CD5298

• 1N5283 THRU 1N5314 AVAILABLE IN JANHC AND JANKC PER MIL-PRF-19500/463 • CURRENT REGULATOR CHIPS • ALL JUNCTIONS COMPLETELY PROTECTED WITH SILICON DIOXIDE • ELECTRICALLY EQUIVALENT TO 1N5283 THRU 1N5314 • CONSTANT CURRENT OVER WIDE VOLTAGE RANGE • COMPATIBLE WITH ALL WIRE BONDING AND DIE ATTACH TECHNIQUES, WITH THE EXCEPTION OF SOLDER REFLOW CD5283 thru CD5314 MAXIMUM RATINGS Operating Temperature: -55°C to +175°C Storage Temperature: -55°C to +175°C Peak Operating Voltage: 100 VOLTS ELECTRICAL CHARACTERISTICS @ 25°C, unless otherwise speci½ed 13 MILS MAXIMUM LIMITING VOLTAGE @ lL = 0.8 lp (min) VL (VOLTS) 1.00 1.00 1.00 1.00 1.00 1.05 1.05 1.05 1.10 1.13 1.15 1.20 1.25 1.29 1.35 1.40 1.45 1.50 1.55 1.60 1.65 1.75 1.85 1.95 2.00 2.15 2.25 2.35 2.50 2.60 2.75 2.90 2.75 2.35 1.95 1.60 1.35 1.00 0.870 0.750 0.560 0.470 0.400 0.335 0.290 0.240 0.205 0.180 0.155 0.135 0.115 0.105 0.092 0.074 0.061 0.052 0.044 0.035 0.029 0.024 0.020 0.017 0.014 0.012 TYPE NUMBER NOM CD5283 CD5284 CD5285 CD5286 CD5287 CD5288 CD5289 CD5290 CD5291 CD5292 CD5293 CD5294 CD5295 CD5296 CD5297 CD5298 CD5299 CD5300 CD5301 CD5302 CD5303 CD5304 CD5305 CD5306 CD5307 CD5308 CD5309 CD5310 CD5311 CD5312 CD5313 CD5314 0.22 0.24 0.27 0.30 0.33 0.39 0.43 0.47 0.56 0.62 0.68 0.75 0.82 0.91 1.00 1.10 1.20 1.30 1.40 1.50 1.60 1.80 2.00 2.20 2.40 2.70 3.00 3.30 3.60 3.90 4.30 4.70 REGULATOR CURRENT lp (mA) @ VT = 25V (Note 3) MIN 0.198 0.216 0.243 0.270 0.297 0.351 0.387 0.423 0.504 0.558 0.612 0.675 0.738 0.819 0.900 0.990 1.08 1.17 1.26 1.35 1.44 1.62 1.80 1.98 2.16 2.43 2.70 2.97 3.24 3.51 3.87 4.23 MAX 0.242 0.264 0.297 0.330 0.363 0.429 0.473 0.517 0.616 0.682 0.748 0.825 0.902 1.001 1.100 1.210 1.32 1.43 1.54 1.65 1.76 1.98 2.20 2.42 2.64 2.97 3.30 3.63 3.96 4.29 4.73 5.17 MINIMUM DYNAMIC IMPEDANCE @VT = 25V ZT (M ) (Note 1) 25.0 19.0 14.0 9.0 6.6 4.10 3.30 2.70 1.90 1.55 1.35 1.15 1.00 0.880 0.800 0.700 0.640 0.580 0.540 0.510 0.475 0.420 0.395 0.370 0.345 0.320 0.300 0.280 0.265 0.255 0.245 0.235 MINIMUM KNEE IMPEDANCE @VK = 6.0 V ZK (M ) (Note 2) BACKSIDE IS CATHODE A = Anode DESIGN DATA METALLIZATION: Top: (Anode).......................Al Back: (Cathode)..................Au AL THICKNESS.......25,000 Å Min GOLD THICKNESS...4,000 Å Min CHIP THICKNESS.............10 Mils TOLERANCES: ALL Dimensions + 2 mils, Except Anode Pad Where Tolerance is + 0.1 mils. NOTE 1 NOTE 2 NOTE 3 ZT is derived by superimposing A 90Hz RMS signal equal to 10% of VT on VT. ZK is derived by superimposing A 90Hz RMS signal equal to 10% of VK on VK. IP is read using a pulse measurement, 10 milliseconds maximum. 6 LAKE STREET, LAWRENCE, PHONE (978) 620-2600 WEBSITE: http://www.microsemi.com M A S S A C H U S E T T S 01841 FAX (978) 689-0803 205 28 MILS CD5283 TC,TEMPERATURE COEFFICIENT (% / °C) 0.7 0.6 0.5 0.4 0.3 0.2 0.1 0 -0.1 -0.2 -0.3 -0.4 -0.5 0.2 0.3 0.4 0.5 0.6 0.7 thru CD5314 0.8 0.9 1.0 2.0 3.0 4.0 5.0 lp. NOMINAL PINCH-OFF CURRENT (mA) FIGURE 2 TEMPERATURE COEFFICIENT TC,TEMPERATURE COEFFICIENT 1.0 0.8 0.6 0.4 0.2 0 -0.2 -0.4 -0.6 -0.8 -1.0 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0 2.0 3.0 4.0 5.0 RANGE TYPICAL lp. NOMINAL PINCH-OFF CURRENT (mA) FIGURE 3 TEMPERATURE COEFFICIENT 0.1 0 ³lp,CURRENT CHANGE (mA) -0.1 -0.2 -0.3 -0.4 -0.5 -0.6 -0.7 -0.8 -0.9 -1.0 -1.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0 2.0 3.0 4.0 5.0 lp NOMINAL PINCH-OFF CURRENT (mA) FIGURE 4 TEMPERATURE COEFFICIENT 206