0638132450

Extractor Tool for 0.6mm (.02") CP Crimp Terminals Extractor Tool HD-50423-1 Application Tooling Specification Sheet Order No. 63813-2450 FEATURES
This Extractor Tool is for the removal of 64322 Series female terminals from CMC connector. SCOPE Products: 0.6mm (.02") CP Crimp Female Terminal for Power CMC Receptacle. Terminal Series No. 64322 Terminal Order No. Housing Series No. 64322-1019 64322-1229 64318, 64319, 64326, 64322-1029 64322-1319 64320 and 64321 64322-1219 64322-1329 OPERATION: When removing a damaged crimped wire from the CMC connector follow the steps below: 1. The secondary lock on the CMC connector will need to be opened first. See Figure 1. 2. Using a screwdriver insert the flat edge under the tab of the secondary lock and pull up. Use your fingers to open the lock completely. SECONDARY LOCK WIRE SCREWDRIVER Figure 1 Doc No: ATS-638132450 Revision: A CMC CONNECTOR Release Date: 07-01-10 Revision Date: 07-01-10 UNCONTROLLED COPY Page 1 of 2 Extractor Tool for 0.6mm (.02") CP Crimp Terminals 3. Position the blades of the extraction tool into the two small cavities of the slot in the front face of the housing as shown in Figure 2. Use the identifying markings on both the front and back of the connector to locate the opening used to extract the crimped wire. CRIMPED WIRE SECONDARY LOCK OPEN MARKINGS ON BACK AND FRONT OF HOUSING PUSH EXTRACTOR TOOL INTO FRONT FACE Figure 2 ORIENT BLADES INTO HOUSING CAVITIES 4. Push extractor tool into the desired slot until it clicks or comes to a stop. Do not force the extractor tool any further or there can be damage to the housing. 5. Gently push the wire forward towards the housing and then pull out of the CMC housing. 6. Molex does not offer repair parts for Extractor Tools due to the inexpensive nature of these tools. http://www.molex.com Doc No: ATS-638132450 Revision: A Release Date: 07-01-10 Revision Date: 07-01-10 UNCONTROLLED COPY Page 2 of 2