ADF-07

ADF-07 Series 7 Watts Universal Input Range AC/DC Power Modules Single Outputs Key Features High Efficiency up to 78% 85~265VAC, 47~440Hz Universal Input Range I/O Isolation 3000VAC EMI Complies With EN55022 Class B and FCC part 15, level B EMC Complies With EN61000 MTBF > 330,000 Hours UL 60950-1 Safety Approval IEC61140 Safety Class II Approval Operating Temperature 71] (Reference to Derating Curve) ADF-07 is a 7-Watt series of AC-DC power modules. These modules have universal input range of 85-265VAC and are available in output voltages of 3.3V, 5V, 12V, 15V and 24V with efficiency as high as 78%. Other features include continuous short circuit protection, overvoltage protection, output current limitation, EMC EN61000-4(-2,-3,-4) and EMI EN55022 level B approved which conducted noise compliance minimize design-in time, cost and eliminate the need for external components. The ADF-07 series has IEC / EN / UL 60950-1 safety approval qualifies this product for worldwide markets. The series is a wide variety of applications including in commercial and industrial of the MTBF 330,000 hours. ~ 85 265 VAC Universal Voltage OVP Protection 3000 VAC I/O Isolation EMI EN55022 EMC EN61000 Derating Curve 100 80 Output Power (%) 60 40 25% 20 0 -25 ～ 10 20 30 40 50 60 70 Ambient Temperature ] 1 MINMAX REV:10 2008/07 ADF-07 Series Model Selection Guide Model Number Output Voltage Output Current Max. mA 1400 1400 583 466 291 Min. mA 140 140 58 47 29 Input Current 115VAC, 60Hz @Max. Load @No Load mA (Typ.) mA (Typ.) 96 10 139 10 130 10 130 10 130 10 Capacitive Load Max. uF 2200 2200 1000 1000 680 Efficiency @Max. Load % (Typ.) 70 73 78 78 78 ADF-07S03 ADF-07S05 ADF-07S12 ADF-07S15 ADF-07S24 VDC 3.3 5 12 15 24 Environmental Specifications Parameter Operating Temperature Storage Temperature Humidity Cooling Conducted EMI Conditions Ambient Min. Max. -25 71 -40 85 --95 Free-Air Convection EN55022 Class B specification requirement Air {8KV Cont. {4KV 80~1000MHz 10V/m 80% AM1KHz modulation AC port {2KV DC, SL, TL {2KV not less than 1 min. 1.2/50uS(8/20uS) AC dif. {1KV DC {0.5KV 0.15~80MHz 10Vrms (functional earth ports included) 80% AM 1kHz modulation 30% 10ms 60% 100ms 95% 5000ms Unit ] ] % Note : 1. Specifications typical at Ta=+25], resistive load, 115VAC, 60Hz input voltage, rated output current unless otherwise noted. 2. Ripple & Noise measurement bandwidth is 0-20 MHz. 3. These power modules require a minimum output loading to maintain specified regulation. 4. Operation under no-load conditions will not damage these devices; however they may not meet all listed specifications. 5. All AC/DC modules should be externally fused at the front end for protection. A 6. Other input and output voltage may be available, please contact factory. 7. Specifications subject to change without notice. B Standard EN61000-4-2 Performance Criteria B EN61000-4-3 EN61000-4-4 Conducted EMC EN61000-4-5 B EN61000-4-6 B EN61000-4-11 B C C General Specifications Parameter Isolation Voltage Isolation Test Voltage Isolation Resistance Switching Frequency Hold-up Time MTBF 115VAC, 60Hz MIL-HDBK-217F @ 25], Ground Benign Conditions Input to Output, 60 Seconds Input to output, Flash Tested for 1 Second 500VDC Min. 3000 4700 100 ----330 Typ. ------100 15 --Max. ------------Unit VAC VDC M[ KHz ms K Hours REV:10 2008/07 MINMAX 2 ADF-07 Series Input Fuse All Models External Fuse (Recommended) 1.5A Slow - Blow Type Input Specifications Parameter Input Voltage Range Input Frequency Range Inrush Current (Cold Start at 25]) Conditions All Models 115VAC 230VAC Min. 85 47 ----Typ. --------Max. 265 440 10 20 Unit VAC Hz A A Output Specifications Parameter Output Voltage Accuracy Line Regulation Load Regulation Ripple & Noise (20MHz) Over Voltage Protection Temperature Coefficient Overshoot Current limitation Short circuit protection 85VAC, Hiccup technique, auto-recovery Vin=Min. to Max. Iout=Min. to Max. 3.3 & 5.0VDC Output Models Other Output Models Zener diode clamp Conditions Min. ----------------105 Typ. {1.0 {0.5 {0.5 1.5 0.8 120 {0.01 ----Max. {2.0 {1.0 {1.0 1.8 1.0 --{0.02 5.0 --Unit % % % %Vpp of Vo %Vpp of Vo % of Vo %/] % % Hiccup mode, indefinite (automatic recovery) Block Diagram Single Output L EMI Filter and Inrush Current Limiter Rectifier Switching Device Rectifier OVP -Vo Control Circuit Isolation Ref.Amp +Vo N 3 MINMAX REV:10 2008/07 ADF-07 Series Mechanical Dimensions Pin Connections Pin 19.3 [0.76] 10.16 [0.400] 6.00 [0.236] 0.5 [0.02] Single Output AC(N) - AC Neutral AC(L) - AC Line +Vout -Vout 1 2 3 4 45.72 [1.800] 50.8 [2.00] 1.00[ 0.039] 4 3 Bottom Side Physical Characteristics Case Size : 50.8*25.4*19.3 mm 2.00*1.00*0.76 inches 2 1 5.0 [0.20] Case Material 2.54 [0.100] : Plastic resin + Fiberglass : 44 g : UL94V-0 20.32 [0.800] 25.4 [1.00] Weight Flammability Tolerance Millimeters X.X{0.5 X.XX{0.25 Inches X.XX{0.02 X.XXX{0.01 {0.004 Pin {0.1 REV:10 2008/07 MINMAX 4