60KS200CH1

60KS200C & 90KS200C BI-DIRECTIONAL TRANSIENT VOLTAGE SUPPRESSORS SCOTTSDALE DIVISION APPEARANCE These devices are bidirectional Transient Voltage Suppressors (TVSs) for shipboard equipment and power servicing equipment where large voltage transients endanger voltage sensitive components. It meets all applicable environmental requirements of MIL-S-19500 and is consistent with MIL-E-16400. Designed with MIL-STD-1399 Section 300A (Interface standard for shipboard systems, Electrical power, alternating current) as the controlling specification. The subassembly components can also be tested or screened for military requirements prior to encapsulation into the complete module. The screening would consist of 100% TX level environmental testing per MIL-PRF-19500/507A (Par. 4.3). For ordering these options, use the following suffix: H1 – Submodule Screening H2 – Submodule and Module Screening H3 – Submodule and Module Screening & Module Group B & C lot testing The individual submodules can also be selected for lower or higher voltage as well as increased power capability compared to the example 200 volt 60 and 90 kW herein. WWW . Microsemi .C OM DESCRIPTION IMPORTANT: For the most current data, consult MICROSEMI’s website: http://www.microsemi.com FEATURES • • • • • • APPLICATIONS / BENEFITS • • Designed for military or commercial applications 200 Volt Bidirectional Exceeds MIL-STD-1399 requirements Can be supplied with JANTX subassemblies Module subassemblies are packaged in a hermetically sealed glass-to-metal package Moisture classification is Level 1 (no dry pack required) • • • MAXIMUM RATINGS • • • • • Protection from switching transients and induced RF Protection from ESD and EFT per IEC 61000-4-2 and IEC 61000-4-4 Secondary lightning protection per IEC61000-4-5 with 42 Ohm source impedance up to class 5 Secondary lightning protection per IEC61000-4-5 with 12 Ohm source impedance up to class 4 Secondary lightning protection per IEC61000-4-5 with 2 Ohm source impedance up to class 4 MECHANICAL AND PACKAGING • • • • 60,000 watts @ 1.2/50 µs Peak Pulse Power (PPP) dissipation at 25oC for 60KS200C. 90,000 watts @ 1.2/50 µs Peak Pulse Power (PPP) dissipation at 25oC for 90KS200C. Steady State power dissipation: 10 watts. Operating and Storage temperatures: -65oC to +150oC. tclamping (0 volts to V(BR) ): Less than 1 x 10-8 seconds • • CASE: Molded case. TERMINAL: Silver-plated brass. POLARITY: Bidirectional. WEIGHT (60KS200C): 65 grams (approximate) (90KS200C): 80 grams (approximate) CAPACITANCE: 170 pF @ 0 Volts (typical) Maximum Torque For Mounting: 15 in-lbs REVERSE STANDOFF VOLTAGE* MICROSEMI PART NUMBER 60KS200C 90KS200C 90KS200C VWM VOLTS 180 180 180 MAXIMUM REVERSE CURRENT @ VWM ID µA 10 0.5 0.5 BREAKDOWN VOLTAGE* @ 1 mA V(BR) VOLTS MIN. MAX. 200 225 200 225 200 225 MAXIMUM CLAMPING VOLTAGE @ IPP VC VOLTS 335 280 335 PEAK PULSE CURRENT (Fig. 2) IPP A 180 180 270 * Consult factory for other available voltages. Copyright  2002 5-26-2004 REV A Microsemi Scottsdale Division 8700 E. Thomas Rd. PO Box 1390, Scottsdale, AZ 85252 USA, (480) 941-6300, Fax: (480) 947-1503 Page 1 60KS200C & 90KS200C ELECTRICAL CHARACTERISTICS @ 25oC (Test Both Polarities)* 60KS200C & 90KS200C BI-DIRECTIONAL TRANSIENT VOLTAGE SUPPRESSORS SCOTTSDALE DIVISION IP – Peak Current - %IPP PPP – Peak Pulse Power - kW WWW . Microsemi .C OM GRAPHS tp – Pulse Time FIGURE 1 Peak Pulse Power vs. Pulse Time t – Time – µsec FIGURE 2 Pulse Wave Form (1.2 x 50µs) Peak Pulse Power (PPP) or Current o (IPP) in percent of 25 C rating NOTE: In MIL-STD-1399, Section 300A the source impedance is assumed to be 5ohms at 100 to 200kHz of shipboard electrical power systems. 60KS200C & 90KS200C T – Temperature – oC FIGURE 3 Derating Curve NOTE: Maximum operating and o storage temperature is 150 C. Copyright  2002 5-26-2004 REV A Microsemi Scottsdale Division 8700 E. Thomas Rd. PO Box 1390, Scottsdale, AZ 85252 USA, (480) 941-6300, Fax: (480) 947-1503 Page 2 60KS200C & 90KS200C BI-DIRECTIONAL TRANSIENT VOLTAGE SUPPRESSORS SCOTTSDALE DIVISION WWW . Microsemi .C OM PACKAGE DIMENSIONS 60KS200C & 90KS200C Copyright  2002 5-26-2004 REV A Microsemi Scottsdale Division 8700 E. Thomas Rd. PO Box 1390, Scottsdale, AZ 85252 USA, (480) 941-6300, Fax: (480) 947-1503 Page 3