0733000090

12 11 10 9 8 7 5 6 4 3 2 1 MATERIALS AND FINISHES: H BODY, CENTER CONTACT: BRASS FINISH: GOLD (5 µ-in MIN) OVER NICKEL PHOSPHOR (80 µ-in MIN) H INSULATOR: LCP 1.60 .063 REF G G +0.00 -0.15 +.000 .004 -.006 0.300 ◻ .012 REF 0.10 ⌀ 5.20 REF F F .205 0.50 .020 REF E E ⌀ 3.40 .134 REF D D R/P 4.000 ◻ .157 REF 1.29 ±0.05 .051 ±.002 3.40 REF .134 C 73300-0092 73300-0091 73300-0090 PART NO. C TAPE AND REEL WITH KAPTON TAPE TAPE AND REEL (1500 PCS) SMPM PLUG FULL DETENT INTERFACE (TRAY) DESCRIPTION B MIL- STD-384B, FIG 328-2 INTERFACE B DESCRIPTION SPECIFICATION SYMBOLS = 0 = 0 THIS DRAWING CONTAINS INFORMATION THAT IS PROPRIETARY TO MOLEX ELECTRONIC TECHNOLOGIES, LLC AND SHOULD NOT BE USED WITHOUT WRITTEN PERMISSION DIMENSION UNITS SCALE MM/IN NTS GENERAL TOLERANCES (UNLESS SPECIFIED) = 0 = 0 = 0 A MM 4 PLACES ± ± 3 PLACES ± ± 2 PLACES ± ± 1 PLACE ± ± = 0 0 PLACES ± ± ANGULAR TOL DOCUMENT STATUS 12 FORMAT: Eng-lega-master-tb-prod-C REVISION: D DATE: 2018/01/18 P1 RELEASE DATE 11 2019/12/05 10 14:20:26 C 9 8 7 6 INCH = 0 = 0 = 0 CURRENT REV DESC: ± DRAFT WHERE APPLICABLE MUST REMAIN WITHIN DIMENSIONS 5 ° EC NO: 627990 DRWN: SSSHAH CHK'D: BSHAH APPR: AROBERTSON INITIAL REVISION: DRWN: JLEE02 APPR: JWIENER THIRD ANGLE PROJECTION 4 SMPM, PLUG VERTICAL PCB 2019/11/22 FULL DETENT, SMT 50 OHM EWR-13431, SMPM-PCB 2019/12/04 2019/12/05 PRODUCT CUSTOMER DRAWING DOC TYPE DOC PART REVISION DOCUMENT NUMBER 2011/08/02 2011/08/08 DRAWING SERIES C-SIZE 73300 3 SD-73300-009 MATERIAL NUMBER CUSTOMER PSD 001 B3 SHEET NUMBER SEE TABLE 1 OF 2 2 1 A 12 11 10 9 7 8 5 6 4 3 2 1 PCB CONNECTOR LAUNCH / PAD (FOR REFERENCE ONLY) H ALL HATCHED SURFACES SHOWN BELOW ARE COPPER (Cu) H REFERENCE LAYER (LAYER 2) MOUNTING & SIGNAL LAYER (LAYER 1) SUBSEQUENT LAYERS ⌀ 2.50 .098 G G 2.05 ±0.13 .081 ±.005 F F 1.85 ±0.13 .073 ±.005 ⌀ 3.10 ±0.13 ⌀ 3.10 ±0.13 .122 ±.005 0.44 .017 IMPEDANCE CONTROLLED DIMENSION 1.40 .055 E E DRILL HOLE DIAMETER .041 ±.005 (DO NOT PLATE) 30° TYP LAYER MATERIAL 1 Copper + PLATING FR4 2 Copper FR4 3 Copper FR4 4* Copper ⌀ 5.20 .205 ⌀ 0.40 Dk THICKNESS (mil) 2.1 4.3 10.0 0.6 4.3 10.0 0.6 4.3 10.0 0.6 .016 TYP .092 0.90 .035 ⌀ 4.00 ±0.13 .157 ±.005 1.00 .039 TYP VSWR (FULLY MATED) FREQUENCY BAND 1.4 DC TO 18 GHz 1.25 .049 0.63 .025 3.25 TYP .128 VARYING PCB STACKUPS AND PCB LAUNCH WILL RESULT IN VARYING RESULTS CONTACT MOLEX RF / MICROWAVE FOR APPLICATION SPECIFIC ASSISTANCE B SYMBOLS = 0 = 0 THIS DRAWING CONTAINS INFORMATION THAT IS PROPRIETARY TO MOLEX ELECTRONIC TECHNOLOGIES, LLC AND SHOULD NOT BE USED WITHOUT WRITTEN PERMISSION DIMENSION UNITS SCALE MM/IN NTS = 0 = 0 A MM 4 PLACES ± ± 3 PLACES ± ± 2 PLACES ± ± 1 PLACE ± ± = 0 0 PLACES ± ± ANGULAR TOL P1 RELEASE DATE 11 2019/12/05 10 14:20:26 C 9 8 7 6 INCH = 0 = 0 = 0 CURRENT REV DESC: GENERAL TOLERANCES (UNLESS SPECIFIED) = 0 DOCUMENT STATUS 12 4.62 .182 C TYPICAL PERFORMANCE CHARACTERISTICS WITH CONNECTOR AND PCB LAUNCH SHOWN FORMAT: Eng-lega-master-tb-prod-C REVISION: D DATE: 2018/01/18 D ⌀ 2.35 * SUBSEQUENT LAYERS MAY BE ADDED AS REQUIRED FOR INDIVIDUAL APPLICATIONS B 4.00 ◻ .157 ⌀ 1.04 ±0.13 PCB STACK UP C SOLDER MASK VIAS AND DRILL HOLE 2.60 .102 IMPEDANCE CONTROLLED DIMENSION D .122 ±.005 ± DRAFT WHERE APPLICABLE MUST REMAIN WITHIN DIMENSIONS 5 ° EC NO: 627990 DRWN: SSSHAH CHK'D: BSHAH APPR: AROBERTSON INITIAL REVISION: DRWN: JLEE02 APPR: JWIENER THIRD ANGLE PROJECTION 4 SMPM, PLUG VERTICAL PCB 2019/11/22 FULL DETENT, SMT 50 OHM EWR-13431, SMPM-PCB 2019/12/04 2019/12/05 PRODUCT CUSTOMER DRAWING DOC TYPE DOC PART REVISION DOCUMENT NUMBER 2011/08/02 2011/08/08 DRAWING SERIES C-SIZE 73300 3 SD-73300-009 MATERIAL NUMBER CUSTOMER PSD 001 B3 SHEET NUMBER SEE TABLE 2 OF 2 2 1 A