SF13M

MCC Micro Commercial Components TM
  omponents 20736 Marilla Street Chatsworth    !"# $ %    !"# SF11M THRU SF18M 1 Amp Glass Passivated Super Fast Recovery Rectifier 50 to 600 Volts DO-214AC (HSMA) (High Profile) H Features • • • • • • Lead Free Finish/RoHS Compliant(Note 1) ("P" Suffix designates RoHS Compliant. See ordering information) High Surge Capability Low Leakage Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 Super Fast Switching Speed For High Efficiency Maximum Ratings • • Operating Temperature: -65 °C to +150°C Storage Temperature: -65°C to +150°C MCC Catalog Number Device Marking Maximum Recurrent Peak Reverse Voltage 50V 100V 150V 200V 300V 400V 600V Maximum RMS Voltage Maximum DC Blocking Voltage 50V 100V 150V 200V 300V 400V 600V Cathode Band J SF11M SF12M SF13M SF14M SF15M SF16M SF18M SF11 SF12 SF13 SF14 SF15 SF16 SF18 35V 70V 105V 140V 210V 280V 420V A C E F G D B Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward IF(AV) 1A TA = 55°C Current Peak Forward Surge IFSM 30A 8.3ms, half sine Current Maximum Instantaneous Forward Voltage .975V IFM = 1.0A; SF11M-SF15M VF 1.75V TA = 25°C SF16M-SF18M Maximum DC Reverse Current At IR 5µA TA = 25°C Rated DC Blocking 50µA TA = 150°C Voltage Maximum Reverse Recovery Time Trr 35ns IF=0.5A, IR=1.0A, SF11M-SF15M SF16M-SF18M 50ns Irr=0.25A Typical Junction Capacitance 15pF Measured at SF11M-SF15M CJ 10pF 1.0MHz, VR=4.0V SF16M-SF18M *Pulse Test: Pulse Width 300 µsec, Duty Cycle 1% Notes: 1. High Temperature Solder Exemption Applied, see EU Directive Annex Notes 7. DIM A B C D E F G H J DIMENSIONS INCHES MIN .078 .067 .002 --.035 .065 .205 .160 .100 MAX .116 .089 .008 .02 .055 .096 .224 .180 .112 MM MIN 1.98 1.70 .05 --.89 1.65 5.21 4.06 2.57 MAX 2.95 2.25 .20 .51 1.40 2.45 5.69 4.57 2.84 NOTE SUGGESTED SOLDER PAD LAYOUT 0.090” 0.085” 0.070” Revision: A www.mccsemi.com 1 of 4 2011/01/01 SF11M thru SF18M Figure 1 Typical Forward Characteristics 20 10 6 4 1.25 1.5 MCC Micro Commercial Components Figure 2 Forward Derating Curve TM 2 25°C Amps 1 .6 .4 .2 SF16M - SF18M 1.0 .75 Amps SF11M - SF15M .5 .1 .06 .04 .02 .01 .4 .6 .8 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts .25 Single Phase, Half Wave 60Hz Resistive or Inductive Load 0 0 50 75 100 °C Average Forward Rectified Current - Amperes versus Ambient Temperature -°C 125 150 175 1.0 1.2 1.4 Figure 3 Junction Capacitance 100 60 40 SF11M - SF15M 20 pF 10 SF16M - SF18M 6 TJ=25°C 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 Junction Capacitance - pFversus Reverse Voltage - Volts Revision: A www.mccsemi.com 2 of 4 2011/01/01 SF11M thru SF18M Figure 4 Typical Reverse Characteristics 100 60 40 20 10 6 4 2 TA=100°C Amps 30 20 TA=150°C 60 50 40 MCC Micro Commercial Components Figure 5 Peak Forward Surge Current TM µ Amps 1 .6 .4 .2 .1 .06 .04 TA=25°C 10 5 0 1 2 4 6 8 10 Cycles 20 40 60 80 100 Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles .02 .01 20 40 60 80 Volts Instantaneous Reverse Leakage Current - MicroAmperes ersus v Percent Of Rated Peak Reverse Voltage - Volts Figure 6 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr 100 120 140 +0.5A 0 25Vdc Pulse Generator Note 2 1Ω Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Revision: A www.mccsemi.com 3 of 4 2011/01/01 MCC Micro Commercial Components TM Ordering Information : Device Part Number-TP Packing Tape&Reel: 3Kpcs/Reel ***IMPORTANT NOTICE* ** Micro Comme rcial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Comme rcial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Co mponents Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from A uthorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC' s quality standards for handling and storage. MCC will not pro vide any warranty coverage or o ther assistance for parts bought from Unau thorized Source s. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. Revision: A www.mccsemi.com 4 of 4 2011/01/01