GS60A05-P1J

60W AC-DC Single Output Desktop Features : Universal AC input / Full range 3 pole AC inlet IEC320-C14 GS60 series Protections: Short circuit / Overload / Over voltage/ Over temperature Fully enclosed plastic case Approvals: UL / CUL / TUV / BSMI / CB / FCC / CE Class power ( with earth pin) Pass LPS LED indicator for power on No load power consumption 70 Protection type : Shut down o/p voltage, re-power on to recover -30 ~ +50 (Refer to "Derating Curve") 20% ~ 90% RH non-condensing -40 ~ +85 , 10 ~ 95% RH 0.03% / (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes UL60950-1, TUV EN60950-1, BSMI CNS14336, J60950-1(except for 48V) approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 class B, EN61000-3-2,3, FCC PART 15 / CISPR22 class B, CNS13438 class B, GB17625.1 Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A 711Khrs min. MIL-HDBK-217F(25 ) 125*50*31.5mm (L*W*H) 0.305Kg; 40pcs/13.02Kg/1.05CUFT Standard type P1J: 2.1 * 5.5 * 11mm, tuning fork type, center positive for stock ; Other type available by customer requested See page 2 ; Other type available by customer requested 85.5% 1A / 230VAC 87.5% 88% 88.5% 88.5% 90% 92% 25.2 ~ 32.4V 50.4 ~ 64.8V CONNECTOR NOTE 1. All parameters are specified at 230VAC input, rated load, 25 70% RH ambient. 2. DC voltage: The output voltage set at point measure by plug terminal & 50% load. 3. Ripple & noise are measured at 20MHz by using a 12" twisted pair terminated with a 0.1uf & 47uf capacitor. 4. Tolerance: includes set up tolerance, line regulation, load regulation. 5. Line regulation is measured from low line to high line at rated load. 6. The power supply is considered as an independent unit, but the final equipment still need to re-confirm that the whole system complies with the EMC directives. 7. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time. File Name:GS60-SPEC 2011-06-15 60W AC-DC Single Output Desktop Mechanical Specification GS60 Case No. 974A series Unit:mm 31.5 125 UL2624 16AWG 1000 50mm for 5 ~ 9V UL1185 16AWG 1000 50mm for 12 ~ 15V UL1185 18AWG 1800 50mm for 18 ~ 48V POWER LED 50 7 0 10mm C"+" 11 0.5mm ID 2.1 x OD 5.5 Plug Assignment Standard plug: P1J P1J P/N CENTER OUTPUT + Derating Curve Static Characteristics Ta=25 100 90 100 80 80 60 70 LOAD (%) LOAD (%) 0 10 20 30 40 50 60 70 50 40 60 50 40 20 -30 (HORIZONTAL) 90 95 100 110 120 140 160 180 200 220 240 264 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (VAC) 60Hz File Name:GS60-SPEC 2011-06-15