WRB2405CS-3W

WRA_CS-3W & WRB_CS-3W Series 3W, WIDE INPUT, ISOLATED & REGULATED DUAL/SINGLE OUTPUT DC-DC CONVERTER m ulti-country patent protection FEATURES Miniature SIP Package Wide (2:1) Input Range Regulated Outputs I/0 Isolation 1500VDC Short Circuit Protection(automatic recovery) Internal SMD construction Operating Temperature: -40°C to +85°C External On/Off control RoHS Compliance RoHS PRODUCT PROGRAM Input Part Number Nominal W RA1205CS-3W W RA1209CS-3W W RA1212CS-3W W RA1215CS-3W W RB1205CS-3W W RB1209CS-3W W RB1212CS-3W 12 9.0-18 22 Voltage (VDC) Range M ax* Voltage (VDC) ±5 ±9 ±12 ±15 5 9 12 15 ±5 ±9 ±12 24 18-36 40 ±15 5 9 12 15 Output Current (mA) Max ±300 ±167 ±125 ±100 600 333 250 200 ±300 ±167 ±125 ±100 600 333 250 200 Min ±30 ±17 ±13 ±10 60 33 25 20 ±30 ±17 ±13 ±10 60 33 25 20 74 76 78 80 74 76 78 80 76 78 80 81 76 78 80 81 Efficiency (%, Typ) APPLICATIONS The WRA_CS-3W & WRB-CS-3W Series are specially designed for applications where a wide range input voltage power supplies are isolated from the input power supply in a distributed power supply system on a circuit board. These products apply to: 1) Where the voltage of the input power supply is wide range (voltage range≤ 2:1); 2) Where isolation is necessary between input and output(Isolation Voltage≤ 1500VDC); 3) Where the regulation of the output voltage and the output ripple noise are demanded. W RB1215CS-3W W RA2405CS-3W W RA2409CS-3W W RA2412CS-3W W RA2415CS-3W W RB2405CS-3W W RB2409CS-3W W RB2412CS-3W W RB2415CS-3W *Input voltage can’t exceed this value, or will cause the permanent damage. Note: The load shouldn't be less than 10%, otherwise ripple will increase dramatically. Operation under 10% load will not damage the converter; However, they may not meet all specification listed. COMMON SPECIFICATION Item Test Conditions Min Typ Max 95 -40 -55 15 1.5mm from case for 10 seconds Tested for 1 minute and 1mA max 1500 Test at 500VDC 100KHz,1V 1000 80 100 Free Air Convection Plastic (UL94-V0) Continuous, Automatic Recovery 1000 6 K hours g 300 VDC MΩ PF mW 85 125 °C Units % MODEL SELECTION WRA1205CS-3W Rated Power Package Style Output Voltage Input Voltage Product Series Storage Humidity Operating Temperature Storage Temperature Temp. Rise at Full Load Lead Temperature Isolation voltage Isolation resistance M ORNSUN Science& Technology co.,Ltd. Address: 2th floor 6th building, Huangzhou I ndustrial District, Guangzhou, China Tel: 86-20-38601850 Fax: 86-20-38601272 Http://www.mornsun-power.com Isolation capacitance No-load Power Consumption Cooling Case Material Short Circuit Protection MTBF W eight MORNSUN reserves the copyright Specifications subject to change without notice. WRA_CS-3W & WRB_CS-3W A/1-2008 Page 1 of 2 OUTPUT SPECIFICATIONS Item Output Power Positive voltage accuracy Test Conditions See below products program Refer to recommended circuit Min 0.3 ±1 ±3 ±0.5 ±0.5 ±0.2 Typ M ax 3 ±3 ±5 ±0.75 ±1.0 ±0.5 ±0.03 50 300 100 %/°C m Vp-p KHz % Units W Recommended circuit If you want to further decrease the input/output ripple, an “LC” filtering network may be connected to the input and output ends of the DC/DC converter, see (Figure 1). Single Output Vc Vi n Cin GND 1 7 Negative voltage accuracy Refer to recommended circuit Load Regulation Line Regulation Temperature drift (Vout) Ripple & Noise** Switching Frequency 10% To 100% Load (WRB_CS-3W) 10% To 100% Load (WRA_CS-3W)* Input Voltage From Low To High Refer To Recommended Circuit 20MHz Bandwidth 100% Load, Input Voltage D1 Ic R 3 Li n 2 6 8 +Vo Co ut 0V Cs * Dual output models unbalanced load (25/100%): ±5%Max. **Test ripple and noise by “parallel cable” method. See detailed operation instructions at Testing of Power Converter section, application notes. Note: 1. All specifications measured at TA=25°C, humidity