0622025260

zQSFP+ Multi-Port Connector Tooling 2-by-2 zQSFP+ Insertion Tool Application Tooling Specification Sheet Order No. 62202-5260 FEATURES Lightweight tool used in the insertion of a zQSFP+ connector in a PCB Inserts connector to a PCB without damage to the board Use tool 62202-5220 for removing connectors PCB support not included (furnished by customer) SCOPE Products: zQuad Small Form-factor Pluggable Plus (zQSFP+) Cage Assembly, with Elastomeric Gasket or Metal EMI Gasket, 2 by 2 Enhanced EMI Cage Construction. Connector Series No. Connector Order No. 171565 171565-0001 171565-0002 171565-0003 171565-2001 171565-2002 171565-2003 171722 171722-2001 171722-2002 171722-2003 171722-2062 Notes: 1. See the following pages for tooling operation instructions. 2. These tools require a “Keep Out Zone” around the connector free of components. The right and left sides should be .138” (3.5mm). The rear of the connector should be .197” (5.0mm). See Figure 1. zQSFP+ CAGE ASSEMBLY 5mm MINIMUM PCB 3.5mm MINIMUM (BOTH SIDES) Doc. No: ATS-622025260 Revision: C Release Date: 10-25-13 Revision Date: 02-10-17 Figure 1 KEEP OUT ZONE UNCONTROLLED COPY Page 1 of 2 zQSFP+ Multi-Port Connector Tooling Description INSERTION TOOL OVER CONNECTOR ASSEMBLY The following instructions are used for inserting the 2 by 2 connector into a PCB. Operation INSERTION TOOL (CLOSED END) 1. Place a connector assembly on the PCB. 2. Place the tool on the connector PCB assembly (closed end to the back Figure 2 zQSFP+ end of the connector). See Figure 2. CONNECTOR 3. Place tool, connector, and PCB, in a BOTTOM OF CONNECTOR ASSEMBLY press of suitable size and force, and TO SEAT FLUSH ON PCB seat the connector assembly as shown. The support plate (furnished by the customer) under the PCB must have clearance for the connector pins as they pass through the PCB. SIDE PLATE Figure 3 Clearance 1.0mm CLEARANCE BETWEEN BOARD AND THE SIDE PLATE AFTER zQSFP+ ASSEMBLY IS SEATED ONTO THE PCB PCB Use this tool only with a press that has a predetermined shut height when seating a zQSFP+ Assembly on a PCB. See figure 3. Allowing the Press-In Tool to stop on the board will result in damage the zQSFP+ cage and terminals being over seated. CAUTION: Molex application tooling specifications are valid only when used with Molex connectors and tooling. Application Tooling Support Phone: +1-402-458-TOOL (8665) E-Mail: applicationtooling@molex.com Website: www.molex.com/applicationtooling Doc. No: ATS-622025260 Revision: C Release Date: 10-25-13 Revision Date: 02-10-17 UNCONTROLLED COPY Page 2 of 2