MX23C2100

INDEX MX23C2100 2M-BIT [256K x 8/128K x 16] CMOS MASK ROM FEATURES • Switchable organization - 256K x 8 (byte mode) - 128K x 16 (word mode) • Single +5V power supply • Fast access time:150/200ns • Totally static operation • • • • Completely TTL compatible Operating current: 60mA Standby current: 100uA Package type: - 40 pin DIP (600 mil) GENERAL DESCRIPTION The MX23C2100 is a 5V only, 2M-bit, Read Only Memory. It is organized as 256K x 8 bits (byte mode) or as 128K x 16 bit (word mode) depending on BYTE (pin 31) voltage level. MX23C2100 has a static standby mode, and has an access time of 150/200ns. It is designed to be compatible with all microprocessors and similar applications in which high performance, large bit storage and simple interfacing are important design considerations. MX23C2100 offers automatic power-down, with powerdown controlled by the chip enable (CE/CE) input. When CE/CE is not selected, the device automatically powers down and remains in a low-power standby mode as long as CE/CE stays in the unselected mode. The OE/OE inputs as well as CE/CE input may be programmed either active High or Low. PIN CONFIGURATION 40 PDIP NC A7 A6 A5 A4 A3 A2 A1 A0 CE/CE VSS OE/OE Q0 Q8 Q1 Q9 Q2 Q10 Q3 Q11 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 40 39 38 37 36 35 34 33 32 31 30 29 28 27 26 25 24 23 22 21 A8 A9 A10 A11 A12 A13 A14 A15 A16 BYTE VSS Q15/A-1 Q7 Q14 Q6 Q13 Q5 Q12 Q4 VCC BLOCK DIAGRAM CE/CE OE/OE BYTE Q15/A-1 CONTROL LOGIC OUTPUT BUFFERS Q0~Q14 MX23C2100 A0~A16 ADDRESS INPUTS . . . . . . . . Y-DECODER X-DECODER . . . . . . . . Y-DECODER 2M BIT ROM ARRAY VCC VSS PIN DESCRIPTION Symbol A0~A16 Q0~Q14 CE/CE OE/OE BYTE Q15/A-1 VCC VSS Pin Function Address Input Data Output Chip Enable Input Output Enable Input Word/Byte Selection Q15 (Word mode)/LSB addr. (Byte mode) Power Supply Pin (+5V) Ground Pin REV. 2.2, JAN. 28, 1999 P/N:PM0134 1 INDEX MX23C2100 TRUTH TABLE OF BYTE FUNCTION BYTE MODE (BYTE=VSS) CE OE/OE D15/A-1 H X X L L/H X L H/L A-1 input WORD MODE (BYTE=VSS) CE OE/OE D15/A-1 H X High Z L L/H High Z L H/L DOUT NOTE1:X=H or L MODE Non selected Non selected Selected D0-D7 High Z High Z DOUT SUPPLY CURRENT Standby (ICC2) Operating (ICC1) Operating (ICC1) NOTE 1 1 1 MODE Non selected Non selected Selected D0-D14 High Z High Z DOUT SUPPLY CURRENT Standby (ICC2) Operating (ICC1) Operating (ICC1) NOTE 1 1 1 ABSOLUTE MAXIMUM RATINGS* RATING Ambient Operating Temperature Storage Temperature Applied Input Voltage Applied Output Voltage VCC to Ground Potential Power Dissipation VALUE 0° to 70° C C -65° to 125° C C -0.5V to 7.0V -0.5V to 7.0V -0.5V to 7.0V 1.0W *Notice: Stress greater than those listed under ABSOLUTE MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended period may affect reliability. DC CHARACTERISTICS (Ta = 0°C ~ 70°C, VCC = 5V±10%) Item Output High Voltage Output Low Voltage Input High Voltage Input Low Voltage Input Leakage Current Output Leakage Current Power-Down Supply Current Standby Supply Current Operating Supply Current Symbol VOH VOL VIH VIL ILI ILO ICC3 ICC2 ICC1 MIN. 2.4 2.2V -0.3V MAX. 0.4V VCC+0.3V 0.8V 10uA 10uA 100uA 1.0mA 60mA Conditions IOH = -1.0mA IOL = 2.1mA - VIN=0 to 5.5V VOUT=0 to 5.5V CE>VCC-0.2V CE = VIH Note 1 P/N:PM0134 REV. 2.2, JAN. 29, 1999 2 INDEX MX23C2100 CAPACITANCE (Ta = 25°C, f=1.0MHz (Note 2)) Item Input Capacitance Output Capacitance Symbol CIN COUT TYP. MAX. 10 10 UNIT pF pF Conditions VIN=0V VOUT=0V AC CHARACTERISTICS (Ta = 0°C ~ 70°C, VCC = 5V±10%) Item Cycle Time Address Access Time Output Hold Time After Address Change Chip Enable Access Time Output Enable/Chip Select Access Time Output Low Z Delay Output High Z Delay BYTE Access Time BYTE Output Hold Time BYTE Output Delay Time BYTE Output Set Time tLZ tHZ tBHA tOHB tBHZ tBLZ 0ns 0ns 10ns 70ns 150ns 70ns 0ns 0ns 10ns 70ns 200ns 70ns Note 3 Note 4 tACE tAOE 150ns 80ns 200ns 90ns Symbol tCYC tAA tOH 23C2100-15 MIN. 150ns 0ns MAX. 150ns 23C2100-20 MIN. 200ns 0ns MAX. 200ns CONDITIONS Note: 1. Measured with device selected at f=5 MHz and output unloaded. 2. This parameter is periodically sampled and is not 100% tested. 3. Output low-impedance delay (tLZ) is measured from CE going low. 4. Output high-impedance delay (tHZ) is measured from CE going high. AC Test Conditions Input Pulse Levels Input Rise and Fall Times Input Timing Level Output Timing Level Output Load 0.4V~ 2.4V 10ns 1.5V 0.8V and 2.0V 1TLL+100pF P/N:PM0134 REV. 2.2, JAN. 29, 1999 3 INDEX MX23C2100 TIMING DIAGRAM PROPAGATION DELAY FROM ADDRESS (CE/OE=ACTIVE) tCYC ADDRESS INPUTS tAA DATA OUT VALID ADDRESS tOH VALID DATA PROPAGATION DELAY FROM CHIP ENABLE (ADDRESS VALID) CE tACE OE tAOE tLZ tHZ DATA OUT PROPAGATION DELAY FROM CHIP ENABLE (ADDRESS VALID) HIGH-Z tAA BYTE tOH HIGH-Z A-1 D0-D7 VALID DATA tBHA tOHB VALID DATA D15-D8 tBHZ tBLZ VALID DATA P/N:PM0134 REV. 2.2, JAN. 29, 1999 4 INDEX MX23C2100 ORDER INFORMATION Part No. MX23C2100PC-12 MX23C2100PC-15 Access Time 150ns 200ns Operating Current MAX. 60mA 60mA Standby Current MAX. 100uA 100uA Package 40 Pin DIP 40 pin DIP REVISION HISTORY REVISION 2.2 DESCRIPTION AC CHARACTERISTICS tOH 10ns-->0ns PAGE P3 DATE JAN/29/1999 P/N:PM0134 REV. 2.2, JAN. 29, 1999 5 INDEX MX23C2100 PACKAGE INFORMATION 40-PIN PLASTIC DIP (600 mil) ITEM A B C D E F G H I J K L M MILLIMETERS 52.54 max. 2.03 [REF] 2.54 [TP] .46 [Typ.] 48.22 1.52 [Typ.] 3.30±.25 .51 [REF] 3.94±.25 5.33 max. 15.22±.25 13.97±.25 .25 [Typ.] INCHES 2.070 max. .080 [REF] .100 [TP] .018 [Typ.] 1.900 .060 [Typ.] .130±.010 .020 [REF] 1.55±.010 .210 max. .600±.010 .550±.010 .010 [Typ.] F D E C B M H G I J 1 A K L 20 40 21 0~15¡ NOTE: Each lead centerline is located within .25 mm[.01 inch] of its true position [TP] at maximum material condition. P/N:PM0134 REV. 2.2, JAN. 29, 1999 6 INDEX MX23C2100 MACRONIX INTERNATIONAL CO., LTD. HEADQUARTERS: TEL:+886-3-578-8888 FAX:+886-3-578-8887 EUROPE OFFICE: TEL:+32-2-456-8020 FAX:+32-2-456-8021 JAPAN OFFICE: TEL:+81-44-246-9100 FAX:+81-44-246-9105 SINGAPORE OFFICE: TEL:+65-747-2309 FAX:+65-748-4090 TAIPEI OFFICE: TEL:+886-3-509-3300 FAX:+886-3-509-2200 MACRONIX AMERICA, INC. TEL:+1-408-453-8088 FAX:+1-408-453-8488 CHICAGO OFFICE: TEL:+1-847-963-1900 FAX:+1-847-963-1909 http : //www.macronix.com MACRONIX INTERNATIONAL CO., LTD. reserves the rignt to change product and specifications without notice. 7