MPM-07S-15

MPM-07S Series C Compact 1 x 2 I h t Inch 7W, Single Output AC/DC Power Supplies Key Features: • 7W Output Power • Compact 1 x 2 Inch Case • Universal 85-265 VAC Input • EN60950 Approved • Meets EN55022 B • Meets IEC Safety Class II • >280 kHour MTBF Electrical Specifications Specifications typical @ +25°C, 230 VAC input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice. Input Parameter Input Voltage Range Input Frequency Input Current Inrush Current EMI Safety Ground Leakage Current Conditions Min. Typ. Max. 85 265 47 440 See Model Selection Guide 115 VAC 10.0 230 VAC 20.0 Meets CISPR Pub. 22/FCC Class B 115 VAC 0.1 230 VAC 0.3 Units VAC Hz A Pk mA Units Output Parameter Output Voltage Output Current Output Voltage Accuracy Line Regulation Load Regulation Ripple & Noise (20 MHz) Hold-Up Time Temperature Coefficient Over Voltage Protection Short Circuit Protection, Note 3 Overload Protection, Note 4 Conditions Min. Typ. Max. See Model Selection Guide See Model Selection Guide ±1.0 ±2.0 VIN = Min to Max ±0.5 ±1.0 IO = Min to Max ±0.5 ±1.0 3.3 & 5.0 VDC Output 1.5 1.8 All Other Outputs 0.8 1.0 115 VAC, 60 Hz 15 ±0.02 Zener Diode Clamp 120 Continuous (Autorecovery) Typ. 120% to 180% of Output Power Conditions Input to Output Input to Output, Flash Tested For 60S 500 VDC Conducted Electrostatic Discharge (ESD) RF Field Susceptibility Electrical Fast Transients/Bursts On Mains Surge Min. 3,000 4,700 100 Typ. Max. % % % %VP-P of VO mSec %/°C % of VO General Parameter Isolation Voltage Isolation Test Voltage Isolation Resistance EMI/RFI EMC Compliance Units VAC VAC MΩ EN 55022 Level B IEC/EN 61000-4-2 Level B IEC/EN61000-4-3 IEC/EN 61000-4-4 Level 3 2 kV IEC/EN 61000-4-5 Level 3 1kV/2 kV 100 kHz Units °C °C % MicroPower Direct 292 Page Street Suite D Stoughton, MA 02072 USA T: (781) 344-8226 F: (781) 344-8481 E: sales@micropowerdirect.com W: www.micropowerdirect.com Switching Frequency Environmental Parameter Operating Temperature Range Storage Temperature Range Cooling Humidity Conditions Min. Typ. Max. -25 +25 +71 -40 +85 Free Air Convection (See Derating Curve) RH, Non-condensing 95 Ambient Physical Case Size Case Material Weight 2.00 x 1.00 x 0.76 Inches (50.8 x 25.4 x 19.3 mm) Non-Conductive Plastic& Fiberglass (UL94-V0) 1.55 Oz (44g) Conditions Min. Typ. MIL HDBK 217F, 25°C, Gnd Benign 280 IEN 60950, IEC 60950 IEN 60950, IEC 60950 IEC 61140 Class II Max. Units kHours Reliability Specifications Parameter MTBF Safety Standards Safety Approvals Safety Class Model Selection Guide Model Number MPM-07S-03 MPM-07S-05 MPM-07S-12 MPM-07S-15 MPM-07S-24 Output 1 (Vout 1) Current (A) Voltage 115 VAC 230 VAC (VDC) Max. Min. 0.96 0.139 0.130 0.130 0.130 0.051 0.051 0.051 0.051 0.051 3.3 5.0 12.0 15.0 24.0 1.400 1.400 0.583 0.466 0.291 0.140 0.140 0.058 0.047 0.029 Input Current (A) Efficiency (%, Typ) Fuse Capacitive Rating Load Slow-Blow (µF Max) (mA) 2,200 2,200 1,000 1,000 680 1,500 1,500 1,500 1,500 1,500 70 73 78 78 78 Other outputs may be available Contact the factory for details at: sales@micropowerdirect.com Notes: 1. Load regulation is measured for an output change of 0% to 100% at nominal input line. 2. Operation at no-load will not damage these units. However, they may not meet all specifications. 3. Output short circuit protection is provided by a “hiccup mode” circuit. The unit recovers automatically when the fault condition is removed. 4. Output overload protection is provided by a fold back current limiting circuit. 5. It is recommended that an external slow blow fuse also be used on the input for protection. See the table above for the correct rating. Derating Curve Mechanical Dimensions Pin Connections Pin 1 2 3 4 Function AC-Neutral AC-Line +Vout -Vout MicroPower Direct www.micropowerdirect.com • Notes: Notes: • All dimensio are typical in inches (mm) dimensions • Tolerance x. = ±0.01 (±0.25) olerance x.xx 292 Page Street Ste D Stoughton, MA 02072 TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropowerdirect.com