MURX0520

MCC Features • • • • •
  omponents 21201 Itasca Street Chatsworth    !"# $ %    !"# MURX0510 THRU MURX0560 0.5 Amp Super Fast Recovery Rectifier 100 to 600 Volts SOD-123 A B For Surface Mount Application Low Leakage Low Forward Voltage Drop Extremely Low Thermal Resistance Super Fast Recovery Time For High Efficiency Maximum Ratings • • • Operating Temperature: -40 to +150 Storage Temperature: -40 to +150 Maximum Thermal Resistance: 200 /W Junction to Ambient Maximum Recurrent Peak Reverse Voltage Maximum DC Blocking Voltage C E MCC Part Number Device Marking Maximum RMS Voltage MURX0510 MURX0520 MURX0530 MURX0540 MURX0550 MURX0560 U1 U2 U3 U4 U5 U6 100V 200V 300V 400V 500V 600V 70V 140V 210V 280V 350V 420V 100V 200V 300V 400V 500V 600V DIM A B C D E G H J G J H D Electrical Characteristics @ 25 Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage Maximum DC Reverse Current At Rated DC Blocking Voltage Maximum Reverse Recovery Time Typical Junction Capacitance IF(AV) IFSM Unless Otherwise Specified 0.5 A 8.0A TL = 115 8.3ms, half sine IFM =0.5A; TA = 25 VF 1.35V DIMENSIONS INCHES MM MIN MAX MIN MAX .140 .152 3.55 3.85 .100 .112 2.55 2.85 .055 .071 1.40 1.80 - ---.053 ----1.35 .012 .031 0.30 .78 .006 ----0.15 ----- ---.01 ----.25 - ---.006 ----.15 SUGGESTED SOLDER PAD LAYOUT 0.093” NOTE IR 5.0µA TA = 25 IF=0.5A, IR=1.0A, Irr=0.25A Measured at 1.0MHz, VR=4.0V Trr CJ 75ns 10pF 0.048” *Pulse Test: Pulse Width 300µsec, Duty Cycle 2% 0.036” www.mccsemi.com MURX0510 thru MURX0560 Figure 1 Typical Forward Characteristics 2.0 1.0 .6 .4 .5 .2 2 5 °C Amps .1 .06 .04 .02 .01 .006 .004 .002 .001 .4 .6 .8 Volts Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts 1.0 1.2 1.4 0 .1 Amps .2 .4 .6 MCC Figure 2 Forward Derating Curve .3 Single Phase, Half Wave 60Hz Resistive or Inductive Load 0 50 75 100 °C Average Forward Rectified Current - Amperes versus Ambient Temperature - °C 125 150 175 Figure 3 Junction Capacitance 10 6 4 2 pF 1 .6 .4 .2 .1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 TJ=25°C Junction Capacitance - pF versus Reverse Voltage - Volts www.mccsemi.com MURX0510 thru MURX0560 Figure 4 Typical Reverse Characteristics 100 60 40 20 10 6 4 2 TA=100°C µAmps 1 .6 .4 .2 .1 .06 .04 .02 .01 2 4 60 80 Volts Instantaneous Reverse Leakage Current - MicroAmperes versus Percent Of Rated Peak Reverse Voltage - Volts Figure 6 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω 100 120 140 TA=25°C Amps TA=150°C 6.0 4.5 3.0 1.5 0 1 2 4 6 9.0 7.5 MCC Figure 5 Peak Forward Surge Current 8 10 Cycles 20 40 60 80 100 Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles trr +0.5A 0 25Vdc Pulse Generator Note 2 1Ω Oscilloscope Note 1 -0.25 1.0 1cm Set Time Base for 20/100ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive www.mccsemi.com