2002140100

Multi-Port Connector Tooling 1-by-2 Multi-Port Insertion Tool Application Tooling Specification Sheet Order No. 200214-0100 FEATURES Lightweight tool used in the insertion of a zQSFP+™ cage in a PCB Inserts connector to a PCB without damage to the board . SCOPE Products: Small Form-factor Pluggable zQSFP+™,custom 1-by-2 Multi-Port Connector with Press-fit PC Tails Connector Series No. 100015 Connector Order No. 100015-2547 Notes: 1. See the following pages for tooling operation instructions. 2. These tools require a “Keep Out Zone” around the connector free of components. The rear of the connector should be .200” (5.08mm). The right and left sides should be .080” (2.00mm). See Figure 1. CONNECTOR ASSEMBLY 1.20mm Maximum PCB 1.20mm Maximum (BOTH SIDES) KEEP OUT ZONE Doc. No: ATS-2002140100 Revision: B Release Date: 09-23-16 Revision Date: 09-23-16 Figure 1 UNCONTROLLED COPY Page 1 of 2 Multi-Port Connector Tooling Description The following Instructions are used for inserting the 1 x 2 cage assemblies into a PCB. Operation 1. By hand, place a connector assembly on the PCB. 2. Place the tool on the connector assembly (closed end to the back end of the connector). See Figure 2. 3. Place tool, connector, and PCB, in a press of suitable size and force, and seat the connector assembly shown. The support under the PCB must have clearance for the connector pins if they pass through the PCB Note: The insertion tool does not contact the PCB when the connector is fully seated. INSERTION TOOL INSERTION TOOL OVER CONNECTOR ASSEMBLY CONNECTOR ASSEMBLY Figure 2 BOTTOM OF CONNECTOR TO SEAT FLUSH ON PCB PCB Application Tooling Support 2200 Wellington Court Lisle, IL 60532 USA Phone: +1-402-458-TOOL (8665) E-mail: applicationtooling@molex.com Visit our Website at www.molex.com/applicationtooling Doc. No: ATS-2002140100 Revision: B Release Date: 09-23-16 Revision Date: 09-23-16 UNCONTROLLED COPY Page 2 of 2