SF63

MCC Micro Commercial Components TM
  omponents 20736 Marilla Chatsworth    !"# $ %    !"# SF61 THRU SF66 6.0 Amp Super Fast Rectifier 50 to 400 Volts DO-201AD • Features Lead Free Finish/RoHS Compliant(Note 1) ("P" Suffix designates RoHS Compliant. See ordering information) Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 High reliability High current capability Low forward voltage drop High surge current capability Operating Temperature: -65 to +125 Storage Temperature: -65 to +150 For capacitive load, derate current by 20% Maximum Maximum Recurrent MCC RMS Peak Reverse Part Number Voltage Voltage SF61 50 35 SF62 100 70 SF63 150 105 SF64 200 140 SF65 300 210 SF66 400 280 • • Maximum Ratings Maximum DC Blocking Voltage D 50 100 150 200 300 400 A Cathode Mark B D Electrical Characteristics @ 25 C Unless Otherwise Specified Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage SF61-SF64 SF65-SF66 IF(AV) 6.0A T C = 55 IFSM 150A 8.3ms, half sine C VF 0.975V 1.3V IFM = 6.0A; T C = 25 DIMENSIONS Maximum DC Reverse Current At Rated DC Blocking Voltage Typical Junction Capacitance SF61-SF64 SF65-SF66 Maximum Reverse Recovery Time IR 5.0uA 50uA T C = 25 TC = 100 CJ 120pF 60pF Measured at 1.0MHz, VR=4.0V DIM A B C D INCHES MIN MAX --.370 --.250 .048 .052 1.000 --- MM MIN ----1.20 25.40 MAX 9.50 6.40 1.30 --- NOTE TRR 35nS IF=0.5A, IR=1.0A, IRR=0.25A Notes: 1. High Temperature Solder Exemption Applied, see EU Directive Annex Notes 7. 2. Pulse Test: Pulse width 300 usec, Duty cycle 1%. Revision: A www.mccsemi.com 1 of 4 2011/01/01 SF61 thru SF66 Figure1 Reverse Recovery Time Characteristic And Test Circuit Diagram 50 10 MCC Micro Commercial Components trr TM +0.5A 0 50Vdc Pulse Generator Note 2 1 Oscilloscope Note 1 -0.25 -1.0 Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive 1cm Set Time Base for 20/100ns/cm Figure 2 Forward Derating Curve Figure 3 Typical Reverse Characteristics 60 Single Phase, Half Wave 60Hz Resistive or Inductive Load 100 50 40 TJ=100 C 10 30 Amps 20 10 µAmps 1.0 0 150 25 50 100 75 0 125 Average Forward Rectified Current Per Leg - Amperes versus Ambient Temperature - C 0.1 TJ=25 C .01 0 20 40 60 Volts 80 100 140 Instantaneous Reverse Leakage Current -MicroAmperes versus Percent Of Rated Peak Reverse Voltage - Volts Revision: A www.mccsemi.com 2 of 4 2011/01/01 SF61 thru SF66 Figure 4 Typical Forward Characteristics 100 150 125 100 75 MCC Micro Commercial Components Figure 5 Peak Forward Surge Current TM 8.3ms Single Hale Sine Wave JEDEC METHED 10 Amps 50 25 SF61-SF64 0 1 2 4 6 8 10 20 40 60 80 100 Amps 1.0 Cycles Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles SF65-SF66 .1 TJ=25 Pulse Width=300µs 1% Duty Cycle .01 0 0.2 0.4 0.6 0.8 10 1.4 Volts Instantaneous Forward Current - Amperes versus Forward Voltage - Volts Figure 6 Typical Junction Capacitance 180 160 140 120 SF61-SF64 pF TJ=25 100 SF65-SF66 80 60 .1 .5 1 2 5 Volts 10 20 50 100 200 Junction Capacitance – pF Reverse Voltage - Volts Revision: A www.mccsemi.com 3 of 4 2011/01/01 MCC Micro Commercial Components TM Ordering Information : Device Part Number-TP Part Number-AP Part Number-BP Packing Tape&Reel: 1.2Kpcs/Reel Ammo Packing: 1.2Kpcs/Ammo Box Bulk: 12Kpcs/Carton ***IMPORTANT NOTICE* ** Micro Comme rcial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Comme rcial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Co mponents Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from A uthorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC' s quality standards for handling and storage. MCC will not pro vide any warranty coverage or o ther assistance for parts bought from Unau thorized Source s. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. Revision: A www.mccsemi.com 4 of 4 2011/01/01 3