0638241900

Unlocking Tool for CMX Receptacle Crimp Terminal Unlocking Tool Application Tooling Specification Sheet Order No. 63824-1900 FEATURES This Tool is for locking and unlocking the TPA from a 70 Way CMX or Euro6 Connector. SCOPE Products: CMX Receptacle Connectors Connector Series No. 34820 34820-0111 34820-0121 34820-0112 34820-0122 Connector Order No. 34820-0113 34820-0114 34820-0123 34820-0124 34820-0115 34820-0125 34820-0116 34820-0126 Unlocking and Opening the (TPA) Secondary Lock For the CMX receptacle assembly, follow the steps below: 1. Insert the tool into the (2) side slots of the (TPA) secondary lock on each sides until it stops. See Figure 1. The (2) two catch pivots on the sides of the tool will engage the TPA. 2. Push on the tool until the TPA contacts with the inside edge of the tool and the locking latches click into place. 3. The tool is now secure on the in the TPA. See Figure 2. 4. Gently push the blade engagement slide “IN” until it is about even with the face of the tool. 5. Still holding the front of the tool, pull out until the TPA stops. 6. Remove the tool and check the position of the TPA. SIDE SLOTS EXTRACTOR TOOL TPA LATCH LOCKING LATCH Figure 1 BLADE ENGAGEMENT SLIDE (SHOWN IN THE “OUT” POSITION) Doc No: ATS-638241900 Revision: C Release Date: 03-29-12 Revision Date: 05-17-13 UNCONTROLLED COPY Page 1 of 2 Unlocking Tool for CMX Receptacle Crimp Terminal TPA LATCH HOLD HERE TO OPEN THE TPA EXTRACTOR TOOL BLADE ENGAGEMENT SLIDE (SHOWN IN THE “IN” POSITION) HOLD HERE TO RELEASE THE TOOL FROM THE CONNECTOR Figure 2 Closing the (TPA) secondary lock On a CMX receptacle assembly, follow the steps below: Secondary lock can be closed manually or during the final connector check. This procedure is done after the insertion of all female terminals. 1. Insert the extractor tool into the (2) side slots of the (TPA) secondary lock on each sides. 2. Pull out with the tool. See Figure 2. 3. Remove the tool and check for placement. Note: One of the functions of the secondary lock (TPA) is to detect if any of the terminals are not fully seated in the cavities. If the secondary lock does not close, reopen the TPA. Push on the terminals one at a time to make sure they are locked in place. Close the secondary lock see step 2 and 3. Check visually the locking latches are in the correct position. Visit our Web site at http://www.molex.com Doc No: ATS-638241900 Revision: C Release Date: 03-29-12 Revision Date: 05-17-13 UNCONTROLLED COPY Page 2 of 2