SF14-AP

MCC TM Micro Commercial Components SF11 Thru SF18
  omponents 20736 Marilla Street Chatsworth    !"# $ %    !"# Features • • • Fast Switching Speed Marking : Type Number Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates Compliant. See ordering information) Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 Halogen free available upon request by adding suffix "-HF" • • • 1.0 Amp Super Fast Recovery Rectifiers 50 to 600 Volts Maximum Ratings • • • Operating Temperature: -55℃ to +125℃ Storage Temperature: -55℃ to +150℃ Typical Thermal Resistance: 50.0℃/W Junction To Ambient MCC Part Number SF11 SF12 SF13 SF14 SF15 SF16 SF18 Maximum Recurrent Peak Reverse Voltage 50V 100V 150V 200V 300V 400V 600V Maximum RMS Voltage Maximum DC Blocking Voltage 35V 70V 105V 140V 210V 280V 420V 50V 100V 150V 200V 300V 400V 600V DO-41 D A Cathode Mark Electrical Characteristics @ 25℃ Unless Otherwise Specified Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage SF11-SF14 SF15-SF16 SF18 Maximum DC Reverse Current At Rated DC Blocking Voltage Maximum Reverse Recovery Time Typical Junction Capacitance SF11-SF14 SF15-SF18 Note: B IF(AV) 1.0A TA = 55℃ D IFSM 30.0A 8.3ms, half sine C VF 0.95V 1.30V 1.70V IFM = 1.0A IR TRR CJ DIMENSIONS 5.0uA 100uA TA = 25℃ TA = 100℃ 35.0nS IF=0.5A, IR=1.0A, IRR=0.25A 40pF 25pF DIM A B C D INCHES MIN .166 .080 .028 1.000 MAX .205 .107 .034 --- MM MIN 4.10 2.00 .70 25.40 MAX 5.20 2.70 .90 --- NOTE Measured at 1.0MHz, VR=4.0V 1. High Temperature Solder Exemption Applied, see EU Directive Annex 7. www.mccsemi.com Revision: B 1 of 4 2013/01/01 MCC SF11 thru SF18 TM Micro Commercial Components Figure 1 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc -0.25 Oscilloscope Note 1 1Ω -1.0 1cm Set Time Base for 10ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Figure 2 Peak Forward Surge Current Figure 3 Maximum Average Forward Current Rating 36 1.5 30 24 8.3ms Single Half Sine Wave, JEDEC Method 18 Amps 1.0 12 Amps 6 0 0.5 1 2 4 6 8 10 20 40 60 80 100 Single Phase, Half Wave 60Hz Resistive or Inductive Load Cycles Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles 0 0 25 50 75 100 125 150 ℃ Average Forward Rectified Current Per Leg - Amperes versus Ambient Temperature - ℃ www.mccsemi.com Revision: B 2 of 4 2013/01/01 MCC TM SF11 thru SF18 Micro Commercial Components Figure 4 Typical Junction Characteristics Figure 5 Typical Reverse Characteristics 100 500 SF15-SF16 SF11-SF14 1.0 200 TA=100℃ Amps 0.6 µAmps 50 SF18 0.3 0.1 0 TA=25℃ 5 .4 .2 .6 .8 1.0 1.4 0 2 0 Volts 40 60 80 100 140 Volts Instantaneous Forward Current -Amperes versus Instantaneous Forward Voltage - Volts Instantaneous Reverse Leakage Current - MicroAmperes versus Percent Of Rated Peak Reverse Voltage - %Volts Figure 6 Typical Junction Characteristics 120 100 80 pF 60 SF11-SF14 40 SF15-SF18 20 .1 .5 1 2 10 5 Volts 20 50 100 200 500 1000 Capacitance - pF Reverse Voltage - Volts www.mccsemi.com Revision: B 3 of 4 2013/01/01 MCC TM Micro Commercial Components Ordering Information : Device Packing Part Number-TP Tape&Reel: 5Kpcs/Reel Part Number-AP Ammo Packing: 5Kpcs/Ammo Box Part Number-BP Bulk: 50Kpcs/Carton Note : Adding "-HF" suffix for halogen free, eg. Part Number-TP-HF ***IMPORTANT NOTICE*** Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. www.mccsemi.com Revision: B 4 of 4 2013/01/01 1