JANTX1N4627C-1

• 1N4614-1THRU 1N4627-1 AVAILABLE IN JAN, PER MIL-PRF-19500/435 • LOW CURRENT OPERATION AT 250 µA JANTX, JANTXV AND JANS 1N4614 thru 1N4627 and 1N4614-1 thru 1N4627-1 • LOW REVERSE LEAKAGE AND LOW NOISE CHARACTERISTICS • DOUBLE PLUG CONSTRUCTION • METALLURGICALLY BONDED MAXIMUM RATINGS Operating Temperature: -65°C to +175°C DC Power Dissipation: 500mW @ +50°C Power Derating: 4 mW / °C above +50°C Forward Voltage @ 200 mA: 1.1 Volts maximum * ELECTRICAL CHARACTERISTICS @ 25°C, unless otherwise speci½ed. JEDEC TYPE NUMBER NOMINAL ZENER VOLTAGE V @I Z ZT (Note 1) VOLTS ZENER TEST CURRENT I ZT MAXIMUM ZENER IMPEDANCE Z @I ZT ZT (Note 2) MAXIMUM REVERSE LEAKAGE CURRENT 1 R @V R MAXIMUM DC ZENER CURRENT lZM MAXIMUM NOISE DENSITY ND µA 250 250 250 250 250 250 250 250 250 250 250 250 250 250 OHMS 1200 1250 1300 1400 1500 1600 1650 1700 1650 1600 1550 1500 1400 1200 µA 7.5 5.0 4.0 2.0 1.0 0.8 7.5 7.5 5.0 4.0 10.0 10.0 10.0 10.0 VOLTS 1 1 1 1 1 1 1.5 2 2 2 3 3 4 5 mA 120 110 100 95 90 87 85 83 80 77 75 70 65 61 µ V/ 1 1 1 1 1 1 1 1 1 1 1 2 4 5 Hz 1N4614 1N4615 1N4616 1N4617 1N4618 1N4619 1N4620 1N4621 1N4622 1N4623 1N4624 1N4625 1N4626 1N4627 1.8 2.0 2.2 2.4 2.7 3.0 3.3 3.6 3.9 4.3 4.7 5.1 5.6 6.2 FIGURE 1 DESIGN DATA CASE: Hermetically sealed glass case. DO – 35 outline. LEAD MATERIAL: Copper clad steel. LEAD FINISH: Tin / Lead THERMAL RESISTANCE: (ROJEC): 250 °C/W maximum at L = .375 inch THERMAL IMPEDANCE: (ZOJX): 35 °C/W maximum POLARITY: Diode to be operated with the banded (cathode) end positive. MOUNTING POSITION: ANY. * JEDEC Registered Data. NOTE 1 The JEDEC type numbers shown above have a Zener voltage tolerance of + 5% of the nominal Zener voltage. Vz is measured with the device junction in thermal equilibrium at an ambient themperature of 25°C + 3°C. A “C” suffix denotes a + 2% tolerance and a “D” suffix denotes a + 1% tolerance. Zener impedance is derived by superimposing on l ZT A 60Hz rms a.c. current equal to 10% of l ZT (25 µ A a.c.) NOTE 2 6 L AKE STREET, LAWRENCE, MASSACHUSETTS 01841 PHONE (978) 620-2600 FAX (978) 689-0803 WEBSITE: http://www.microsemi.com 45 thru 1N4627 INCLUDING -1 VERSIONS 400 0JL, Junction to Lead Thermal Resistance (°C/W) 1N4614 300 200 100 0 0.2 0.4 0.6 0.8 1.0 L, lead Length to Heat Sink (iNCHES) FIGURE 2 TYPICAL THERMAL RESISTANCE 1000 500 400 300 200 ZENER IMPEDANCE ZZT (OHMS) 100 50 40 30 20 10 5 4 3 2 1 .1 .2 .5 1 2 5 10 20 50 100 OPERATING CURRENT IZT (mA) 3.3 VOLT 5.1 VOLT 6.2 VOLT FIGURE 3 ZENER IMPEDANCE VS. OPERATING CURRENT 46