0622035240

zQSFP+ Multi-Port Connector Tooling 2-by-3 zQSFP+ Insertion Tool Application Tooling Specification Sheet Order No. 62203-5240 FEATURES Lightweight tool used in the insertion of a zQSFP+ connector in a PCB Inserts connector to a PCB without damage to the board Use tool 62202-5230 for removing connectors PCB support not included (furnished by customer). SCOPE Products: zQuad Small Form-factor Pluggable Plus (zQSFP+) Cage Assembly, with Elastomeric Gasket or Metal EMI Gasket, 2 by 3 Enhanced EMI Cage Construction. Connector Series No. Connector Order No. 171233 171233-0002 171233-0003 171233-0004 Notes: 1. See the following pages for tooling operation instructions. 2. These tools require a “Keep Out Zone” around the connector free of components. The right and left sides should be 4.5mm (.17”) and the rear of the connector should be 5.0mm (.197”). See Figure 1. zQSFP+ CAGE ASSEMBLY 5.0mm MINIMUM Figure 1 PCB 4.5mm MINIMUM (BOTH SIDES) Doc. No: ATS-622035240 Revision: A Release Date: 10-31-13 Revision Date: 10-31-13 KEEP OUT ZONE UNCONTROLLED COPY Page 1 of 2 zQSFP+ Multi-Port Connector Tooling Description INSERTION TOOL OVER CONNECTOR ASSEMBLY The following Instructions are used for inserting the 2 by 3 connector into a PCB. Operation 1. Place a connector assembly on the PCB. 2. Place the tool on the connector assembly (closed end to the back end of the connector). See Figure 2. 3. Place tool, connector, and PCB, in a press of suitable size and force, and seat the connector assembly as shown. The support plate (furnished by the customer) under the PCB must have clearance for the connector pins as they pass through the PCB. INSERTION TOOL (CLOSED END) zQSFP+ CONNECTOR ASSEMBLY PCB BOTTOM OF CONNECTOR TO SEAT FLUSH ON PCB Figure 2 SIDE PLATE Clearance Use this tool only with a press that has a pre-determined shut height when seating a QSFP Assembly on a PCB. See figure 3. Allowing the Press-In Tool to stop on the board will result in damage the QSFP cage and terminals being over seated. 1.0mm CLEARANCE BETWEEN BOARD AND THE SIDE PLATE AFTER zQSFP+ ASSEMBLY IS SEATED ONTO THE PCB PCB Figure 3 CAUTION: Molex application tooling specifications are valid only when used with Molex connectors and tooling. CAUTION: Molex application tooling specifications are valid only when used with Molex connectors and tooling. Contact Information For more information on Molex application tooling please contact Molex at 1-800-786-6539. Visit our Web site at http://www.molex.com Doc. No: ATS-622035240 Revision: A Release Date: 10-31-13 Revision Date: 10-31-13 UNCONTROLLED COPY Page 2 of 2