US1J

Micro
Commercial Components



















MCC TM
  omponents 20736 Marilla Street Chatsworth    !"# $ %    !"# US1A THRU US1M 1 Amp Ultra Fast Rectifier 50 to 1000 Volts
Features Lead Free Finish/RoHS Compliant(Note 1) ("P" Suffix designates RoHS Compliant. See ordering information)
•

Glass
Passivated Chip







•

Ultra Fast
Switching For High Efficiency

















• For Surface Mounted Applications • Low Forward Voltage Drop And High Current Capability • Low Reverse Leakage Current • Epoxy meets UL 94 V-0 flammability rating • Moisture Sensitivity Level 1 • Maximum Ratings • • • Operating Temperature: -65 °C to +175°C Storage Temperature: -65°C to +175°C Maximum Thermal Resistance; 30 °C/W Junction To Lead MCC Catalog Number Device Marking Maximum Recurrent Peak Reverse Voltage 50V 100V 150V 200V 400V 600V 800V 1000V Maximum RMS Voltage Maximum DC Blocking Voltage 50V 100V 150V 200V 400V 600V 800V 1000V DO-214AC (SMA) (LEAD
FRAME) H J


US1A US1B US1C US1D US1G US1J US1K US1M US1A US1B US1C US1D US1G US1J US1K US1M 35V 70V 105V 140V 280V 420V 560V 700V A C E F G Dimensions INCHES MIN .079 .050 .002 --.030 .065 .189 .157 .090 D B Electrical Characteristics @ 25 C Unless Otherwise Specified ° Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage US1A-1D US1G US1J-1M IF(AV) 1.0A TL = 75°C IFSM 30A 8.3ms, half sine DIM A B C D E F G H J MAX .096 .064 .008 .02 .060 .091 .220 .181 .115 MM MIN 2.00 1.27 .05 --.76 1.65 4.80 4.00 2.25 MAX 2.44 1.63 .20 .51 1.52 2.32 5.59 4.60 2.92 NOTE VF 1.0V 1.4V 1.7V IFM = 1.0A; TJ = 25°C SUGGESTED SOLDER PAD LAYOUT 0.090” MAX Maximum DC Reverse Current At Rated DC Blocking Voltage Maximum Reverse Recovery Time US1A-US1G US1J~US1K US1M IR 10uA 100uA TA = 25°C TA = 100°C 0.085” MIN Trr 50ns 75ns 100ns 20pF 17pF IF=0.5A, IR=1.0A, Irr=0.25A 0.070” MIN Typical Junction Capacitance US1A-1G US1J-1M CJ Measured at 1.0MHz, VR=4.0V *Pulse test: Pulse width 300 sec, Duty cycle 1% Notes: 1. High Temperature Solder Exemption Applied, see EU Directive Annex Notes 7. Revision: C www.mccsemi.com 1 of 4 2011/08/01 US1A thru US1M Figure 1 Typical Forward Characteristics 20 10 6 4 2.4 2.2 2.0 1.8 US1A-1D US1G US1J-1M MCC Micro Commercial Components Figure 2 Forward Derating Curve TM 2 Amps 1.6 1.4 1.2 Amps 1.0 .8 .6 TJ=25°C 1 .6 .4 .2 .1 .06 .04 .02 .01 .8 1.0 1.2 Volts 1.4 .4 Single Phase, Half Wave .2 60Hz Resistive or Inductive Load 0 0 30 60 90 °C Average Forward Rectified Current - Amperes versus Lead Temperature - °C 120 150 180 1.6 1.8 Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF 10 6 US1J-1M TJ=25°C US1A-1G 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 Junction Capacitance - pFversus Reverse Voltage - Volts Revision: C www.mccsemi.com 2 of 4 2011/08/01 US1A thru US1M Figure 4 Peak Forward Surge Current 30 25 20 15 Amps 10 5 20 Amps MCC Micro Commercial Components Figure 5 Peak Forward Surge Current TM 1000 600 400 200 100 60 40 0 1 2 4 6 8 10 Cycles 20 40 60 80 100 10 .01 .02 .06 .1 .2 mS .6 1 2 6 10 Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles Figure 6 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω Peak Forward Surge Current - Amperesversus Pulse Duration - Milliseconds (mS) trr +0.5A 0 25Vdc Pulse Generator Note 2 1Ω Oscilloscope Note 1 -0.25 -1.0 Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive 1cm Set Time Base for 20/100ns/cm Revision: C www.mccsemi.com 3 of 4 2011/08/01 MCC Micro Commercial Components TM Ordering Information : Device Part Number-TP Packing Tape&Reel: 5Kpcs/Reel ***IMPORTANT NOTICE* ** Micro Comme rcial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Comme rcial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Co mponents Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from A uthorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC' s quality standards for handling and storage. MCC will not pro vide any warranty coverage or o ther assistance for parts bought from Unau thorized Source s. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. Revision: C www.mccsemi.com 4 of 4 2011/08/01 1