SLW05B-15

5W DC-DC Regulated Single Output Converter Features : S LW 0 5 series 2:1 wide input range 4:1 wide input range(option) 1000VDC I/O isolation 3000VDC I/O isolation(option) Built-in EMI filter Protections: Short circuit / Overload Cooling by free air convection Six-sided shield metal case 100% burn-in test Low cost / High reliability Approvals: FCC / CE 2 years warranty SPECIFICATION ORDER NO. DC VOLTAGE CURRENT RANGE RATED POWER VOLTAGE ACCURACY OUTPUT SLW05A- SLW05B- SLW05C- SLW05A- SLW05B- SLW05C- SLW05A- SLW05B- SLW05C- SLW05A- SLW05B- SLW05C05 05 05 09 09 12 12 12 15 15 15 09 5V 100 ~ 1000mA 5W 60mVp-p 60mVp-p 60mVp-p 9V 55.6 ~ 556mA 12V 41.7 ~ 417mA 15V 33.3 ~ 333mA 2.0% RIPPLE & NOISE (max.) Note.2 50mVp-p LINE REGULATION Note.3 0.2% LOAD REGULATION VOLTAGE RANGE EFFICIENCY (Typ.) Note.4 0.5% 50KHz min. A: 9 ~ 18VDC 75% Full load No load 77% A: 33mA B: 18 ~ 36VDC 77% B: 16mA C: 36 ~ 72VDC 80% 80% 83% 80% 80% 83% 81% 81% 85% C: 135mA C: 10mA SWITCHING FREQUENCY INPUT DC CURRENT FILTER PROTECTION OVER CURRENT A: 556mA B: 270mA Pi network Fuse recommended 160 ~ 250% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed All output equipped with short circuit Protection type : Hiccup mode, recovers automatically after fault condition is removed -25 ~ +71 (Refer to output load derating curve) 20% ~ 90% RH non-condensing -25 ~ +105 , 10 ~ 95% RH 0.03% / (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes I/P-O/P:1KVDC I/P-O/P: 100M Ohms / 500VDC / 25 / 70% RH PROTECTION (Note. 5) SHORT CIRCUIT WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE EMC OTHERS EMI CONDUCTION & RADIATION Compliance to EN55022 Class B, FCC part 15 Class B Compliance to EN61000-4-2,3,4,5,6,8, light industry level, criteria A EMS IMMUNITY 800khrs min. MIL-HDBK-217F(25 ) MTBF DIMENSION 50.8*25.4*11.27mm or 2"*1"*0.44" inch (L*W*H) WEIGHT 32g Mechanical Specification Unit:mm 50.8 15.3 20.3 15.2 2.5 Pin Configuration 11.27 Derating Curve Pin no. 1 2 3 4 5 Output Single + Vi n - Vi n + Vo u t No Pin - Vo u t 10.2 5.1 10.1 100 10.2 10.2 25.4 1 2 LOAD (%) 3 4 5 80 2.5 BOTTOM VIEW 0.8 + 0.1/-0 5.8(0.13) -25 0 25 50 60 71 100 Ta ( NOTE 1.All parameters are specified at normal input, rated load, 25 70% RH ambient. 2.Ripple & noise are measured at 20MHz by using a 12" twisted pair terminated with a 0.1uf & 47uf capacitor. 3.Line regulation is measured from low line to high line at rated load. 4.Load regulation is measured from 10% to 100% rated load. 5.Please prevent the converter from operating in overload or short circuit condition for more than 30 seconds. ) File Name:SLW05-SPEC 2008-05-12