 to 1000 Volts • Features Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates Compliant. See ordering information) High surge current capability High reliability Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 • • Maximum Ratings Operating Temperature: -55 to +125 Storage Temperature: -55 to +150 MCC Part Number Device Marking ER3A-HT ER3B-HT ER3D-HT ER3G-HT ER3J-HT ER3K-HT ER3M-HT ER3A ER3B ER3D ER3G ER3J ER3K ER3M Maximum Recurrent Peak Reverse Voltage 50V 100V 200V 400V 600V 800V 1000V Maximum RMS Voltage 35V 70V 140V 280V 420V 560V 700V Maximum DC Blocking Voltage 50V 100V 200V 400V 600V 800V 1000V DO-214AB (HSMC) (Round Lead) H Cathode Band J A C E D Electrical Characteristics @ 25 Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage ER3A-HT~ER3D-HT ER3G-HT ER3J-HT~ER3M-HT Unless Otherwise Specified 3.0A 150A TA = 55 8.3ms, half sine DIM A B C D E F G H J F G DIMENSIONS INCHES MIN .200 .177 .002 --. 047 .168 .309 .239 .234 MAX .214 .203 .005 .02 .056 .179 . 322 .243 .240 MM MIN 5.08 4. 70 .05 --1. 20 4.27 7.85 6.08 5.95 MAX 5.43 5. 30 .13 .51 1. 42 4.55 8. 18 6.18 6.10 B IF(AV) IFSM NOTE VF 1.0V 1.3V 1.7V IFM = 3.0A; TA = 25 * Maximum DC Reverse Current At Rated DC Blocking Voltage Maximum Reverse Recovery Time ER3A-HT~ER3G-HT ER3J-HT~ER3M-HT SUGGESTED SOLDER PAD LAYOUT IR 10uA 200uA TA = 25 TA = 100 0.200” 0.190 Trr 50ns 75ns IF=0.5A, IR=1.0A IRR=0.25A Measured at 1.0MHz, VR=4.0V 0.070” Typical Junction Capacitance E R3A-HT~ER3G-HT ER3J-HT~ER3M-HT 80pF 50pF *Pulse Test: Pulse Width 300 µsec, Duty Cycle 1% Note: CJ 1. High Temperature Solder Exemptions Applied, see EU Directive Annex 7. Revision: A www.mccsemi.com 1 of 3 2011/01/01 ER3A-HT THRU ER3M-HT RATINGS AND CHARACTERISTIC CURVES FIG.1- REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM AVERAGE FORWARD CURRENT. (A) 50W NONINDUCTIVE 10W NONINDUCTIVE +0.5A (-) DUT (+) 50Vdc (approx) (-) PULSE GENERATOR (NOTE 2) 1W NON INDUCTIVE OSCILLOSCOPE (NOTE 1) (+) 0 -0.25A trr MCC TM Micro Commercial Components FIG.2- MAXIMUM AVERAGE FORWARD CURRENT DERATING 6 5 4 3 2 1 Single Phase Half Wave 60Hz Resistive or Inductive Load 0.375" (9.5mm) Lead Length NOTES: 1. Rise Time=7ns max. Input Impedance= 1 megohm 22pf 2. Rise Time=10ns max. Sourse Impedance= 50 ohms -1.0A 1cm SET TIME BASE FOR 5/ 10ns/ cm 25 50 75 100 125 150 175 O AMBIENT TEMPERATURE. ( C) FIG.3- TYPICAL REVERSE CHARACTERISTICS 1000 FIG.5- TYPICAL FORWARD CHARACTERISTICS 100.0 INSTANTANEOUS FORWARD CURRENT. (A) INSTANTANEOUS REVERSE CURRENT. ( A) ER 3A -H T~ E R3 100 10.0 T 3G -H ER ER 3J -H T~ E DH Tj=100 0C Tj=25 0C T R3 M -H 1.2 Tj=25 0C 10 1.0 1.0 .1 0.1 20 40 60 80 100 120 .01 .2 PERCENT OF RATED PEAK REVERSE VOLTAGE. (%) .4 .6 .8 1.0 FORWARD VOLTAGE. (V) T 1.4 300 FIG.4- MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT 175 150 125 100 75 50 FIG.6- TYPICAL JUNCTION CAPACITANCE PEAK FORWARD SURGE CURRENT. (A) 200 JUNCTION CAPACITANCE.(pF) ER 3A -H ER T~ E 3JH T~ E R3 G- HT 100 R3 MHT 25 0 0 1 10 100 1000 .1 .5 1 2 5 10 20 50 100 200 500 NUMBER OF CYCLES AT 60Hz REVERSE VOLTAGE. (V) www.mccsemi.com Revision: A 2 of 3 2011/01/01 MCC Micro Commercial Components TM Ordering Information : Device Part Number-TP Packing Tape&Reel: 1.5Kpcs/Reel ***IMPORTANT NOTICE* ** Micro Comme rcial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Comme rcial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Co mponents Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from A uthorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC' s quality standards for handling and storage. MCC will not pro vide any warranty coverage or o ther assistance for parts bought from Unau thorized Source s. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. Revision: A www.mccsemi.com 3 of 3 2011/01/01