2002141183

QSFP-DD Multi-Port Connector Tooling 2-by-1 QSFP-DD Insertion Tool Application Tooling Specification Sheet Order No. 200214-1183 FEATURES   Lightweight tool used in the insertion of a QSFP-DD connector in a PCB Inserts connector to a PCB without damage to the board SCOPE Products: Quad Small Form-factor Pluggable QSFP-DD Cage Assembly, 2-by 1 Multi-Port Connector, 2 Press Fit Rear Legs, Elastomeric Gasket for SAN Applications. Series No. 173604 Connector Order No. 173604-0001 Notes: 1. See the following pages for tooling operation instructions. 2. These tools require a “Keep Out Zone” around the connector free of components. The rear of the connector should be .197” (5.0mm). The right and left sides should be .14” (3.5mm). See Figure 1. QSFP-DD CONNECTOR ASSEMBLY 5.0mm MINIMUM PCB 3.5mm MINIMUM (BOTH SIDES) Doc. No: ATS-2002141183 Revision: A Release Date: 04-14-17 Revision Date: 04-14-17 Figure 1 KEEP OUT ZONE UNCONTROLLED COPY Page 1 of 2 QSFP-DD Multi-Port Connector Tooling Description The following instructions are used for inserting the 2 by 1 connector into a PCB. Operation INSERTION TOOL OVER CONNECTOR ASSEMBLY INSERTION TOOL (CLOSED END) 1. Place a connector assembly on the PCB. 2. Place the tool on the connector assembly (closed end to the back end of the connector). See Figure 2. 3. Place tool, connector, and PCB, in a press of suitable size and force, and seat the connector assembly as shown. QSFP-DD CONNECTOR ASSEMBLY Figure 2 BOTTOM OF CONNECTOR TO SEAT FLUSH ON PCB PCB The support plate (furnished by the customer) under the PCB must have clearance for the connector pins as they pass through the PCB. SIDE PLATE 1.0mm CLEARANCE BETWEEN BOARD AND THE SIDE PLATE AFTER QSFP-DD ASSEMBLY IS SEATED ONTO THE PCB PCB Figure 3 Clearance Use this tool only with a press that has a predetermined shut height when seating a QSFP-DD assembly on a PCB. See figure 3. Allowing the press-in tool to stop on the board will result in damage the QSFP-DD cage and terminals being overseated. CAUTION: Molex application tooling specifications are valid only when used with Molex connectors and tooling. Application Tooling Support Phone: +1-402-458-TOOL (8665) E-Mail: applicationtooling@molex.com Website: www.molex.com/applicationtooling Molex is a registered trademark of Molex, LLC in the United States of America and may be registered in other countries; all other trademarks listed herein belong to their respective owners. Doc. No: ATS-2002141183 Revision: A Release Date: 04-14-17 Revision Date: 04-14-17 UNCONTROLLED COPY Page 2 of 2