600S-N015

600W Single Output With Parallel Function Features : SCN-600 series AC input range selected by switch Protections: Short circuit / Overload / Over voltage / Over temp. High reliability/ Low ripple noise Built-in remote sense function Built-in remote ON-OFF control Built-in parallel operation function Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan Case coating with paint 2 years warranty SPECIFICATION ORDER NO. SAFETY MODEL NO. DC VOLTAGE RATED CURRENT CURRENT RANGE RATED POWER OUTPUT VOLTAGE ADJ. RANGE LINE REGULATION LOAD REGULATION VOLTAGE RANGE FREQUENCY RANGE INPUT EFFICIENCY (Typ.) AC CURRENT INRUSH CURRENT (max.) LEAKAGE CURRENT OVERLOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & EMC (Note. 4) SCN-600-05 600S-N005 5V 100A 0 ~ 100A 500W SCN-600-12 600S-N012 12V 50A 0 ~ 50A 600W 120mVp-p SCN-600-15 600S-N015 15V 40A 0 ~ 40A 600W 150mVp-p SCN-600-18 600S-N018 18V 33A 0 ~ 33A 594W 180mVp-p SCN-600-24 600S-N024 24V 25A 0 ~ 25A 600W 240mVp-p SCN-600-48 600S-N048 48V 12A 0 ~ 12A 576W 480mVp-p 1.0% 0.5% 0.5% RIPPLE & NOISE (max.) Note.2 100mVp-p 5.0% typical adjustment by potentiometer 1.0% VOLTAGE TOLERANCE Note.3 1.5% 0.5% 1.0% 0.5% 0.5% 20~100% adjustment by 1~5VDC external control 1.0% 1.0% 1.0% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE, HOLD UP TIME 800ms, 50ms, 16ms at full load 90 ~ 130VAC / 180 ~ 260VAC selected by switch, 260 ~ 370VDC 47 ~ 63Hz 77% 11A / 115VAC 60A / 230VAC 3.5mA / 240VAC 101 ~ 115% 110 ~ 135% rated output power Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover 110 ~ 135% follow to output set up point Protection type : Shut down o/p voltage, re-power on to recover >100 / measure by heat sink, near transformer Protection type : Shut down o/p voltage, re-power on to recover -10 ~ +65 (Refer to output load derating curve) 20% ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.04% / (0 ~ 50 ) 10 ~ 200Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes UL60950-1, CSA22.2, IEC60950 approved I/P-O/P, I/P-FG:1500VAC I/P-O/P, I/P-FG, 100M Ohms / 500VDC / 25 / 70% RH 80% 7.0A / 230VAC 81% 82% 85% 87% ISOLATION RESISTANCE EMI CONDUCTION & RADIATION Compliance to FCC part 15 class A ---HARMONIC CURRENT EMS IMMUNITY MTBF DIMENSION PACKING SPECIAL FUNCTION ---120Khrs min. MIL-HDBK-217F (25 ) 291*132*68mm (L*W*H) 2.6kg; 8pcs/ 24kg/ CARTON DC voltage adj., Remote sensing, remote control, parallel operation (refer to terminal instruction manual) OTHERS NOTE 1.All parameters are specified at 230VAC input, rated load, 25 70% RH ambient. 2.Tolerence: includes set up tolerance, line regulation, load regulation. 3.Ripple & noise are measured at 20MHz by using a 12" twisted pair terminated with a 0.1uf & 47uf capacitor. 4.The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name:SCN-600-SPEC 2008-05-06 600W Single Output With Parallel Function Mechanical Specification SCN-600 series Unit:mm 291 200 199.5 L N FG 50.5 41 15.5 68 AC INPUT #6-32-4 M3(NUT)x3H-4 30 15 POS+ 291 9 250 M3(NUT)x3H-4 Air flow direction 32 DC OUTPUT POS 9.5 AC INPUT BOTTOM SIDE M6.0 NEG Derating Curve External DC Control VS Output Voltage Vout 7.5 115 132 O.V.P. 100 100 OUTPUT VOLTAGE (%) 80 LOAD (%) non-linear 60 40 50 20 -10 0 10 20 30 40 50 60 V 1 2 3 4 5 Ta ( ) EXTERNAL VOLTAGE(Typical) File Name:SCN-600-SPEC 2008-05-06 VS+ VSVCI VCO GND PAR GND INH LED NEGV ADJ 500~600W Parallel (N+1) With PFC Function Control terminal instruction manual SCP-600 series LOAD LOAD LOAD LOAD VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH ON/OFF SWITCH VS+ VSVCI VCO PG PAR GND INH H:ON L:OFF USING INTERNAL VOLTAGE CONTROL REMOTE SENSING ON/OFF CONTROL BY SWITCH ON/OFF CONTROL BY TRANSISTOR Vout GOOD FAIL : LED OFF : LED ON O.V.P. 120% (Typ.) 120 100 LOAD LOAD OUTPUT VOLTAGE (%) 80 60 40 20 Non-Linear VS+ VSVCI VCO PG PAR GND INH 40V / 0.5A MAX. VS+ VSVCI VCO PG PAR GND INH DC 1-5V POWER GOOD SIGNAL OUTPUT VOLTAGE ADJUST WITH DC 1-5V 1 2 3 4 5 6 V EXTERNAL VOLTAGE (DC) LOAD LOAD VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH VS+ VSVCI VCO PG PAR GND INH PARALLEL OPERATION WITH REMOTE SENSING PARALLEL OPERATION WITHOUT REMOTE SENSING F ile Name: SCP-600-SPEC 2008-05-06