LPC-20_12

20W Single Output Switching Power Supply Features : LPC-20 series Constant current design Universal AC input / Full range Withstand 300VAC surge input for 5 seconds Protections: Short circuit / Over voltage Cooling by free air convection Small and compact size Fully encapsulated with IP67 level (Note.7) Fully isolated plastic case Class power unit, no FG Class 2 power unit Pass LPS Suitable for LED lighting and moving sign applications 100% full load burn-in test Low cost, high reliability 2 years warranty SPECIFICATION MODEL RATED CURRENT DC VOLTAGE RANGE RATED POWER VOLTAGE TOLERANCE Note.3 CURRENT ACCURACY LINE REGULATION LOAD REGULATION SETUP, RISE TIME HOLD UP TIME (Typ.) VOLTAGE RANGE FREQUENCY RANGE INPUT EFFICIENCY (Typ.) AC CURRENT (Typ.) INRUSH CURRENT(max.) LEAKAGE CURRENT PROTECTION OVER VOLTAGE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE EMC ISOLATION RESISTANCE EMC EMISSION EMC IMMUNITY MTBF OTHERS DIMENSION PACKING NOTE LPS IP67 LPC-20-350 350mA 9 ~ 48V 16.8W 5.0% 5.0% 1.0% 2.0% Note.6 500ms, 250ms / 230VAC ( for 350mA only) ( except for 350mA ) LPC-20-700 700mA 9 ~ 30V 21W 200mVp-p RIPPLE & NOISE (max.) Note.2 200mVp-p OUTPUT 500ms, 250ms / 115VAC at full load 50ms/230VAC Note.4 90 ~ 264VAC 16ms/115VAC at full load 127 ~ 370VDC 47 ~ 63Hz 83% 0.55A/115VAC 0.35A/230VAC COLD START 35A/115VAC 70A/230VAC 0.25mA / 240VAC 50.4 ~ 60V Protection type : Shut off o/p voltage, clamping by zener diode -30~ +70 -40 ~ +80 (Refer to "Derating Curve") , 10 ~ 95% RH 20 ~ 90% RH non-condensing 0.03%/ (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes UL879, UL1310 , CSA C22.2 No. 207-M89(except for LPC-20-350), CAN/CSA C22.2 No. 223-M91(except for LPC-20-350), IP67 approved ; design refer to TUV EN60950-1 I/P-O/P:3KVAC I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 (CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3 Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A 786.5Khrs min. MIL-HDBK-217F (25 ) 118*35*26mm (L*W*H) 0.22Kg; 60pcs/14.2Kg/0.62CUFT 31.5 ~ 40.5V 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltage. Please check the static characteristics for more details. 5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. 6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time. 7. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute. 8. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit. File Name:LPC-20-SPEC 2012-03-20 20W Single Output Switching Power Supply Mechanical Specification LPC-20 Case No. 972A series Unit:mm 600 3 0 UL1015 18AWG 118 3.5 17 600 30 35 3.5 23.5 T case: Max. Case Temperature. 26 Recommend Mounting Direction Block Diagram fosc : 60KHz I/P EMI FILTER & RECTIFIERS POWER SWITCHING RECTIFIERS & FILTER O.C.P. 28 AC/N(Blue) AC/L(Brown) 3.5 T case 3.6 UL1015 18AWG +V(Red) -V(Black) +V -V O.L.P. PWM CONTROL DETECTION CIRCUIT O.V.P. Derating Curve Static Characteristics 100 100 90 80 80 70 60 LOAD (%) 40 LOAD (%) -15 0 15 30 40 50 60 70 (HORIZONTAL) 60 50 40 20 -30 90 100 125 135 145 155 165 175 180 200 230 264 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (V) 60Hz File Name:LPC-20-SPEC 2012-03-20