0039000334

12 11 10 9 7 8 5 6 4 3 2 1 H H C L ALTERNATE TIP GEOMETRY SEE NOTE 7 G G 0.5 MAX "A" 1.42 - 1.50 2.08 ±0.08 GAP ACCEPTABLE SEE ALTERNATE TIP VIEW F 3.20 ±0.25 2.45 F 0.81 ±0.25 1.78 2.03 ±0.25 R0.76 ±0.25 16.8 3.18 ±0.25 2.67 ±0.25 E "B" "B" SECT. "B-B" 1.97 - 2.47 2.03 ±0.25 1.17 ±0.25 "C" E 3.18 1.52 ±0.25 "C" D D 3.56 9.525 ±0.25 "A" 0.5 MAX CHAIN FORM SCALE: 4:1 CL R1.14 ±0.25 SECT. "A-A" SECT. "C-C" C B C NOTES: 1. MATERIAL: BRASS 2. FINISH: SEE CHART 3. PRODUCT SPECIFICATION: PS-02-06 4. PACKAGING INFORMATION: 15610000-PK 5. TERMINAL FOR USE WITH (1.57)/.062 DIA. SERIES HOUSINGS AND WILL ACCEPT 18 THRU 24 AWG WIRE WITH 1.5/3.1 INSULATION DIA. 6. PARTS CONFORM TO CLASS B REQUIREMENTS OF COSMETIC SPECIFICATION PS-45499-002. 7. TIP GEOMETRY IS TOOL DEPENDENT. EITHER GEOMETRY IS ACCEPTABLE. B SYMBOLS = 0 = 0 = 0 A P1 RELEASE DATE 11 2020/06/05 10 20:49:08 C 9 8 7 6 mm 8:1 = 0 4 PLACES ± = 0 3 PLACES ± = 0 2 PLACES ± = 0 CURRENT REV DESC: UPDATE GRAPHICS, REMOVE 1561G AND GL GENERAL TOLERANCES (UNLESS SPECIFIED) ± = 0 DOCUMENT STATUS 12 SCALE ANGULAR TOL = 0 FORMAT: master-tb-prod-C REVISION: H DATE: 2018/01/18 THIS DRAWING CONTAINS INFORMATION THAT IS PROPRIETARY TO MOLEX ELECTRONIC TECHNOLOGIES, LLC AND SHOULD NOT BE USED WITHOUT WRITTEN PERMISSION DIMENSION UNITS 1 PLACE ± 0 PLACES ± ° DRAFT WHERE APPLICABLE MUST REMAIN WITHIN DIMENSIONS 5 EC NO: 632666 2019/03/06 2020/02/26 2020/06/05 DRWN: MKIPPER CHK'D: DSTEIER APPR: FSMITH INITIAL REVISION: DRWN: YAOYAGI APPR: NUKITA THIRD ANGLE PROJECTION 4 .062 DIA CRIMP FEMALE TERMINAL PRODUCT CUSTOMER DRAWING DOC TYPE DOC PART REVISION DOCUMENT NUMBER 2009/02/16 2009/02/17 DRAWING SERIES C-SIZE 1561 3 1 SD-1561-001 MATERIAL NUMBER PSD 001 CUSTOMER SEE CHART 2 M SHEET NUMBER GENERAL MARKET 1 OF 1 1 A