FS1A-LTP

NOT RECOMMENDED FOR NEW DESIGNS USE FS1A-LTP~FS1M-LTP SERIES MCC TM Micro Commercial Components FS1A THRU
  omponents 20736 Marilla Street Chatsworth    !"# $ %    !"# FS1M Features • • • • • • • Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates Compliant. See ordering information) Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 Easy Pick And Place High Temp Soldering: 260°C for 10 Seconds At Terminals Superfast Recovery Times For High Efficiency Halogen free available upon request by adding suffix "-HF" 1 Amp Fast Recovery Silicon Rectifier 50 to 1000 Volts Maximum Ratings Operating Temperature: -50°C to +150°C • • • • DO-214AC (HSMA) Storage Temperature: -50°C to +150°C Maximum Thermal Resistance; 15 °C/W Junction To Lead Maximum Thermal Resistance; 88°C/W Junction To Ambient MCC Catalog Number Device Marking FS1A FS1B FS1D FS1G FS1J FS1K FS1M FS1A FS1B FS1D FS1G FS1J FS1K FS1M Maximum Recurrent Peak Reverse Voltage 50V 100V 200V 400V 600V 800V 1000V Maximum RMS Voltage 35V 70V 140V 280V 420V 560V 700V H Cathode Band Maximum DC Blocking Voltage 50V 100V 200V 400V 600V 800V 1000V J A E D Note: B F G DIMENSIONS Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward IF(AV) 1.0A Ta = 90°C current Peak Forward Surge IFSM 30A 8.3ms, half sine Current IFM = 1.0A; Maximum 1.30V Instantaneous VF TJ = 25°C* Forward Voltage Maximum DC Reverse Current At IR 5µA TJ = 25°C Rated DC Blocking 200µA TJ = 125°C Voltage Maximum Reverse Recovery Time 150ns IF=0.5A, IR=1.0A, FS1A-G Trr 250ns Irr=0.25A FS1J 500ns FS1K-M Typical Junction CJ 50pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse test: Pulse width 200 µsec, Duty cycle 2% C DIM A B C D E F G H J INCHES MIN .078 .067 .002 --.035 .065 .205 .160 .100 MM MIN 1.98 1.70 .05 --.89 1.65 5.21 4.06 2.57 MAX .116 .089 .008 .02 .055 .096 .224 .180 .112 MAX 2.95 2.25 .20 .51 1.40 2.45 5.69 4.57 2.84 NOTE SUGGESTED SOLDER PAD LAYOUT 0.090” 0.085” 0.070” 1. High Temperature Solder Exemptions Applied, see EU Directive Annex 7. www.mccsemi.com Revision: D 1 of 4 2013/01/01 MCC FS1A thru FS1M Figure 1 Typical Forward Characteristics Micro Commercial Components 20 Figure 2 Forward Derating Curve 10 2.4 6 2.2 2.0 4 1.8 2 1.6 25°C Amps 1.4 1 1.2 .6 Amps .4 1.0 .8 .6 .2 .4 Single Phase, Half Wave .2 60Hz Resistive or Inductive Load .1 .06 0 .04 0 25 50 75 100 125 150 °C Average Forward Rectified Current - Amperesversus Ambient Temperature - °C .02 .01 .8 .6 10 1.2 1.4 1.6 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF TJ=25°C 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 Junction Capacitance - pFversus Reverse Voltage - Volts www.mccsemi.com Revision: D 2 of 4 2013/01/01 TM MCC FS1A thru FS1M TM Figure 4 Peak Forward Surge Current Micro Commercial Components 36 30 24 Figure 5 New SMA Assembly 18 Amps 12 6 0 Round Lead Process 1 4 2 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles Figure 7 Typical Reverse Characteristics Figure 6 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 100 60 10Ω 40 20 10 Pulse Generator Note 2 25Vdc 1Ω 6 4 TA=125°C 2 Oscilloscope Note 1 µAmps 1 Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive .6 .4 .2 .1 trr +0.5A .06 .04 0 -0.25 TA=25°C .02 .01 20 40 -1.0 60 80 100 120 140 Volts 1cm Set Time Base for 20/100ns/cm Instantaneous Reverse Leakage Current - MicroAmperesversus Percent Of Rated Peak Reverse Voltage - Volts www.mccsemi.com Revision: D 3 of 4 2013/01/01 MCC TM Micro Commercial Components Ordering Information : Device Packing Part Number-TP Tape&Reel: 3Kpcs/Reel Note : Adding "-HF" suffix for halogen free, eg. Part Number-TP-HF ***IMPORTANT NOTICE*** Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. www.mccsemi.com Revision: D 4 of 4 2013/01/01 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Micro Commercial Components (MCC): FS1D-LTP FS1K-LTP FS1M-LTP FS1G-LTP FS1J-LTP FS1A-LTP FS1B-LTP FS1M-TP