0622025240

zQSFP+ Multi-Port Connector Tooling 2-by-1 zQSFP+ Insertion Tool Application Tooling Specification Sheet Order No. 62202-5240 FEATURES Lightweight tool used in the insertion of a zQSFP+ connector in a PCB Inserts connector to a PCB without damage to the board Use tool 62203-0390 for removing connectors SCOPE Products: Quad Small Form-factor Pluggable zQSFP+ Cage Assembly, 2-by 1 Multi-Port Connector, 2 Press Fit Rear Legs, Elastomeric Gasket for SAN Applications. Series No. 171565 171722 171565-1001 171722-1001 Connector Order No. 171565-1002 171565-1003 171722-1002 171722-1003 171565-7102 171722-1062 Notes: 1. See the following pages for tooling operation instructions. 2. These tools require a “Keep Out Zone” around the connector free of components. The rear of the connector should be .197” (5.0mm). The right and left sides should be .14” (3.5mm). See Figure 1. zQSFP CONNECTOR ASSEMBLY 5.0mm MINIMUM PCB 3.5mm MINIMUM (BOTH SIDES) Figure 1 KEEP OUT ZONE Doc. No: ATS-622025240 Revision: C Release Date: 10-11-13 Revision Date: 02-10-17 UNCONTROLLED COPY Page 1 of 2 zQSFP+ Multi-Port Connector Tooling Description The following instructions are used for inserting the 2 by 1 connector into a PCB. INSERTION TOOL OVER CONNECTOR ASSEMBLY Operation INSERTION TOOL 1. Place a connector assembly on Figure 2 (CLOSED END) the PCB. 2. Place the tool on the connector assembly (closed end to the back end of the connector). See Figure 2. 3. Place tool, connector, and QSFP BOTTOM OF PCB, in a press of suitable size CONNECTOR PCB CONNECTOR TO ASSEMBLY and force, and seat the SEAT FLUSH ON PCB connector assembly as shown. The support plate (furnished by the customer) under the PCB must have clearance for the connector pins as they pass through the PCB. SIDE PLATE Clearance 1.0mm CLEARANCE BETWEEN BOARD AND THE SIDE PLATE AFTER QSFP ASSEMBLY IS SEATED ONTO THE PCB PCB Figure 3 Use this tool only with a press that has a predetermined shut height when seating a QSFP Assembly on a PCB. See figure 3. Allowing the Press-In Tool to stop on the board will result in damage the QSFP cage and terminals being over seated. CAUTION: Molex application tooling specifications are valid only when used with Molex connectors and tooling. Application Tooling Support Phone: +1-402-458-TOOL (8665) E-Mail: applicationtooling@molex.com Website: www.molex.com/applicationtooling Doc. No: ATS-622025240 Revision: C Release Date: 10-11-13 Revision Date: 02-10-17 UNCONTROLLED COPY Page 2 of 2