MWP-610

304W Triple Output for Video Game Features : AC input range selected by switch Economical video game power Power ON-OFF switch MWP-610 Protections: Short circuit / Overload / Over voltage / Over temperature Forced air cooling by built-in DC fan 100% full load burn-in test 2 years warranty SPECIFICATION MODEL NO. CHANNEL DC VOLTAGE MINIMUM CURRENT PEAK CURRENT (10 min.) MWP-610 CH1 5V 1.5A 8A 304W 150mVp-p 5.0% 1.0% 5.0% 200mVp-p 5.0% 1.0% 5.0% 5.0% 1.0% Note.3 CH2 12V 1A 8A 12A CH3 24V 0.5A 4.5A 5A RATED CURRENT (CONTINUOUS) 8A RATED POWER (CONTINUOUS) 244W OUTPUT PEAK POWER (10 min.) VOLTAGE TOLERANCE LINE REGULATION LOAD REGULATION HOLD UP TIME VOLTAGE RANGE FREQUENCY RANGE EFFICIENCY (Typ.) RIPPLE & NOISE (max.) Note.2 80mVp-p 5.0% 12ms min. at full load AC RECEPTACLE RATED (max.) 1A / 230VAC 100 ~ 132VAC / 200 ~ 264VAC selected by switch 47 ~ 63Hz 76% 8A / 115VAC 4.5A / 230VAC 40A / 115VAC 80A / 230VAC 3.5mA / 240VAC 105 ~ 200% rated output power Protection type : Shut down o/p voltage, re-power on to recover 105 ~ 140% rated output voltage Protection type : Shut down o/p voltage, re-power on to recover Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -10 ~ +50 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.05% / ( 0 ~ 50 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes Design refer to EN60950-1 I/P-O/P, I/P-FG:1.5KVAC I/P-O/P, I/P-FG:50M Ohms / 500VDC / 25 Design refer to EN55022 class B INPUT AC CURRENT INRUSH CURRENT (max.) LEAKAGE CURRENT(max.) OVERLOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE EMC ISOLATION RESISTANCE (Note 4) EMI CONDUCTION & RADIATION CONNECTOR OTHERS NOTE COOLING DIMENSION / 70% RH See page 2 Forced air ventilation by 8cm DC fan 150*140*86mm (L*W*H) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Load regulation is measured from 20% to 100% max. Load. 4. The power supply is considered as an independent unit, but the final equipment still need to re-confirm that the whole system complies with the EMC directives. File Name: MWP-610-SPEC 2010-04-28 304W Triple Output for Video Game Mechanical Specification MWP-610 Unit: mm 86 80 42.55 16 6 52.4 118.5 140 Derating Curve 150 100 120 80 60 40 20 138 230 OUTPUT WIRES 29.5 69.9 61.8 25 PIN12 PIN4 350 50 PIN9 PIN1 Pin No. Assignment :JST ELR-12V or equivalent Pin No. 1 2 3 4 Assignment +12V GND +24V +5V Pin No. 5 6 7 8 Assignment +12V GND +24V +5V Pin No. 9 10 11 12 Assignment +12V GND GND +5V Static Characteristics Ta=25 100 90 80 70 LOAD (%) LOAD (%) 0 10 20 30 35 40 50 60 (HORIZONTAL) 60 50 40 -10 100 200 105 210 110 220 115 230 120 240 132 264 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (VAC) 60Hz File Name: MWP-610-SPEC 2010-04-28