0520041110

10 9 8 7 5 6 4 3 2 1 F F E E D D C C B B THIS DRAWING CONTAINS INFORMATION THAT IS PROPRIETARY TO MOLEX ELECTRONIC TECHNOLOGIES, LLC AND SHOULD NOT BE USED WITHOUT WRITTEN PERMISSION DIMENSION UNITS SCALE mm 5:1 CURRENT REV DESC: GENERAL TOLERANCES (UNLESS SPECIFIED) MM GENERAL TOLERANCES (UNLESS SPECIFIED) A 10 10 OVER DOCUMENT STATUS FORMAT: Met-lega-master-tb-prod-A3 REVISION: D DATE: 2018/01/18 10 P1 RELEASE DATE 9 2020/01/16 30 OVER 06:07:08 8 7 6 ±0.2 UNDER 5 30UNDER ±0.25 ±0.3 INCH 4 PLACES ± ± 3 PLACES ± ± 2 PLACES ± ± ± ± 0 PLACES ± ± 1 PLACE ANGULAR TOL ± 3.0 ° DRAFT WHERE APPLICABLE MUST REMAIN WITHIN DIMENSIONS 4 EC NO: 628958 DRWN: AKUMAR19 CHK'D: GGA APPR: GGA INITIAL REVISION: DRWN: SKUNISHI APPR: MFUKUSHIMA THIRD ANGLE PROJECTION 2019/04/11 2020/01/16 2020/01/16 PRODUCT CUSTOMER DRAWING DOC TYPE DOC PART REVISION DOCUMENT NUMBER 1986/08/27 1993/01/18 DRAWING SERIES A3-SIZE 52004 3 1.5 WIRE TRAP CONN. SD-52004-XX10 MATERIAL NUMBER PSD 001 CUSTOMER GENERAL MARKET SEE TABLE 2 G SHEET NUMBER 1 OF 2 1 A 10 9 8 7 5 6 4 3 2 1 F F E E D D C C B B THIS DRAWING CONTAINS INFORMATION THAT IS PROPRIETARY TO MOLEX ELECTRONIC TECHNOLOGIES, LLC AND SHOULD NOT BE USED WITHOUT WRITTEN PERMISSION DIMENSION UNITS SCALE mm 5:1 CURRENT REV DESC: GENERAL TOLERANCES (UNLESS SPECIFIED) MM GENERAL TOLERANCES (UNLESS SPECIFIED) A 10 10 OVER DOCUMENT STATUS FORMAT: Met-lega-master-tb-prod-A3 REVISION: D DATE: 2018/01/18 10 P1 RELEASE DATE 9 2020/01/16 30 OVER 06:07:08 8 7 6 ±0.2 UNDER 5 30UNDER ±0.25 ±0.3 INCH 4 PLACES ± ± 3 PLACES ± ± 2 PLACES ± ± ± ± 0 PLACES ± ± 1 PLACE ANGULAR TOL ± 3.0 ° DRAFT WHERE APPLICABLE MUST REMAIN WITHIN DIMENSIONS 4 EC NO: 628958 DRWN: AKUMAR19 CHK'D: GGA APPR: GGA INITIAL REVISION: DRWN: SKUNISHI APPR: MFUKUSHIMA THIRD ANGLE PROJECTION 2019/04/11 2020/01/16 2020/01/16 PRODUCT CUSTOMER DRAWING DOC TYPE DOC PART REVISION DOCUMENT NUMBER 1986/08/27 1993/01/18 DRAWING SERIES A3-SIZE 52004 3 1.5 WIRE TRAP CONN. SD-52004-XX10 MATERIAL NUMBER PSD 001 CUSTOMER GENERAL MARKET SEE TABLE 2 G SHEET NUMBER 2 OF 2 1 A