HERF1602C

HIGH EFFICIENCY GLASS PASSIVATED RECTIFIER HERF1601C THRU HERF1607C FEATURES • • • • • • • VOLTAGE RANGE CURRENT 50 to 1000 Volts 16.0 Ampere ITO-220AB • • High speed switching Glass passivated chip junction Low power loss, high efficiency Low leakage High surge capacity High temperature soldering guaranteed 250℃/10 second, 0.16″(4.06mm) lead length Also available with common Anode, add an “A” suffix, i.e. HERF1601CA, add as a doubler, add a “D” suffix, i.e. HERF1601CD Also available in an isolated package, HER1601C Also available in the single chip version, HERF1601 MECHANICAL DATA • • • • • • Dimensions in inches and (millimeters) Case: Transfer molded plastic Epoxy: UL94V-0 rate flame retardant Lead: solderable per MIL-STD-202E method 208C Polarity: as Marked Mounting position: Any, 5 in-lbs Torque Max Weight: 0.08ounce, 2.24 gram MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25℃ ambient temperature unless otherwise specified Single Phase, half wave, 60Hz, resistive or inductive load For capacitive load derate current by 20% HERF HERF SYMBOLS 1601C 1602C Maximum Repetitive Peak Reverse Voltage VRRM 50 100 Maximum RMS Voltage VRMS 35 70 Maximum DC Blocking Voltage VDC 50 100 • • • Maximum Average Forward Rectified Current At Tc=100℃ Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC method) Maximum Instantaneous Forward Voltage per at 8.0A Maximum DC Reverse Current at rated TA = 25℃ DC Blocking Voltage at TA = 125℃ Maximum Reverse Recovery Time Test conditions lF=0.5A, lR=1.0A, lRR=0.25A Typical Junction Capacitance ( Measured at 1.0MHz and applied reverse voltage of 4.0V) Typical Thermal Resistance (NOTE 1) Operating Junction Temperature Storage Temperature Range HERF 1603C 200 140 200 HERF 1604C 300 210 300 16.0 125 HERF 1605C 400 280 400 HERF 1606C 600 420 600 HERF 1607C 800 560 800 UNIT Volts Volts Volts Amps Amps I(AV) IFSM VF IR trr CJ RθJC TJ TSTG 70 1.0 1.3 10 500 1.5 1.7 Volts µA 100 40 2.5 (-55 to +150) (-55 to +150) nS pF ℃/W ℃ ℃ Notes: 1. Unit mounted on heatsink E-mail: sales@cnmic.com Web Site: www.cnmic.com HIGH EFFICIENCY GLASS PASSIVATED RECTIFIER HERF1601C THRU HERF1607C VOLTAGE RANGE CURRENT 50 to 1000 Volts 16.0 Ampere RATING AND CHRACTERISTIC CURVES HERF1601C THRU HERF1607C FIG.1-TYPICAL FORWARD CURRENT DERATING CURVE AVERAGE FORWARD CURRENT, 24 F IG.2-MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT PEAK FORWARD SURGE 20 150 16 CURRENT, (A) 8.3ms Single Half Sine-Wave (JEDEC Method) T= Tjmax 100 (A) 12 8.0 Single Phase Half Wave 60Hz Resistive or Inductive Load 0.375″(9.5mm) Lead Length 50 4.0 0 0 25 50 75 100 125 150 175 0 1 1 Cycle 2 4 6 8 10 20 40 60 100 AMBIENT TEMPERATURE, (° C) NUMBER OF CYCLES AT 60 Hz FIG.3-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS PER LEG 100 FIG.4-TYPICAL REVERSE CHARACTERISTICS PER LEG INSTANTANEOUS FORWARD CURRENT, 100 TJ=125° C 00 V 10 00 V (A) TJ =25° C Pulse Width=300us 1% Duty Cycle 0.1 0.4 0.8 1.2 1.6 (μA) 1.0 50 /10 0/ 2 30 0 60 80 0/ 0V INSTANTANEOUS REVERSE CURRENT, 10 /4 1.0 TJ =25 ° C 0.1 INSTANTANEOUS FORWARD VOLTAGE,(V) FIG.5-TYPICAL JUNCTION CAPACITANCE PER LEG 100 0.01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE,(%) JUNCTION CAPACITANCE,(pF) F1G.6-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC Trr 50Ω 10Ω NONINDUCTIVE NONINDUCTIVE 10 (+) 25 Vdc (approx.) (-) T J =25 ° C f=1MHz Vsig=50mVp-p D.U.T. (-) PULSE GENERATIOR (NOTE 2) (+) OSCILLOSCOPE (NOTE 1) +0.5A 0 -0.25A 1Ω NON INDUCTIVE -1.0A 1cm 1 0.1 1.0 10 100 REVERSE VOLTAGE,(V) NOTES : 1.Rise Time=7ns mas. Input Impedance= 1 magohm. 22pF 2.Rise time=10ns max. Source Impedance= 50 ohms SET TIME BASE FOR 50/100ns/cm E-mail: sales@cnmic.com Web Site: www.cnmic.com