FR2G

MCC Features
  omponents 21201 Itasca Street Chatsworth    !"# $ %    !"# FR2A THRU FR2M 2 Amp Fast Recovery Silicon Rectifier 50 to 1000 Volts DO-214AA (SMBJ) (Round Lead) H Cathode Band • • • • • For Surface Mount Applications Extremely Low Thermal Resistance Easy Pick And Place High Temp Soldering: 250 °C for 10 Seconds At Terminals Superfast Recovery Times For High Efficiency Maximum Ratings • • • Operating Temperature: -50 °C to +150°C Storage Temperature: -50°C to +150°C Maximum Thermal Resistance; 15 °C/W Junction To Lead MCC Device Maximum Maximum Maximum Catalog Marking Recurrent RMS DC Number Peak Reverse Voltage Blocking Voltage Voltage FR2A FR2A 50V 35V 50V FR2B FR2B 100V 70V 100V FR2D FR2D 200V 140V 200V FR2G FR2G 400V 280V 400V FR2J FR2J 600V 420V 600V FR2K FR2K 800V 560V 800V FR2M FR2M 1000V 700V 1000V J A C E F G D B Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward I F(AV) 2.0A TA = 90°C current Peak Forward Surge IFSM 50A 8.3ms, half sine Current IFM = 2.0A; Maximum 1.30V Instantaneous VF TJ = 25°C* Forward Voltage Maximum DC Reverse Current At IR 5µA TJ = 25°C Rated DC Blocking 200µA TJ = 125°C Voltage Maximum Reverse Recovery Time 150ns FR2A-G IF=0.5A, IR=1.0A, Trr 250ns Irr=0.25A FR2J 500ns FR2K-M Typical Junction CJ 40pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse test: Pulse width 300 µsec, Duty cycle 1% DIM A B C D E F G H J DIMENSIONS INCHES MIN .078 .075 .002 ----.035 .065 .205 .160 .130 MM MIN 1.98 1.90 .05 ----.90 1.65 5.21 4.06 3.30 MAX .116 .089 .008 .02 .055 .091 .224 .180 .155 MAX 2.95 2.25 .20 .51 1.40 2.32 5.69 4.57 3.94 NOTE SUGGESTED SOLDER PAD LAYOUT 0.090" 0.085” 0.070” www.mccsemi.com FR2A thru FR2M Figure 1 Typical Forward Characteristics 20 10 6 4 2.5 2 Amps 1 .6 .4 .2 .1 .06 .04 .02 .01 .4 .6 .8 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts 1.0 1.2 1.4 0 .5 Amps 1.0 25°C 3.0 Figure 2 Forward Derating Curve MCC 2.0 1.5 Single Phase, Half Wave 60Hz Resistive or Inductive Load 0 50 75 100 °C Average Forward Rectified Current - Amperes ersus v Ambient Temperature - °C 125 150 175 Figure 3 Junction Capacitance 100 60 40 20 pF 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 TJ=25°C Junction Capacitance - pFversus Reverse Voltage - Volts www.mccsemi.com FR2A thru FR2M Figure 4 Maximum Non-Repetitive Forward Surge Current 90 75 60 45 Amps 30 15 0 1 4 6 8 10 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles 20 40 60 80 100 MCC 2 Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 25Vdc Pulse Generator Note 2 1Ω Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive www.mccsemi.com