160W Single Output Medical Type
Features :
RPS-160
Universal AC input / Full range Built-in active PFC function
series
Protections: Short circuit / Overload / Over voltage / Over temperature 5"x3" compact size Free air convection for 110W and 160W with 20.5 CFM forced air With power good and fail signal output Built-in remote sense function for 5~15V No load power consumption under 0.75W by PS-ON control (G model)
Standby 5V@0.8A with fan, @0.6A without fan (G model)
3 years warranty
RPS G G: With 5Vsb & no load power consumption < 0.75 W Blank: Basic function (without 5Vsb)
160 12
SPECIFICATION
MODEL DC VOLTAGE RPS -160-5 5V RATED CURRENT (20.5CFM) 30A CURRENT RANGE (convection) 0 ~ 20A CURRENT RANGE (20.5CFM) 0 ~ 30A RATED POWER (convection) Note.7 103W RATED POWER (20.5CFM) Note.8 155W OUTPUT RIPPLE & NOISE (max.) Note.2 100mVp-p VOLTAGE ADJ. RANGE LINE REGULATION LOAD REGULATION SETUP, RISE TIME HOLD UP TIME (Typ.) VOLTAGE RANGE FREQUENCY RANGE POWER FACTOR (Typ.) INPUT EFFICIENCY (Typ.) AC CURRENT (Typ.) INRUSH CURRENT (Typ.) LEAKAGE CURRENT OVERLOAD OVER VOLTAGE PROTECTION OVER TEMPERATURE CH1:4.5 ~ 5.5V VOLTAGE TOLERANCE Note.3 4.0% 0.5% 1.0% 1800ms, 30ms/230VAC
Note.6 90 ~ 264VAC
RPS -160-12 12V 12.9A 0 ~ 9.1A 0 ~ 12.9A 112.2W 159.8W 100mVp-p CH1:10.8 ~ 13.2V 3.0% 0.5% 1.0%
RPS -160-15 15V 10.3A 0 ~ 7.3A 0 ~ 10.3A 112.5W 159.5W 120mVp-p CH1:13.5 ~ 16.5V 3.0% 0.5% 1.0%
RPS -160-24 24V 6.5A 0 ~ 4.6A 0 ~ 6.5A 113.4W 161W 150mVp-p CH1:22 ~ 27V 2.0% 0.5% 1.0%
RPS -160-48 48V 3.25A 0 ~ 2.3A 0 ~ 3.25A 113.4W 161W 250mVp-p CH1:43.2 ~ 52.8V 2.0% 0.5% 1.0%
3500ms, 30ms/115VAC at full load
16ms/230VAC/115VAC at full load 127 ~ 370VDC PF>0.98/115VAC at full load 87% 87% 87% 88% 47 ~ 63Hz PF>0.93/230VAC 85%
2A/115VAC 1.1A/230VAC COLD START 35A/115VAC 70A/230VAC Earth leakage current 1ms POWER GOOD / POWER FAIL 500ms>PG>10ms 5 ~ 15V REMOTE SENSE -20 ~ +70 (Refer to "Derating Curve") WORKING TEMP.
WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC (Note 4) EMC EMISSION
20 ~ 90% RH non-condensing -40 ~ +85 , 10 ~ 95% RH 0.03%/ (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes ANSI/AAMI ES60601-1, TUV EN60601-1 approved I/P-O/P:4KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55011 (CISPR11), EN55022 (CISPR22) Class B, EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, EN60601-1-2, EN61204-3, medical level, criteria A 230.5Khrs min. MIL-HDBK-217F (25 ) 127*76.2*34.6mm (L*W*H) 0.32Kg; 36pcs/12.5Kg/0.79CUFT
EMC IMMUNITY MTBF
OTHERS DIMENSION PACKING
NOTE
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies. (as available on http://www.meanwell.com) 5. HS1,HS2 & HS3 can not be shorted. 6. Derating may be needed under low input voltages. Please check the derating curve for more details. 7. The rated power includes 5Vsb @ 0.6A. 8. The rated power includes 5Vsb @ 0.8A.
160W Single Output Medical Type
Mechanical Specification
FAN
20.5CFM min.
5
RPS-160
series
Unit:mm
AC Input Connector (CN1) : JST B3P-VH or equivalent
Pin No. 1 2 3 Assignment AC/L No Pin AC/N
5cm
Mating Housing JST VHR or equivalent
Terminal JST SVH-21T-P1.1 or equivalent
SVR1 CN3
HS1
1 2 3 4
DC Output Connector (CN2) : JST B8P-VH or equivalent
1 2 3 4 5 6 7 8
76.2
66.2
FS1 CN1 FS2 1 2 3
HS2
Pin No. 1,2,3,4 5,6,7,8
Assignment +V -V
Mating Housing JST VHR or equivalent
Terminal JST SVH-21T-P1.1 or equivalent
HS3
CN2 CN901 LED
Power Good Connector(CN3):JST B4B-XH or equivalent
Pin No.
CN901
Status PG GND -S +S
Mating Housing JST XHP or equivalent
Terminal JST SXH-001T-P0.6 or equivalent
4-
5
117 127
3.5
1234
1 2 3 4
5VSB Connector(CN901) : JST B-XH or equivalent
PS/ON 5mA(max.)
34.6
GND
Pin No. 1 2,4 3
Assignment PS/ON GND 5VSB
Mating Housing JST XHP or equivalent
Terminal JST SXH-001T or equivalent
HS1,HS2,HS3 can not be shorted
3 max.
Block Diagram
+5VSB DETECTION CIRCUIT
fosc :100KHz(5V) 70KHz(12~48V)
+5VSB
+S
POWER SWITCHING PWM CONTROL
I/P EMI FILTER RECTIFIERS & PFC POWER SWITCHING
RECTIFIERS & FILTER RECTIFIERS & FILTER PG
+V -V -S PG
FG O.L.P. CONTROL
DETECTION CIRCUIT O.V.P.
PS/ON CONTROL
PS/ON
Derating Curve
Output Derating VS Input Voltage
100
100
With FAN
90 80 70
80
60
LOAD (%)
LOAD (%)
60 70 (HORIZONTAL)
Without FAN
40
60 50 40
20
-20
0
10
20
30
40
50
90
95
100
115
120
140
160
180
200
220
240
264
AMBIENT TEMPERATURE ( )
INPUT VOLTAGE (VAC) 60Hz
File Name:RPS-160-SPEC 2012-02-20
很抱歉,暂时无法提供与“RSP-160-5”相匹配的价格&库存,您可以联系我们找货
免费人工找货