SF24G

MCC Micro Commercial Components TM
  omponents 20736 Marilla Street Chatsworth    !"# $ %    !"# SF21G THRU SF26G 2.0 Amp Super Fast Glass Passivated Rectifier 50 to 400 Volts DO-15 • Features • • • • • • Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates Compliant. See ordering information) High reliability High current capability Low forward voltage drop High surge capability Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 Operating Temperature: -65°C to +150°C Storage Temperature: -65°C to +150 °C For capacitive load, derate current by 20% MCC Part Number SF21G SF22G SF23G SF24G SF25G SF26G Maximum Recurrent Peak Reverse Voltage 50V 100V 150V 200V 300V 400V Maximum RMS Voltage 35V 70V 105V 140V 210V 280V Maximum DC Blocking Voltage 50V 100V 150V 200V 300V 400V • • • Maximum Ratings D Electrical Characteristics @ 25° C Unless Otherwise Specified Average Forward IF(AV) 2.0A TC = 55°C Current Peak Forward Surge IFSM 50A 8.3ms, half sine Current Maximum Instantaneous IFM = 2.0A; Forward Voltage VF Ta = 25°C* SF21G-SF24G 0.95V SF25G-SF26G 1.3V Maximum DC 5.0uA TC = 25°C Reverse Current At IR 100uA TC = 125°C Rated DC Blocking Voltage Typical Junction Capacitance Measured at CJ SF21G-SF24G 60pF 1.0MHz, VR=4.0V SF25G-SF26G 30pF IF=0.5A, IR=1.0A, Maximum Reverse TRR 35nS Recovery Time IRR=0.25A *Pulse Test: Pulse width 300 usec, Duty cycle 1%. Note: 1. High Temperature Solder Exemptions Applied, see EU Directive Annex 7. A Cathode Mark B D C DIMENSIONS INCHES MIN .230 .104 .026 1.000 MM MIN 5.80 2.60 .70 25.40 DIM A B C D MAX .300 .140 .034 --- MAX 7.60 3.60 .90 --- NOTE www.mccsemi.com 1 of 4 Revision: A 2011/01/01 SF21G thru SF26G Figure 1 Typical Reverse Characteristics MCC Micro Commercial Components Figure 2 Typical Forward Characteristics 20 10 6 4 SF 21 G TM 1000 Tj=150C 100 Amps Tj=125C 2 1 .6 .4 .2 .1 ~S F2 4G SF 25 G ~S F2 6G uAmps 10 1 Tj=25C .06 .04 .02 0 20 40 60 80 100 120 140 .01 .4 .6 .8 Volts 1.0 1.2 1.4 Volts Instantaneous Reverse Current - uAmperes versus Percent of Rated Peak Reverse Voltage - % Figure 3 Forward Derating Curve 3.0 Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts 2.5 2.0 1.5 Amps 1.0 0.5 Single Phase, Half Wave 60Hz Resistive or Inductive Load 0 0 25 50 75 °C Average Forward Rectified Current Per Leg - Amperes versus Case Temperature - °C 100 125 150 www.mccsemi.com 2 of 4 Revision: A 2011/01/01 SF21G thru SF26G Figure 4 Maximum Non-repetitive Forward Surge Current 60 150 MCC Micro Commercial Components Figure 5 Typical Junction Capacitance JUNCTION CAPACITANCE.(pF) 125 100 TM PEAK FORWARD SURGE CURRENT. (A) 50 8.3ms Single Half Sine Wave JEDEC Method 40 SF 21 75 30 20 G~ SF 24 G 50 SF 25 G~ SF 26 G 10 0 1 2 5 10 20 50 100 NUMBER OF CYCLES AT 60Hz 25 0 .1 .5 1 2 5 10 20 50 100 200 500 1000 REVERSE VOLTAGE. (V) Figure 6 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 25Vdc Pulse Generator Note 2 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.mccsemi.com 3 of 4 Revision: A 2011/01/01 MCC Micro Commercial Components TM Ordering Information : Device Part Number-TP Part Number-BP Packing Tape&Reel: 4Kpcs/Reel Bulk: 25Kpcs/Carton ***IMPORTANT NOTICE* ** Micro Comme rcial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Comme rcial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Co mponents Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from A uthorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC' s quality standards for handling and storage. MCC will not pro vide any warranty coverage or o ther assistance for parts bought from Unau thorized Source s. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. www.mccsemi.com Revision: A 4 of 4 2011/01/01 4