0190730309

PRODUCT SPECIFICATION COSMETIC SPECIFICATION 1.0 SCOPE This applies to all TBO products. 2.0 PURPOSE To define acceptability criteria for cosmetic issues 3.0 REFERENCE MATERIAL NUMBERS This applies to all TBO products. 4.0 DEFINITIONS Not applicable. 5.0 PROCEDURES Color: The use of color in the plastic component of connectors is for product identification only and not for aesthetic purposes. Lot-to-lot shade variations are acceptable and do not affect the form, fit, or function of the connectors. The specification only specifies the color, not the shade of the color. Color is considered a reference specification with no additional specific requirements. Plating Appearance: Matte tin: Matte tin has a dull, non-reflective surface that varies in color from ash-white to mid-gray. Lot-to-lot shade variations are acceptable and do not affect the form, fit, or function of the connectors. Matte tin is inherently soft and susceptible to handling damage that can cause superficial blemishes which are easily seen by the naked eye due to non-reflective surface. Superficial blemishes do not affect the form, fit, or function of the connectors. Exposed copper up to 3% of the entire part is to be considered acceptable and does not affect the form, fit, or function of the connector. o Example shown below for PN: B-118-38 Accelerated Salt-Spray Test (5% Mixture). Exposed area did not show accelerated corrosion As-Received REVISION: A1 ECR/ECN INFORMATION: EC No: 635275 DATE: 2020 / 4 / 2 DOCUMENT NUMBER: PS-19902-011 TITLE: After 96hrs COSMETIC SPECIFICATION TBO PRODUCTS SHEET No. 1 of 1 CREATED / REVISED BY: CHECKED BY: APPROVED BY: ETHRODAHL/ DMYRICK JHACKNEY JMACNEIL TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC