AQF-30D512

AQF-30 Series 30 Watts Universal Input Range AC/DC Power Modules Single, Dual and Triple Outputs Key Features High Efficiency up to 80% 85~265VAC, 47~440Hz Universal Input Range Single, Dual and Triple Output Modules PCB and Chassis Mounting Packages I/O Isolation 3000VAC EMI Complies With EN55022 Class B and FCC part 15, level B EMC Complies With EN61000 MTBF > 250,000 Hours UL 60950-1 Safety Approval IEC61140 Safety Class II Approval Operating Temperature 71] (Reference to Derating Curve) AQF-30 is a 30-Watt series of AC-DC power modules. These modules have universal input range of 85-265VAC and are available in 13 models with efficiency as high as 80%. Other features include continuous short circuit protection, overvoltage protection, output current limitation, EMC EN61000-4(-2,-3,-4) and EMI EN55022 level B approved which conducted noise compliance minimize design-in time, cost and eliminate the need for external components. The AQF-30 series has IEC / EN / UL 60950-1 safety approval qualifies this product for worldwide markets. The series is a wide variety of applications including in commercial and industrial of the MTBF 250,000 hours. ~ 85 265 VAC Universal Voltage OVP Protection 3000 VAC I/O Isolation EMI EN55022 EMC EN61000 Derating Curve 100 80 Output Power (%) 60 40 25% 20 0 -25 ～ 10 20 30 40 50 60 70 Ambient Temperature ] 1 MINMAX REV:14 2008/08 AQF-30 Series Model Selection Guide Model Number Output Voltage Max. mA 6000 2500 2000 1250 625 {1300 {1000 3000 1250 3000 600 -600 3000 1000 -250 3000 500 -500 4500 1000 250 4000 1500 250 Output Current Min. mA 600 250 200 125 63 {130 {100 300 125 600 120 -120 600 200 -50 300 50 -50 900 220 50 800 300 50 note 8) Peak mA --------------4500 1800 4500 900 900 4500 1500 500 4500 750 750 6000 1500 500 5300 2000 500 Capacitive Load Max. uF 8000 3900 3900 1500 1000 # 1500 # 1500 3900 1500 2200 1500 1500 2200 1500 1500 2200 1500 1500 2200 2200 1500 2200 2200 1500 Input Current 115VAC, 60Hz @Max. Load @No Load mA (Typ.) mA (Typ.) 557 60 543 60 543 60 543 60 543 60 565 60 543 60 572 60 Efficiency @Max. Load % (Typ.) 78 80 80 80 80 80 80 76 AQF-30S05 AQF-30S12 AQF-30S15 AQF-30S24 AQF-30S48 AQF-30D12 AQF-30D15 AQF-30D512 AQF-30T512 AQF-30T512A AQF-30T515 AQF-30T5312P AQF-30T3512P VDC 5 12 15 24 48 {12 {15 ＊5 ＊12 ＊5 12 -12 ＊5 12 -12 ＊5 15 -15 ＊5 +3.3 +12 ＊3.3 +5 +12 572 60 76 572 60 76 572 60 76 588 60 71 483 60 71 ＊Output floating (see # For each output REV:14 2008/08 MINMAX 2 AQF-30 Series Environmental Specifications Parameter Operating Temperature Storage Temperature Humidity Cooling Conducted EMI Standard EN61000-4-2 Conditions Ambient Min. -25 -40 --Max. 71 85 95 Unit ] ] % 1. Specifications typical at Ta=+25], resistive load, 115VAC, 60Hz input voltage, rated output current unless otherwise noted. 2. Ripple & Noise measurement bandwidth is 0～20 MHz. 3. These power modules require a minimum output loading to maintain specified regulation. 4. Operation under no-load conditions will not damage these devices; however they may not meet all listed specifications. 5. Other input and output voltage may be available, please contact factory. A 6. Specifications subject to change without notice. 7. Peak current can’ t be drawn from all output at the same time. 8. Floating (or isolated) output of a power supply that is not connected to any other output. 9. To order the power module with chassis mounting style, please add a suffix C (e.g. AQF-30S05C). 10. Part Number for DIN-Rail bracket: AC-DIN-02 Note: Free-Air Convection EN55022 Class B specification requirement Air {8KV Cont. {4KV 80~1000MHz 10V/m 80% AM1KHz modulation AC port {2KV DC, SL, TL {2KV not less than 1 min. 1.2/50uS(8/20uS) AC dif. {1KV DC {0.5KV 0.15~80MHz 10Vrms (functional earth ports included) 80% AM 1kHz modulation 30% 10ms 60% 100ms 95% 5000ms Performance Criteria B EN61000-4-3 EN61000-4-4 Conducted EMC EN61000-4-5 B B EN61000-4-6 B EN61000-4-11 B C C 3 MINMAX REV:14 2008/08 AQF-30 Series Input Specifications Parameter Input Voltage Range Input Frequency Range Inrush Current (Cold Start at 25]) Conditions All Models 115VAC 230VAC Min. 85 47 ----Typ. --------Max. 265 440 20 40 Unit VAC Hz A A Output Specifications Parameter Output Voltage Accuracy Line Regulation Conditions Single / Dual Output Dual Positive / Triple Output Vin=Min. to Max. Single Output Models Load Regulation Iout=Min. to Max. Dual Output Models Triple Output Models Cross RegulationDual Positives / Triple Output Ripple & Noise (20MHz) Over Voltage Protection Temperature Coefficient Overshoot Current Limitation Short Circuit Protection 85VAC, Hiccup technique, auto-recovery Vo1 Vo2 Vo3 Vo1 Vo2&Vo3 Vo1 Vo2&Vo3 Min. --------------------------------105 Typ. {1.0 {1.0 {3.0 {0.2 {0.5 {2.5 {2.5 {4.0 {2.0 {5.0 {5.0 1.5 1.0 120 {0.02 ----Max. {2.0 {2.0 --{1.0 {1.0 {5.0 {5.0 --------1.8 1.3 ----5 --Unit % % % % % % % % % % % %Vpp of Vo %Vpp of Vo % of Vo %/] % % Measured output Io = 20% to 100% of rated load Other output are set at 50% of rated load 3.3 & 5.0VDC Output Models Other Output Models Zener diode clamp Hiccup mode, indefinite (automatic recovery) General Specifications Parameter Isolation Voltage Isolation Test Voltage Isolation Resistance Switching Frequency Hold-up Time MTBF 115VAC, 60Hz MIL-HDBK-217F @ 25], Ground Benign Conditions Input to Output, 60 Seconds Input to Output, Flash Tested for 1 Second 500VDC Min. 3000 4700 100 ----250 Typ. ------100 20 --Max. ------------Unit VAC VDC M[ KHz ms K Hours Input Fuse All Models Built-in Fuse External Fuse (Recommended) 3.5A / 250VAC 1.5A Slow - Blow Type REV:14 2008/08 MINMAX 4 AQF-30 Series Block Diagram Single Output L EMI Filter and Inrush Current Limiter Rectifier Switching Device Rectifier OVP +Vo N Fuse -Vo Isolation Ref.Amp Control Circuit Dual Output 1 L EMI Filter and Inrush Current Limiter Rectifier Switching Device Rectifier Control Circuit Isolation Ref.Amp Rectifier +Vo OVP Com. OVP N Fuse -Vo Dual Output 2 Rectifier OVP +Vo1 -Vo1 L EMI Filter and Inrush Current Limiter Rectifier Switching Device Rectifier OVP +Vo2 -Vo2 N Fuse Control Circuit Isolation Ref.Amp Triple Output 1 Rectifier OVP +Vo1 L EMI Filter and Inrush Current Limiter Rectifier Switching Device Rectifier -Vo1 +Vo2 OVP N Fuse Com. OVP Rectifier Control Circuit Isolation Ref.Amp -Vo3 Triple Output 2 Rectifier OVP +Vo1 L EMI Filter and Inrush Current Limiter Rectifier Switching Device Rectifier -Vo1 +Vo2 OVP N Fuse Com. OVP Rectifier Control Circuit Isolation Ref.Amp +Vo3 5 MINMAX REV:14 2008/08 AQF-30 Series Mechanical Dimensions PCB mounting 21.5 [0.85] 6.0 [0.24] 0.5 [0.02] Pin Connections Pin 1 2 3 4 5 6 7 81.30 [3.200] Single Output Dual Dual Triple Output1 Output2 Output1 AC(N) - AC Neutral AC(L) - AC Line +Vout Common -Vout +Vout2 +Vout1 -Vout1 NC +Vout2 +Vout1 -Vout1 -Vout3 Triple Output2 15.24 [0.600] 12.70 [0.500] 12.70 [0.500] 15.24 [0.600] +Vout -Vout NC +Vout2 +Vout1 -Vout1 +Vout3 No Pin No Pin Bottom 26.75 [1.053] 1.00 [ 0.039] 7 6 5 4 3 -Vout2 Common 2/3 Common 2/3 27.5 [1.08] 88.9 [3.50] Mounting M3.5 Thead Side NC: No Connection Physical Characteristics 31.45 [1.24] 5.0 [0.20] Case Size : 88.9*63.5*21.5 mm 3.50*2.50*0.85 inches Plastic resin + Fiberglass 177g UL94V-0 2 1 55.88 [2.200] 63.5 [2.50] Case Material Weight Flammability : : : Chassis mounting Pin Connections Pin 1 2 3 +Vout NC -Vout NC Common NC -Vout +Vout Single Output Dual Dual Triple Output1 Output2 Output1 AC(N) - AC Neutral AC(L) - AC Line +Vout2 +Vout1 -Vout1 NC +Vout2 +Vout1 -Vout1 -Vout3 +Vout2 +Vout1 -Vout1 +Vout3 Triple Output2 4 x IO3.5 7 5 4 3 Top view 4 2 1 50.0 [1.97] 63.8 [2.51] 6 5 6 7 -Vout2 Common 2/3 Common 2/3 NC: No Connection 100.0 [3.94] 112.0 [4.41] Physical Characteristics 10.0 [0.39] 92.0 [3.62] Case Size 5.0 [0.20] : 112.0*63.8*25.6 mm 4.41*2.51*1.01 inches Plastic resin + Fiberglass 191g UL94V-0 16.8 [0.66] 25.6 [1.01] Case Material Weight Flammability : : : REV:14 2008/08 MINMAX 6 AQF-30 Series DIN-Rail Package Pin Connections Pin Single Output Dual Dual Triple Output1 Output2 Output1 AC(N) - AC Neutral AC(L) - AC Line +Vout NC -Vout NC Common NC -Vout +Vout +Vout2 +Vout1 -Vout1 NC +Vout2 +Vout1 -Vout1 -Vout3 +Vout2 +Vout1 -Vout1 +Vout3 Triple Output2 4 x 3.5 1 2 7 6 5 4 3 3 50.0 [1.97] Top view 2 1 63.8 [2.51] 4 5 6 7 -Vout2 Common 2/3 Common 2/3 100.0 [3.94] 112.0 [4.41] NC: No Connection 10.0 [0.39] 92.0 [3.62] Physical Characteristics 16.8 [0.66] 25.6 [1.01] Case Size : 112.0*63.8*36.6 mm 4.41*2.51*1.44 inches Plastic resin + Fiberglass 245g UL94V-0 5.0 [0.20] Case Material 11.0 [0.43] 3.0 [0.12] : : : Weight Flammability Tolerance Millimeters X.X{0.5 X.XX{0.25 Inches X.XX{0.02 X.XXX{0.01 {0.004 Pin {0.1 7 MINMAX REV:14 2008/08