0845240016

9 7 8 6 5 4 3 2 1 STRIP MATERIAL FINISH NUMBER 84524-0008 OVERALL NICKEL 80µ" MINIMUM 84524-0016 SELECTIVE HARD GOLD 30µ" MINIMUM OVER NICKEL 50µ" MINIMUM ALL OVER 0.500 REF TYP 12.70 0.250 REF 6.35 E Ø 0.061 REF 1.56 ⌀ 24.0 ±0.5 0.092 REF 2.35 PA D YO FF DI 0.185 REF 4.70 B 610 ±12.0 0.858 REF 21.79 SELECTIVE GOLD PLATING AREA B A A 0.250 REF 6.35 E D RE IO 0.500 REF TYP 12.70 N ⌀ 0.100 C ⌀ 0.750 ±0.2 19.05 ±6.4 B A 0.180 REF 4.56 WIRE INSULATION O.D. RANGE 0.075"-0.130" 1.90-3.30 SYMBOLS = 0 = 0 = 0 9 P1 RELEASE DATE 2018/02/20 8 14:47:37 C 7 6 5 4 SCALE CURRENT REV DESC: UPDATED PIN TIP GENERAL TOLERANCES (UNLESS SPECIFIED) ± 4 PLACES ± = 0 3 PLACES ± = 0 2 PLACES ± = 0 B SECTION B-B CONDUCTOR CRIMP INCH/[mm] 2:1 ANGULAR TOL = 0 C THIS DRAWING CONTAINS INFORMATION THAT IS PROPRIETARY TO MOLEX ELECTRONIC TECHNOLOGIES, LLC AND SHOULD NOT BE USED WITHOUT WRITTEN PERMISSION DIMENSION UNITS = 0 = 0 DOCUMENT STATUS 0.155 REF 3.95 SECTION A-A INSULATION CRIMP NOTES: 1. MATERIAL: COPPER ALLOY .0118/0.300 THICK. 2. FINISH: SEE CHART. 3. STRIP PARTS ARE REELED 3000 PARTS PER REEL AS SHOWN ABOVE. 4. TERMINAL FOR USE ON XRC & ML-XT CONNECTOR ASSEMBLIES. 5. TERMINALS COMPLY WITH SECTION 5.3.2 OF THE SAE J1939-11 STANDARD FOR SURFACE VEHICLE RECOMMENDED PRACTICE. FORMAT: master-tb-prod-A3 REVISION: H DATE: 2018/01/18 REF 0.133 REF 3.38 2.54 0.129 REF 3.27 CT 1 PLACE ± 0 PLACES ± 2.0 ° 0.13 0.2 DRAFT WHERE APPLICABLE MUST REMAIN WITHIN DIMENSIONS EC NO: 168799 DRWN: JFLETCHER CHK'D: JDWALLACE APPR: JDWALLACE INITIAL REVISION: DRWN: JFLETCHER APPR: JALEXANDER THIRD ANGLE PROJECTION 3 2017/11/21 2018/02/12 2018/02/20 PRODUCT CUSTOMER DRAWING DOC TYPE DOC PART REVISION DOCUMENT NUMBER 2016/01/26 2016/02/23 845240020 MATERIAL NUMBER DRAWING SERIES A3-SIZE 84524 2 A XRC PIN TERMINAL 14-18 AWG TW 0.075"-0.130" WIRE Ø SEE CHART PSD 000 B SHEET NUMBER CUSTOMER GENERAL MARKET 1 1 OF 1