RA30H4047M1-101

Silicon RF Power Semiconductors ELECTROSTATIC SENSITIVE DEVICE OBSERVE HANDLING PRECAUTIONS RoHS Compliance, 400-470MHz 30W 12.5V, 2 Stage Amp. For MOBILE RADIO DESCRIPTION The RA30H4047M1 is a 30-watt RF MOSFET Amplifier Module for 12.5-volt mobile radios that operate in the 400- to 470-MHz range. The battery can be connected directly to the drain of the enhancement-mode MOSFET transistors. Without the gate voltage (VGG=0V), only a small leakage current flows into the drain and the nominal output signal (Pout=30W) attenuates up to 60 dB. The output power and the drain current increase as the gate voltage increases. The output power and the drain current increase substantially with the gate voltage around 0V(minimum). The nominal output power becomes available at the state that VGG is 4V (typical) and 5V (maximum). At VGG=5V, the typical gate currents are 1mA.This module is designed for non-linear FM modulation, but may also be used for linear modulation by setting the drain quiescent current with the gate voltage and controlling the output power with the input power. FEATURES • Enhancement-Mode MOSFET Transistors (IDD0 @ VDD=12.5V, VGG=0V) • Pout>30W, T>42% @ VDD=12.5V, VGG=5V, Pin=50mW • Broadband Frequency Range: 400-470MHz • Metal shield structure that makes the improvements of spurious radiation simple • Low-Power Control Current IGG=1mA (typ) @ VGG=5V • Module Size: 67 x 19.4 x 9.9 mm • Linear operation is possible by setting the quiescent drain current with the gate voltages and controlling the output power with the input power. BLOCK DIAGRAM 2 3 1 4 5 1 2 3 4 5 RF Input (Pin) Gate Voltage (VGG), Power Control Drain Voltage (VDD), Battery RF Output (Pout) RF Ground (Case) PACKAGE CODE: H2M RoHS COMPLIANCE • RA30H4047M1 is a RoHS compliant product. • RoHS compliance is indicate by the letter “G” after the Lot Marking. • This product include the lead in the Glass of electronic parts and the lead in electronic Ceramic parts. However, it is applicable to the following exceptions of RoHS Directions. 1.Lead in the Glass of a cathode-ray tube, electronic parts, and fluorescent tubes. 2.Lead in electronic Ceramic parts. ORDERING INFORMATION: ORDER NUMBER RA30H4047M1-101 SUPPLY FORM Antistatic tray, 10 modules/tray RA30H4047M1 25 Jun 2010 1/9 ELECTROSTATIC SENSITIVE DEVICE OBSERVE HANDLING PRECAUTIONS Silicon RF Power Semiconductors RoHS COMPLIANCE RA30H4047M1 MAXIMUM RATINGS (Tcase=+25°C, ZG=ZL=50, unless otherwise specified) SYMBOL PARAMETER VDD VGG Pin Pout Tcase(OP) Tstg Drain Voltage Gate Voltage Input Power Output Power Operation Case Temperature Range Storage Temperature Range CONDITIONS VGG