SF25-AP

MCC TM Micro Commercial Components SF21 THRU SF28
  omponents 20736 Marilla Street Chatsworth    !"# $ %    !"# Features Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates • • • • x • Compliant. See ordering information) Low forward voltage drop Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 Marking: Type Number Halogen free available upon request by adding suffix "-HF" Maximum Ratings • • • Operating Temperature: -55°C to +125°C Storage Temperature: -55°C to +150°C For capacitive load, derate current by 20% Maximum Maximum MCC Recurrent RMS Part Number Peak Reverse Voltage Voltage SF21 50V 35V SF22 100V 70V SF23 150V 105V SF24 200V 140V SF25 300V 210V SF26 400V 280V SF28 600V 420V 2.0 Amp Super Fast Rectifier 50 to 600 Volts DO-15 Maximum DC Blocking Voltage 50V 100V 150V 200V 300V 400V 600V D Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward IF(AV) 2.0A TC = 55°C Current Peak Forward Surge IFSM 50A 8.3ms, half sine Current Maximum Instantaneous Forward Voltage IFM = 2.0A; SF21-SF24 VF 0.95V Ta = 25°C* SF25-SF26 1.30V SF28 1.70V Maximum DC 5.0uA TC = 25°C Reverse Current At IR 100uA TC = 100°C Rated DC Blocking Voltage Typical Junction Capacitance Measured at CJ SF21-SF24 60pF 1.0MHz, VR=4.0V SF25-SF28 30pF IF=0.5A, IR=1.0A, Maximum Reverse TRR 35nS Recovery Time IRR=0.25A *Pulse Test: Pulse width 300 usec, Duty cycle 1%. Note: A Cathode Mark B D C DIMENSIONS DIM A B C D INCHES MIN .230 .104 .026 1.000 MAX .300 .140 .034 --- MM MIN 5.80 2.60 .70 25.40 MAX 7.60 3.60 .90 --- NOTE 1. High Temperature Solder Exemptions Applied, see EU Directive Annex 7. www.mccsemi.com 1 of 4 Revision: B 2013/01/01 MCC SF21 thru SF28 TM Micro Commercial Components FIG.1- TYPICAL REVERSE CHARACTERISTICS FIG.2- TYPICAL FORWARD CHARACTERISTICS 100 1000 100 0 Tj=100 C 10 1 10 SF 21 ~S F2 4 INSTANTANEOUS FORWARD CURRENT. (A) INSTANTANEOUS REVERSE CURRENT. ( A) 10000 S SF 60 28 0.1 Tj=25oC Pulse Width=300 s 1% Duty Cycle 0.1 40 F2 1 Tj=25 0C 20 6 ~S 5 F2 80 100 0.01 0.4 120 0.6 PERCENT OF RATED PEAK REVERSE VOLTAGE. (%) 0.8 1.0 1.2 1.4 FORWARD VOLTAGE. (V) 1.6 1.8 Figure 3 Forward Derating Curve 3.0 2.5 2.0 1.5 Amps 1.0 0.5 Single Phase, Half Wave 60Hz Resistive or Inductive Load 0 0 25 50 75 100 125 150 °C Average Forward Rectified Current Per Leg - Amperes versus Case Temperature - °C www.mccsemi.com 2 of 4 Revision: B 2013/01/01 MCC SF21 thru SF28 TM Micro Commercial Components Figure 5 Typical Junction Capacitance Figure 4 Maximum Non-repetitive Forward Surge Current 150 JUNCTION CAPACITANCE.(pF) PEAK FORWARD SURGE CURRENT. (A) 60 50 8.3ms Single Half Sine Wave JEDEC Method 40 30 20 10 125 100 Tj=25 0C SF 21 75 SF 25 50 ~S F2 ~S F2 4 8 25 0 0 1 2 5 10 20 50 .1 100 .5 1 2 5 10 20 50 100 200 500 1000 REVERSE VOLTAGE. (V) NUMBER OF CYCLES AT 60Hz Figure 6 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω +0.5A trr 0 Pulse Generator Note 2 25Vdc 1Ω Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive www.mccsemi.com 3 of 4 Revision: B 2013/01/01 MCC TM Micro Commercial Components Ordering Information : Device Packing Part Number-TP Tape&Reel: 4Kpcs/Reel Part Number-BP Bulk: 25Kpcs/Carton Note : Adding "-HF" suffix for halogen free, eg. Part Number-TP-HF ***IMPORTANT NOTICE*** Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. www.mccsemi.com Revision: B 4 of 4 2013/01/01 1