MWP-610P

304W Triple Output for Video Game Features : 230VAC input only Built-in passive PFC, PF>0.7 Economical video game power Power ON-OFF switch MWP-610P Protections: Short circuit / Overload / Over voltage / Over temperature Forced air cooling by built-in DC fan 100% full load burn-in test 2 years warranty SPECIFICATION MODEL NO. CHANNEL DC VOLTAGE MINIMUM CURRENT PEAK CURRENT (10 min.) MWP-610P CH1 5V 1.5A 8A 304W 150mVp-p 5.0% 1.0% 5.0% 200mVp-p 5.0% 1.0% 5.0% 5.0% 1.0% Note.3 CH2 12V 1A 8A 12A CH3 24V 0.5A 4.5A 5A RATED CURRENT (CONTINUOUS) 8A RATED POWER (CONTINUOUS) 244W OUTPUT PEAK POWER (10 min.) VOLTAGE TOLERANCE LINE REGULATION LOAD REGULATION HOLD UP TIME RIPPLE & NOISE (max.) Note.2 80mVp-p 5.0% 12ms min. at full load AC RECEPTACLE RATED (max.) 1A / 230VAC 200 ~ 264VAC VOLTAGE RANGE FREQUENCY RANGE INPUT POWER FACTOR (Typ.) EFFICIENCY (Typ.) AC CURRENT INRUSH CURRENT (max.) LEAKAGE CURRENT(max.) OVERLOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE EMC EMI CONDUCTION & RADIATION (Note 4) HARMONIC CURRENT EMS IMMUNITY CONNECTOR OTHERS NOTE COOLING DIMENSION 47 ~ 63Hz PF>0.7 / 230VAC 76% 4.5A / 230VAC 80A / 230VAC 3.5mA / 240VAC 105 ~ 200% rated output power Protection type : Shut down o/p voltage, re-power on to recover 105 ~ 140% rated output voltage Protection type : Shut down o/p voltage, re-power on to recover Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -10 ~ +50 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.05% / ( 0 ~ 50 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes Design refer to EN60950-1 I/P-O/P, I/P-FG:1.5KVAC I/P-O/P, I/P-FG:50M Ohms / 500VDC / 25 Compliance to EN55022 Class B / 70% RH Compliance to EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A See page 2 Forced air ventilation by 8cm DC fan 150*140*86mm (L*W*H) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Load regulation is measured from 20% to 100% max. Load. 4. The power supply is considered as an independent unit, but the final equipment still need to re-confirm that the whole system complies with the EMC directives. File Name: MWP-610P-SPEC 2010-04-28 304W Triple Output for Video Game Mechanical Specification MWP-610P Unit: mm 86 80 42.55 16 6 52.4 118.5 140 Derating Curve 150 100 120 80 60 40 20 138 OUTPUT WIRES 29.5 69.9 61.8 25 PIN12 PIN4 350 50 PIN9 PIN1 Pin No. Assignment :JST ELR-12V or equivalent Pin No. 1 2 3 4 Assignment +12V GND +24V +5V Pin No. 5 6 7 8 Assignment +12V GND +24V +5V Pin No. 9 10 11 12 Assignment +12V GND GND +5V Static Characteristics Ta=25 100 90 80 70 LOAD (%) LOAD (%) 0 10 20 30 35 40 50 60 (HORIZONTAL) 60 50 40 -10 200 210 220 230 240 264 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (VAC) 60Hz File Name: MWP-610P-SPEC 2010-04-28