UFM15PL

MCC Micro Commercial Components TM
  omponents 20736 Marilla Street Chatsworth    !"# $ %    !"# UFM11PL THRU UFM17PL 1 Amp Ultra Fast Recovery Silicon Rectifier 50 to 1000 Volts SOD-123FL A B Features • • Low Cost Ultra fast Recovery High Reliability Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 Maximum Ratings Operating Temperature: -65 C to +150 C Storage Temperature: -65 C to +150 C Maximum Thermal Resistance; 180 C/W Junction To Ambient. MCC Part Number UFM11PL UFM12PL UFM13PL UFM14PL UFM15PL UFM16PL UFM17PL Device Marking U1 U2 U3 U4 U5 U6 U7 Maximum Recurrent Peak Reverse Voltage 50V 100V 200V 400V 600V 800V 1000V Maximum RMS Voltage 35V 70V 140V 280V 420V 560V 700V Maximum DC Blocking Voltage 50V 100V 200V 400V 600V 800V 1000V C E H D G Electrical Characteristics @ 25 C Unless Otherwise Specified Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage UFM11PL-13PL UFM14PL UFM15PL-17PL Maximum DC Reverse Current At Rated DC Blocking Voltage Maximum Reverse Recovery Time UFM11PL-13PL UFM14PL UFM15PL-16PL UFM17PL Typical Junction Capacitance IF(AV) IFSM 1.0A 30A TL = 90 C 8.3ms, half sine DIM A B C D E G H VF 1.0V 1.40V 1.70V 10 A 50 A IFM = 1.0A; Ta = 25 C DIMENSIONS INCHES MM MIN MAX MIN MAX .140 .152 3.55 3.85 .100 .112 2.55 2.85 .055 .071 1.40 1.80 .037 .053 0.95 1.35 .020 .039 0.50 1.00 .010 ----0.25 --------.008 ---.20 SUGGESTED SOLDER PAD LAYOUT NOTE IR Ta = 25 C Ta = 125 C 0.093” 0.048” Trr 35ns 50ns 75ns 100ns 20pF IF = 0.5A,IR=1.0A, Trr= 0.25Α 0.036” CJ Measured at 1.0MHz, VR=4.0V Revision: A www.mccsemi.com 1 of 4 2011/01/01 UFM11PL THRU UFM17PL Figure 1 Typical Forward Characteristics 20 10 6 4 2 Amps 1 .6 .4 .2 TJ=25°C .1 .06 .04 .02 .01 .8 1.0 1.2 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts 1.4 1.6 1.8 2.4 2.2 2.0 1.8 1.6 1.4 UFM11PL-13PL UFM14PL MCC TM Micro Commercial Components Figure 2 Forward Derating Curve UFM15-17PL 1.2 Amps 1.0 .8 .6 .4 Single Phase, Half Wave .2 60Hz Resistive or Inductive Load 0 0 25 50 75 °C Average Forward Rectified Current - Amperes versus Lead Temperature - °C 100 125 150 Figure 3 Junction Capacitance 100 60 40 20 pF 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 UFM15-17PL TJ=25°C; f=1MHZ UFM11PL-UFM14PL Junction Capacitance - pFversus Reverse Voltage - Volts Revision: A www.mccsemi.com 2 of 4 2011/01/01 MCC Micro Commercial Components Figure 4 Peak Forward Surge Current 30 25 20 15 Amps 10 5 0 1 4 6 8 10 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles 20 40 60 80 100 TM 2 Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 25Vdc Pulse Generator Note 2 1Ω Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive www.mccsemi.com Revision: A 3 of 4 2011/01/01 MCC Micro Commercial Components TM Ordering Information : Device Part Number-TP Packing Tape&Reel: 2.5Kpcs/Reel ***IMPORTANT NOTICE* ** Micro Comme rcial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Comme rcial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Co mponents Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from A uthorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC' s quality standards for handling and storage. MCC will not pro vide any warranty coverage or o ther assistance for parts bought from Unau thorized Source s. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. www.mccsemi.com Revision: A 4 of 4 2011/01/01