MM3Z5529

MM3Z5518 thru MM3Z5546 SCOTTSDALE DIVISION LOW VOLTAGE AVALANCHE DIODE P RODUCT P REVIEW FEATURES • • • LOW ZENER NOISE SPECIFIED LOW ZENER IMPEDANCE LOW LEAKAGE CURRENT SOD323 PACKAGE SOD323 PACKAGE W WW. Microsemi . COM • MAXIMUM RATINGS • • • OPERATING TEMPERATURE: -55°C TO +150°C STORAGE TEMPERATURE: -55°C TO +150°C POWER: 200mW ELECTRICAL CHARACTERISTICS PER LINE @ 25°C Unless otherwise specified PART NUMBER (NOTE 1) DEVICE MARKING NOMINAL ZENER VOLTAGE VZ @ I Z T VOLTS (NOTE 2) 3.3 3.6 3.9 4.3 4.7 5.1 5.6 6.2 6.8 7.5 8.2 9.1 10.0 11.0 12.0 13.0 14.0 15.0 16.0 17.0 18.0 19.0 20.0 22.0 24.0 25.0 28.0 30.0 33.0 TEST CURRENT IZT mAdc M AX. REVERSE LEAKAGE MAX ZENER C URRENT IMPEDANCE B-C D SUFFIX VR - VOLTS ZZT @ I ZT IR µAdc OHMS (NOTE 3) (NOTE 4) N ON & A B C D S UFFIX S UFFIX 26 24 22 18 22 26 30 30 30 35 40 45 60 80 90 90 100 100 100 100 100 100 100 100 100 100 100 100 100 5.0 3.0 1.0 3.0 2.0 2.0 2.0 1.0 1.0 0.5 0.5 0.1 0.05 0.05 0.05 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.0 1 0.01 0.01 0.01 0.01 0.01 0.9 0.9 0.9 1.0 1.5 2.0 3.0 4.5 5.5 6.0 6.5 7.0 8.0 9.0 9.5 10.5 11.5 12.5 13.0 14.0 15.0 16.0 17.0 18.0 20.0 21.0 23.0 24.0 28.0 1.0 1.0 1.0 1.5 2.0 2.5 3.5 5.0 6.2 6.8 7.5 8.2 9.1 9.9 10.8 11.7 12.6 13.5 14.4 15.3 16.2 17.1 18.0 19.8 21.6 22.4 25.2 27.0 29.7 BCD B C D SUFFIX S UFFIX MAX. NOISE REGULATION LOW MAXIMUM DENSITY FACTOR VZ DC ZENEER AT IZ =250 µA ?VZ C URRENT C URRENT ND VOLTS IZL IZ M (MICRO-VOLTS (NOTE 6) mAdc mAdc PER SQUARE (NOTE 5) ROOT CYCLE) 0.5 2.0 57.5 0.90 52.5 49.0 43.0 40.5 37.5 34.0 30.5 28.0 25.5 23.0 21.0 19.0 17.5 16.0 14.5 13.5 12.5 12.0 11.0 10.5 10.0 9.5 8.5 8.0 7.5 7.0 6.5 6.0 0.5 0.5 0.5 0.5 0.5 1.0 1.0 1.0 2.0 4.0 4.0 4.0 5.0 10 15 20 20 20 20 20 20 20 20 20 20 20 20 20 0.90 0.85 0.75 0.60 0.65 0.30 0.20 0.10 0.05 0.05 0.05 0.10 0.20 0.20 0.20 0.20 0.20 0.20 0.20 0.20 0.20 0.20 0.20 0.30 0.35 0.40 0.45 0.50 2.0 2.0 2.0 1.0 0.25 0.25 0.01 0.01 0.01 0.01 0.0 1 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 0.01 PACKAGE DIMENSIONS MM3Z5518 MM3Z5519 MM3Z5520 MM3Z5521 MM3Z5522 MM3Z5523 MM3Z5524 MM3Z5525 MM3Z5526 MM3Z5527 MM3Z5528 MM3Z5529 MM3Z5530 MM3Z5531 MM3Z5532 MM3Z5533 MM3Z5534 MM3Z5535 MM3Z5536 MM3Z5537 MM3Z5538 MM3Z5539 MM3Z5540 MM3Z5541 MM3Z5542 MM3Z5543 MM3Z5544 MM3Z545 MM3Z5546 20 20 20 20 10 5.0 3.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0 DIM A B C D E F G H INCHES MILLIMETERS MIN MAX MIN MAX -.043 -1.092 -.004 -.102 -.006 -.152 .010 .016 .254 .406 .003 .006 .076 .152 .063 .075 1.600 1.905 .045 .057 1.143 1.448 .094 .106 2.388 2.692 NOTES MM3Z5518-MM3Z5546 1 2 3 4 TOLERANCE AND VOLTAGE DESIGNATION: The type part numbers shown are +/- 20 % with guaranteed limits for only VZ, IR and V F. Units with A suffix are +/- 10% with guaranteed limits for only V Z, IR and VF. Units with guaranteed limits for all six parameters are indicated by a B suffix for +/ - 5.0% units. C suffix for +/- 2.0% and D suffix for +/- 1.0%. ZENER (V Z) VOLTAGE MEASUREMENT: Nominal zener voltage is measured with the device junction in thermal equilibrium with ambient temperature of 25°C at the specified current of IZT . ZENER IMPEDANCE (ZZ) DERIVATION: The zener impedance is derived from the 60 Hz voltage, which results when an ac current having an rms value equal to 10% of the dc zener current (I ZT ) is superimposed on IZT . REVERSE LEAKAGE CURRENT (I R): Reverse leakage current is guaranteed and measured at VR as shown on the table. MAXIMUM REGULATOR CURRENT (I ZM): The maximum current shown is based on the maximum voltage of a 5.0% type unit; therefore, it applies only to the B C, or D suffix devices. The actual I ZM for any devices may not exceed the value of 200 milliwatts divided by the actual VZ of the device. MAXIMUM REGULATION FACTOR (? V Z): ? V Z is the maximum difference between Vz at IZT and VZ at IZL measured with the device junction in thermal equilibrium. 5 6 Copyright © 2001 MSCXXXX.PDF 02-12-2001 REV A Microsemi Scottsdale Division 8700 E. Thomas Rd. PO Box 1390, Scottsdale, AZ 85252 USA, (480) 941-6300, Fax: (480) 947-1503 Page 1 MM3Z5518 thru MM3Z5546 SCOTTSDALE DIVISION LOW VOLTAGE AVALANCHE DIODE P RODUCT P REVIEW GRAPHS W WW. Microsemi . COM Pd MAXIMUM DISSIPATION 500 100 400 Typical Capacitance in pF 60 40 300 200 20 100 10 8 0 25 50 75 100 125 150 175 200 TL Lead Temperature (°C) 4 POWER-TEMPERATURE DERATING CURVE 2 1 0 20 40 60 80 100 120 140 160 180 200 220 Zener Voltage CAPACITANCE VS. ZENER VOLTAGE (TYPICAL) VZ ? VZ REVERSE VOLTAGE (VOLTS) IZL IZT IR @ VR IZ (mA) VF (VOLTS) IF (mA) FORWARD CHARACTERISTIC GRAPHS REVERSE CHARACTERISTIC IZM ZENER DIODE CHARACTERISTICS AND SYMBOL IDENTIFICATION Copyright © 2001 MSCXXXX.PDF 02-12-2001 REV A Microsemi Scottsdale Division 8700 E. Thomas Rd. PO Box 1390, Scottsdale, AZ 85252 USA, (480) 941-6300, Fax: (480) 947-1503 Page 2