FS1B-L

MCC TM Micro Commercial Components
  omponents 20736 Marilla Street Chatsworth    !"# $ %    !"# FS1A-L THRU FS1M-L 1 Amp Fast Recovery Silicon Rectifier 50 to 1000 Volts
DO-214AC
(SMA) (LEAD FRAME) H Features • • • • • Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 Easy Pick And Place High Temp Soldering: 260 °C for 10 Seconds At Terminals Fast Recovery Times For High Efficiency Maximum Ratings • • • Operating Temperature: -50 °C to +150°C Storage Temperature: -50°C to +150°C Maximum Thermal Resistance; 15 °C/W Junction To Lead MCC Device Maximum Maximum Maximum Catalog Marking Recurrent RMS DC Number Peak Reverse Voltage Blocking Voltage Voltage FS1A-L FS1A 50V 35V 50V FS1B-L FS1B 100V 70V 100V FS1D-L FS1D 200V 140V 200V FS1G-L FS1G 400V 280V 400V FS1J-L FS1J 600V 420V 600V FS1K-L FS1K 800V 560V 800V FS1M-L FS1M 1000V 700V 1000V


J A E F G C D B Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward IF(AV) 1.0A Ta = 90°C current Peak Forward Surge IFSM 30A 8.3ms, half sine Current IFM = 1.0A; Maximum 1.30V VF Instantaneous TJ = 25°C* Forward Voltage Maximum DC Reverse Current At IR 5µA TJ = 25°C Rated DC Blocking 200µA TJ = 125°C Voltage Maximum Reverse Recovery Time 150ns FS1A-L-G-L IF=0.5A, IR=1.0A, Trr 250ns Irr=0.25A FS1J-L 500ns FS1K-L-M-L Typical Junction CJ 50pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse test: Pulse width 200 µsec, Duty cycle 2% DIM A B C D E F G H J INCHES MIN .079 .050 .002 --.030 .065 .189 .157 .090 MAX .096 .064 .008 .02 .060 .091 .220 .181 .115 DIMENSIONS MM MIN 2.00 1.27 .05 --.76 1.65 4.80 4.00 2.25 MAX 2.44 1.63 .20 .51 1.52 2.32 5.59 4.60 2.92 NOTE SUGGESTED SOLDER PAD LAYOUT 0.090” 0.085” 0.070” www.mccsemi.com Revision: A 1 of 4 2011/01/01 FS1A-L thru FS1M-L Figure 1 Typical Forward Characteristics 20 10 6 4 2 25°C Amps 1 .6 .4 .2 .1 .06 .04 .02 .01 .6 .8 10 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts 1.2 1.4 1.6 Amps 2.4 2.2 2.0 1.8 1.6 1.4 1.2 1.0 .8 .6 .4 Figure 2 Forward Derating Curve MCC Micro Commercial Components TM Single Phase, Half Wave .2 60Hz Resistive or Inductive Load 0 0 25 50 75 °C Average Forward Rectified Current - Amperes ersus v Ambient Temperature - °C 100 125 150 Figure 3 Junction Capacitance 100 60 40 20 pF 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 TJ=25°C Junction Capacitance - pFversus Reverse Voltage - Volts www.mccsemi.com Revision: A 2 of 4 2011/01/01 FS1A-L thru FS1M-L Figure 4 Peak Forward Surge Current 36 30 24 18 Amps 12 6 0 1 4 6 8 10 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles 20 40 60 80 100 MCC TM Micro Commercial Components 2 Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 25Vdc Pulse Generator Note 2 1Ω Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive www.mccsemi.com Revision: A 3 of 4 2011/01/01 MCC TM Micro Commercial Components Ordering Information : Device Part Number-TP Packing Tape&Reel: 5Kpcs/Reel ***IMPORTANT NOTICE* ** Micro Comme rcial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Comme rcial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Co mponents Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from A uthorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC' s quality standards for handling and storage. MCC will not pro vide any warranty coverage or o ther assistance for parts bought from Unau thorized Source s. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. www.mccsemi.com Revision: A 4 of 4 2011/01/01