LPV-150-12

L P V- 1 5 0 150W Single Output Switching Power Supply IP67 ■ Features Constant voltage design 90~132VAC input for LPVL-150 180~305VAC input for LPV-150 Fully encapsulated with IP67 level (Note.8) ClassⅡpower unit, no FG Protections: Short circuit/Overload/Over voltage/ (for L type only) series (for Blank type only) ■ Applications LED channel letters Indoor LED lighting LED decorative lighting Over temperature Fully isolated plastic case Fanless design, cooling by free air convection 100% full load burn-in test Low cost, high reliability Listed in UL Sign Component Manual (SAM) Type “HL” for use in class I, Division 2 hazardous (Classified) location luminaires for LPVL-150 2 years warranty ■ Description LPV-150 and LPVL-150 are 150W single output power supplies that specifically and perfectly work for LED lighting and LED moving sign applications. As a class II power unit, these two series are housed with the UL 94V-0 rated flame retardant plastic enclosure. The IP67 design allows every model to fit the use at dry, damp and wet locations. Both series are constant voltage mode design that various models with 12V, 15V, 24V, 36V and 48V are offered for LPV-150 where as 12V and 24V are provided for LPVL-150. ■ Model Encoding LPV L - 150 - 12 Output voltage Output wattage Blank: AC input range 180~305VAC { L:AC input range 90~132VAC Series name File Name:LPV-150-SPEC 2017-08-07 L P V- 1 5 0 150W Single Output Switching Power Supply series SPECIFICATION LPV -150-12 LPV-150-15 LPV LPV-150-36 LPV-150-48 DC VOLTAGE 12V 15V 24V 36V 48V RATED CURRENT 10A 0 ~ 10A 8A 6.3A 4.2A 3.2A 0 ~ 8A 0 ~ 6.3A 0 ~ 4.2A 0 ~ 3.2A 120W 151.2W 151.2W 153.6W 200mVp-p 200mVp-p 200mVp-p 200mVp-p MODEL CURRENT RANGE 120W RIPPLE & NOISE (max.) Note.2 200mVp-p VOLTAGE TOLERANCE Note.3 ±5.0% ±1.0% LINE REGULATION RATED POWER OUTPUT ±2.0% LOAD REGULATION Note.6 LPV-150: 500ms, 50ms / 230VAC SETUP, RISE TIME HOLD UP TIME (Typ.) VOLTAGE RANGE -150-24 LPV-150: 18ms/230VAC 500ms, 50ms / 277VAC; Note.4 LPV-150: 180 ~ 305VAC 254 ~ 431VDC; FREQUENCY RANGE EFFICIENCY (Typ.) 47 ~ 63Hz 87% LPVL-150: 1500ms, 50ms / 115VAC 20ms/277VAC at full load; LPVL-150: 10ms/115VAC at full load LPVL-150: 90~132VAC 254 ~ 370VDC 89% 89% 88% 90% AC CURRENT INPUT LPV-150: 1.7A/230VAC 1.5A/277VAC; LPVL-150: 3.0A/115VAC INRUSH CURRENT Blank type COLD START 60A(twidth=900μs measured at 50% Ipeak) at 230VAC (Typ.) L type COLD START 75A(twidth=900μs measured at 50% Ipeak) at 115VAC MAX. No. of PSUs Blank type 2 units (circuit breaker of type B) / 3 units (circuit breaker of type C) at 230VAC on 16A CIRCUIT BREAKER 1 units (circuit breaker of type B) / 2 units (circuit breaker of type C) at 115VAC L type LEAKAGE CURRENT OVERLOAD PROTECTION LPV-150: 0.25mA / 240VAC LPVL-150:0.25mA / 120VAC 110 ~ 150% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 13.5 ~ 18V 40 ~ 49V 27 ~ 35V 17 ~ 25V OVER VOLTAGE OVER TEMPERATURE Shut down o/p voltage, recovers automatically after temperature goes down WORKING TEMP. -25 ~ +65℃ (Refer to "Derating Curve") WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS 52 ~ 63V Protection type : Shut down o/p voltage, re-power on to recover 20 ~ 90% RH non-condensing -40 ~ +80℃, 10 ~ 95% RH ±0.03%/℃ (0 ~ 40℃ for LPV-150-12,15 and LPVL-150-12,24;0~50℃ for LPV-150-24,36,48) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes Blank type UL8750,CSA C22.2 No 250.13-12,UL879,CSA C22.2 No.207-M89,IP67 approved. Design refer to EN60950-1 L type UL8750(type”HL”),CSA C22.2 No 250.13-12,UL879,CSA C22.2 No.207-M89,IP67 approved WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH SAFETY & ISOLATION RESISTANCE Blank type Compliance to EN55032 (CISPR32) Class B, EN61000-3-2 Class A(≤80% load), EN61000-3-3 EMC EMC EMISSION L type Compliance to FCC part 15 Blank type Compliance to EN61000-4-2,3,4,5,6,8,11; EN55024, light industry level, criteria A EMC IMMUNITY L type Design refer to IEC61000-4-2,3,4,5,6,8,11; light industry level, criteria A MTBF 703Khrs min. MIL-HDBK-217F (25℃) OTHERS 191*63*37.5mm (L*W*H) DIMENSION PACKING LPVL-150: 0.85Kg;20pcs/17Kg/0.95CUFT ‘ NOTE LPV-150: 0.74Kg;20pcs/15.8Kg/0.95CUFT; 1. All parameters NOT specially mentioned are measured at 230VAC(115VAC for LPVL) input, rated load and 25℃ of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltage. Please check the static characteristics for more details. 5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. 6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time. 7. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit. 8. Suitable for indoor use or outdoor use without direct sunlight exposure. File Name:LPV-150-SPEC 2017-08-07 L P V- 1 5 0 150W Single Output Switching Power Supply Mechanical Specification series Case No. LPC-150 Unit:mm 300±20 300±20 191 5 25 25 4. 5 63 5 SJTW 18AWG AC/N(Blue) AC/L(Brown) ψ +V(Red) -V(Black) 96 tc 26 2- 5 tc : Max. Case Temperature 3 37.5 5 SJTW 14AWG T case Recommend Mounting Direction Block Diagram PWM fosc : 47KHz 65KHz EMI FILTER & RECTIFIERS I/P RECTIFIERS & FILTER POWER SWITCHING O.L.P. +V -V DETECTION CIRCUIT PWM CONTROL O.V.P. Derating Curve Static Characteristics 100 LPV-150-24,36,48 100 90 80 80 LPV-150-12,15 70 LOAD (%) LOAD (%) 60 40 LPVL-150 20 -25 -15 0 15 30 40 50 AMBIENT TEMPERATURE (℃) 60 65 (HORIZONTAL) 60 50 40 180 90 190 200 100 210 220 105 230 240 250 260 120 270 280 130 305 (Blank type) 132 (L type) INPUT VOLTAGE (V) 60Hz File Name:LPV-150-SPEC 2017-08-07