MX23C1010QC-12

INDEX MX23C1010 1M-BIT MASK ROM (8 BIT OUTPUT) FEATURES • Bit organization - 128K x 8 (byte mode) • Fast access time - Random access: 45ns (max.) • Current - Operating: 40mA - Standby: 100uA • Supply voltage - 5V±10% for 70ns(max.) - 5V±5% for 45ns(max.) • Package - 32 pin PDIP/SOP/PLCC/TSOP ORDER INFORMATION Part No. Access Time MX23C1010PC-45 45ns MX23C1010PC-70 70ns MX23C1010PC-90 90ns MX23C1010PC-10 100ns MX23C1010PC-12 120ns MX23C1010PC-15 150ns MX23C1010MC-45 45ns MX23C1010MC-70 70ns MX23C1010MC-90 90ns MX23C1010MC-10 100ns MX23C1010MC-12 120ns MX23C1010MC-15 150ns MX23C1010QC-45 45ns MX23C1010QC-70 70ns MX23C1010QC-90 90ns MX23C1010QC-10 100ns MX23C1010QC-12 120ns MX23C1010QC-15 150ns MX23C1010TC-45 45ns MX23C1010TC-70 70ns MX23C1010TC-90 90ns MX23C1010TC-10 100ns MX23C1010TC-12 120ns MX23C1010TC-15 150ns MX23C1010QI-12(*) 120ns MX23C1010QI-15(*) 150ns MX23C1010TI-90(*) 90ns (*): industrial grade, TA= -40° C ~ 85° C Package 32 pin PDIP 32 pin PDIP 32 pin PDIP 32 pin PDIP 32 pin PDIP 32 pin PDIP 32 pin SOP 32 pin SOP 32 pin SOP 32 pin SOP 32 pin SOP 32 pin SOP 32 pin PLCC 32 pin PLCC 32 pin PLCC 32 pin PLCC 32 pin PLCC 32 pin PLCC 32 pin TSOP 32 pin TSOP 32 pin TSOP 32 pin TSOP 32 pin TSOP 32 pin TSOP 32 pin PLCC 32 pin PLCC 32 pin TSOP PIN CONFIGURATION 32 PDIP NC A16 A15 A12 A7 A6 A5 A4 A3 A2 A1 A0 D0 D1 D2 VSS 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 VCC NC NC A14 A13 A8 A9 A11 OE A10 CE D7 D6 D5 D4 D3 32 SOP NC A16 A15 A12 A7 A6 A5 A4 A3 A2 A1 A0 D0 D1 D2 VSS 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 32 31 30 29 28 27 26 25 24 23 22 21 10 19 18 17 VCC NC NC A14 A13 A8 A9 A11 OE A10 CE D7 D6 D5 D4 D3 MX23C1010 MX231010 PIN DESCRIPTION Symbol A0~A16 D0~D7 CE OE VCC VSS NC Pin Function Address Inputs Data Outputs Chip Enable Input Output Enable Input Power Supply Pin Ground Pin No Connection REV. 4.0, DEC. 10, 1998 P/N:PM0227 1 INDEX MX23C1010 32 TSOP(I) 32 PLCC VCC A12 A15 A16 NC NC NC 30 29 VSS D1 D2 D3 D4 D5 ABSOLUTE MAXIMUM RATINGS ITEM Voltage on any Pin Relative to VSS Ambient Operating Temperature Storage Temperature SYMBOL VIN Topr Tstg RATINGS -0.5V to 7.0V -40°C to 85°C -65°C to 125°C DC CHARACTERISTICS (Ta = -40°C ~ 85°C, VCC = 5V±10% for 70ns max., 5V±5% for 45ns max.) ITEM Output High Voltage Output Low Voltage Input High Voltage Input Low Voltage Input Leakage Current Output Leakage Current Operating Current Standby Current (TTL) Standby Current (CMOS) Input Capacitance Output Capacitance SYMBOL VOH VOL VIH VIL ILI ILO ICC1 ISTB1 ISTB2 CIN COUT MIN. 2.4V 2.0V -0.3V -10 -10 MAX. 0.4V VCC+0.5V 0.8V 10uA 10uA 40mA 1.5mA 100uA 12pF 12pF CONDITIONS IOH = -0.4mA IOL = 2.1mA VIN=0 to 5.5V VOUT=0 to 5.5V CE = VIL, f = 5MHz, Iout = 0mA CE = VIH CE = VCC +/- 0.3V VIN=0V VOUT=OV P/N:PM0227 REV. 4.0, DEC. 10, 1998 2 D6 A11 A9 A8 A13 A14 NC NC VCC NC A16 A15 A12 A7 A6 A5 A4 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 MX23C1010 32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 OE A10 CE D7 D6 D5 D4 D3 VSS D2 D1 D0 A0 A1 A2 A3 A7 A6 A5 A4 A3 A2 A1 A0 D0 5 4 1 32 A14 A13 A8 A9 9 MX23C1010 25 A11 OE A10 CE 13 14 17 21 20 D7 INDEX MX23C1010 AC CHARACTERISTICS (Ta = -40°C ~ 85°C, VCC = 5V±10% for 70ns max., 5V±5% for 45ns max.) ITEM SYMBOL 23C1010-45* MIN. Read Cycle Time Address Access Time Chip Enable Access Time Output Enable Time tRC tAA tACE tOE 45ns 0ns MAX. 45ns 45ns 25ns 17ns 23C1010-70* MIN. 70ns 0ns MAX. 70ns 70ns 35ns 20ns 23C1010-90 MIN. 90ns 0ns MAX. 90ns 90ns 40ns 25ns 23C1010-10 MIN. 100ns 0ns MAX. 100ns 100ns 45ns 30ns 23C1010-12 MIN 120ns 0ns MAX 120ns 120ns 50ns 35ns 23C1010-15 MIN 150ns 0ns MAX 150ns 150ns 60ns 50ns Output Hold After Address tOH Output High Z Delay tHZ Note :Output high-impedance delay (tHZ) is measured from OE or CE going high, and this parameter guaranteed by design over the full voltage and temperature operating range - not tested. *45ns&70ns speed grades are under development. AC Test Conditions Input Pulse Levels Input Rise and Fall Times Input Timing Level Output Timing Level Output Load 0.4V~2.4V 0V~3v (for 45ns&70ns) 10ns 0.8V~2.0V 1.5V (for 45ns&70ns) 0.8V and 2.0V 1.5V (for 45ns&70ns) See Figure DEVICE UNDER TEST CL=100pF* 1.8K ohm +5V 6.2K ohm DIODES = IN3064 OR EQUIVALENT *CL=30pF for 45ns&70ns TIMING DIAGRAM RANDOM READ ADD ADD tACE ADD tRC ADD CE OE tOE tOH VALLID tHZ VALLID tAA DATA VALLID Note : CE, OE are enable. P/N:PM0227 REV. 4.0, DEC. 10, 1998 3 INDEX MX23C1010 PACKAGE INFORMATION 32-PIN PLASTIC DIP (600 mil) ITEM A B C D E F G H I J K L M MILLIMETERS 42.13 max. 1.90 [REF] 2.54 [TP] .46 [Typ.] 38.07 1.27 [Typ.] 3.30±.25 .51 [REF] 3.94±.25 5.33 max. 15.22±.25 13.97±.25 .25 [Typ.] INCHES 1.660 max. .075 [REF] .100 [TP] .018 [Typ.] 1.500 .050 [Typ.] .130±.010 .020 [REF] .155±.010 .210 max. .600±.010 .550±.010 .010 [Typ.] 32 17 1 A 16 K L I H F D E J G C B M 0~15 NOTE: Each lead centerline is located within .25 mm[.01 inch] of its true position [TP] at maximum material condition. 32-PIN PLASTIC SOP (450 mil) ITEM A B C D E F G H I J K L MILLIMETERS 20.95 max. 1.00 [REF] 1.27 [TP] .40 [Typ.] .05 min. 3.05 max. 2.69±.13 14.12±.25 11.30±.13 1.42 .20 [Typ.] .79 INCHES .825 max. .039 [REF] .050 [TP] .016 [Typ.] .002 min. .120 max. .106±.005 .556±.010 .445±.005 .056 .008 [Typ.] .031 32 17 1 A 16 H I J G F K E NOTE: Each lead centerline is located within .25 mm[.01 inch] of its true position [TP] at maximum material condition. D C B L P/N:PM0227 REV. 4.0, DEC. 10, 1998 4 INDEX MX23C1010 32-PIN PLASTIC TSOP ITEM A B C D E F G H I J K L M N MILLIMETERS 20.0±.20 18.40±.10 8.20 max. .15 [Typ.] .80 [Typ.] .20 ±.10 .30 ±.10 .50 [Typ.] .45 max. 0 ~ .20 1.00±.10 1.27 max. .50 0 ~ 5° INCHES .078±.006 .724±.004 .323 max. .006 [Typ.] .031 [Typ.] .008±.004 C A B .012±.004 .020 [Typ.] .018 max. 0 ~ .008 .039±.004 .050 max. .020 .500 D E F G H I J K L N M NOTE: Each lead centerline is located within .25 mm[.01 inch] of its true position [TP] at maximum material condition. 32-PIN PLASTIC LEADED CHIP CHARRIER (PLCC) A ITEM A B C D E F G H I J K L MILLIMETERS 12.44±.13 11.50±.13 14.04±.13 14.98±.13 1.93 3.30±.25 2.03±.13 .51 ±.13 1.27 [Typ.] .71 [REF] .46 [REF] 10.40/12.94 (W) (L) INCHES .490±.005 .453±.005 .553±.13 .590±.13 .076 .130±.010 .080±.005 .020±.005 .050 [Typ.] .028 [REF] .018 [REF] .410/.510 (W) (L) 13 14 9 5 4 B 1 32 30 29 25 C D 21 20 E 17 M N .89 R .25 [TYP.] .035 R .010 [TYP.] F G N H I K L M J NOTE: Each lead centerline is located within .25 mm[.01 inch] of its true position [TP] at maximum material condition. P/N:PM0227 REV. 4.0, DEC. 10, 1998 5 INDEX MX23C1010 REVISION HISTORY REVISION 3.9 4.0 DESCRIPTION To add 70ns speed grade To add 45ns speed grade PAGE P2 P2 DATE NOV/23/1998 DEC/10/1998 P/N:PM0227 REV. 4.0, DEC. 10, 1998 6 INDEX MX23C1010 MACRONIX INTERNATIONAL CO., LTD. HEADQUARTERS: TEL:+886-3-578-8888 FAX:+886-3-578-8887 EUROPE OFFICE: TEL:+32-2-456-8020 FAX:+32-2-456-8021 JAPAN OFFICE: TEL:+81-44-246-9100 FAX:+81-44-246-9105 SINGAPORE OFFICE: TEL:+65-747-2309 FAX:+65-748-4090 TAIPEI OFFICE: TEL:+886-3-509-3300 FAX:+886-3-509-2200 MACRONIX AMERICA, INC. TEL:+1-408-453-8088 FAX:+1-408-453-8488 CHICAGO OFFICE: TEL:+1-847-963-1900 FAX:+1-847-963-1909 http : //www.macronix.com MACRONIX INTERNATIONAL CO., LTD. reserves the rignt to change product and specifications without notice. 7