E200E

E200E Series Low Cost, 2W Ultra-Miniature SIP DC/DC Converters Input Electrical Specifications Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice. Key Features: • 2W Output Power • Ultra-Miniature SIP Case • Low 0.3” Profile • 1,000 VDC Isolation • >3.5 MHour MTBF • 5V & 12V Inputs • LOWEST COST! Parameter Input Voltage Range Reverse Polarity Input Current Input Filter Output Parameter Output Voltage Accuracy Line Regulation Load Regulation (Note 1) Ripple & Noise (20 MHz) (Note 2) Output Power Protection Temperature Coefficient Output Short Circuit General Parameter Isolation Voltage Isolation Test Voltage Isolation Resistance Isolation Capacitance Switching Frequency Environmental Parameter Operating Temperature Range Operating Temperature Range Storage Temperature Range Cooling Humidity Physical Case Size Case Material Weight Reliability Specifications Parameter MTBF Absolute Maximum Ratings Parameter Input Voltage Surge (1 Sec) Lead Temperature Internal Power Dissipation Conditions 5 VDC Input 12 VDC Input Min. 4.5 10.8 Typ. 5.0 12.0 Max. 5.5 13.2 0.3 Units VDC A Internal Capacitor Conditions For Vin Change of 1% See Model Selection Guide 50 120 ±0.01 Momentary (0.5 Sec.) Conditions 60 Seconds Flash Tested For 1 Sec 1,000 VDC 100 kHz, 1V Min. 1,000 1,100 1,000 60 75 Conditions Ambient Case -55 Free Air Convection RH, Non-condensing 95 % Min. -40 Typ. +25 Max. +85 +90 +125 100 Typ. Max. Units VDC VDC MΩ pF kHz Units °C °C °C ±0.03 75 mV P - P % %/°C Min. Typ. ±1.0 Max. ±3.0 ±1.2 Units % % RoHS Compliant MicroPower Direct 292 Page Street Suite D Stoughton, MA 02072 USA T: (781) 344-8226 F: (781) 344-8481 E: sales@micropowerdirect.com W: www.micropowerdirect.com 0.46 x 0.40 x 0.30 Inches (11.6 x 10.2 x 7.55 mm) Non-Conductive Black Plastic (UL-94V0) 0.06 Oz (1.8g) Conditions MIL HDBK 217F, 25°C, Gnd Benign Conditions 5 VDC Input 12 VDC Input 1.5 mm From Case For 10 Sec All Models Min. 3.5 Min. -0.7 -0.7 Typ. Max. 9.0 18.0 260 650 Typ. Max. Units MHours Units VDC °C mW Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings. Model Selection Guide Model Number E201E E202E E203E E211E E212E E213E Input Output Load Voltage (VDC) Current (mA) Voltage Current Current Regulation Nominal Range Full-Load No-Load (VDC) (mA, Max) (mA, Min) (% Max) 5 4.5 - 5.5 513 38 5.0 400.0 40.0 15 5 5 12 12 12 4.5 - 5.5 4.5 - 5.5 10.8 - 13.2 10.8 - 13.2 10.8 - 13.2 506 506 214 208 206 38 38 20 20 20 12.0 15.0 5.0 12.0 15.0 167.0 133.0 400.0 167.0 133.0 17.0 14.0 40.0 17.0 14.0 15 15 15 15 15 Efficiency (%, Typ) 78 79 79 78 80 81 Fuse Rating Slow-Blow (mA) 1,000 1,000 1,000 500 500 500 Notes: 1. Output load regulation is specified for a load change of 10% to 100%. 2. When measuring output ripple, it is recommended that an external 0.33 µF ceramic capacitor be placed from the +Vout pin to the -Vout pin. 3. These units should not be operated with a load under 10% of full load. Operation at no-load may cause damage to the unit. 4. These converters are specified for operation without external components. However, in some applications the addition of input/ouput capacitors will enhance stability and reduce output ripple. Recommended capacitor values are: Derating Curve Vin 5 VDC 12 VDC Input Capacitor 4.7 µF 2.2 µF Vout 5 VDC 12 VDC 15 VDC Output Capacitor 10.0 µF 2.2 µF 1.0 µF For applications requiring very low output noise levels, a simple LC filter should be effective. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the Model Selection table above for the correct rating. Mechanical Dimensions Pin Connections Pin 1 2 3 4 Description -Vin +Vin -Vout +Vout Notes: • All dimensions are typical in inches (mm) • Tolerance x.xx = ±0.01 (±0.25) • Pin 1 is marked by a “dot” or indentation on the side of the unit MicroPower Direct www.micropowerdirect.com • 292 Page Street Ste D Stoughton, MA 02072 TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropowerdirect.com