MPM-25S-24

厂商：
MPD
封装：
描述：
MPM-25S-24 - Universal Input, 25W Miniature, PC Mount AC/DC Power Supplies - MicroPower Direct, LLC

数据手册：

下载MPM-25S-24.pdf

立即购买

详情介绍
数据手册
价格&库存

MPM-25S-24 数据手册

MPM-25S Series Universal Input, 25W Miniature, PC Mount AC/DC Power Supplies Electrical Speciﬁcations Key Features: • 25W Output Power • Universal 85-264 VAC Input • EN 60950 Approved • Adjustable Output • Meets EN55022 B • >200 kHour MTBF • Compact PC Mount Case Speciﬁcations typical @ +25°C, 230 VAC input voltage & rated output current, unless otherwise noted. Speciﬁcations subject to change without notice. Input Parameter Input Voltage Range Input Frequency Input Current Inrush Current EMI Safety Ground Leakage Current Conditions Min. Typ. 85 120 47 See Model Selection Guide 115 VAC 16.0 230 VAC 30.0 Meets CISPR Pub. 22/FCC Class B 115 VAC 230 VAC Max. 264 370 63 Units VAC VDC Hz A Pk 0.1 0.3 Max. mA Units Output Parameter Output Voltage Output Current Output Voltage Accuracy Line Regulation Load Regulation Ripple & Noise (20 MHz) Hold-Up Time Temperature Coefﬁcient Short Circuit Protection Overload Protection Conditions Min. Typ. See Model Selection Guide See Model Selection Guide ±2.0 ±0.5 See Model Selection Guide 50 115 VAC 20 230 VAC 80 ±0.02 Continuous (Autorecovery) Typ. 110% of Output Power Conditions Input to Output Input to Ground Output to Ground Conducted Electrostatic Discharge (ESD) RF Field Susceptibility Electrical Fast Transients/Bursts On Mains Surge Min. 3,000 1,500 500 Typ. % mV Pk - Pk mSec %/°C General Parameter Isolation Voltage EMI/RFI EMC Compliance Switching Frequency Max. Units VAC EN 55022 Level B IEC/EN 61000-4-2 Level 3 IEC/EN61000-4-3 IEC/EN 61000-4-4 Level 3 2 kV IEC/EN 61000-4-5 Level 3 1kV/2 kV 150 kHz Min. -25 Typ. +25 Units °C °C °C % Environmental Parameter Conditions MicroPower Direct 292 Page Street Suite D Stoughton, MA 02072 USA T: (781) 344-8226 F: (781) 344-8481 E: sales@micropowerdirect.com W: www.micropowerdirect.com Operating Temperature Range Storage Temperature Range Cooling Humidity Physical Case Size Case Material Weight Max. +70 +90 -25 +105 Free Air Convection (See Derating Curve) RH, Non-condensing 85 Ambient Case 2.75 x 1.88 x 0.92 Inches (70.0 x 48.0 x 23.5 mm) Non-Conductive Black Plastic (UL94-V0) 5.65 Oz (160g) Conditions Min. Typ. MIL HDBK 217F, 25°C, Gnd Benign 200 IEN 60950, IEC 60950 IEN 60950, IEC 60950 Max. Units kHours Reliability Speciﬁcations Parameter MTBF Safety Standards Safety Approvals www.micropowerdirect.com Model Selection Guide Model Number MPM-25S-05 MPM-25S-12 MPM-25S-15 MPM-25S-24 MPM-25S-48 Input Current (A) 115 VAC 0.42 0.42 0.42 0.42 0.42 230 VAC 0.23 0.23 0.23 0.23 0.23 Voltage (VDC) www.micropowerdirect.com Output 1 (Vout 1) Current (A) Load Typ. Reg. 4.10 ±1.0% 2.10 ±1.0% 1.60 ±1.0% 1.10 ±1.0% 0.50 ±1.0% Over Volt. Protection (VDC) Efﬁciency (%, Typ) 5.0 12.0 15.0 24.0 48.0 6.5 20.0 20.0 30.0 60.0 85 85 85 85 85 Notes: 1. Load regulation is measured for an output change of 10% to 90% at nominal input line. For multiple output models, the loads are balanced. 2. As shown in the connection diagram at right, a simple external circuit may be used to adjust the power supply output ±10%. To adjust the output DOWN, connect a 5%, 3W resistor between the plus output pin and the Vout trim pin. To adjust the output UP, connect a 5%, 3W resistor between the minus output pin and the Vout trim. Contact the factory for resistor values needed to achieve a speciﬁc output. 3. It is recommended that a fuse be used on the input of a power supply for protection. For the MPM-25 series, a 3.15A/250 VAC slow blow should be used. Derating Curve Mechanical Dimensions Typical Connection Typical Component Values Vout 5.0 12.0 15.0 24.0 48.0 C1 330 µF/16V 330 µF/25V 330 µF/25V 120 µF/35V 68 µF/35V C2 Fuse TVS P6KE6.8A P6KE16A P6KE20A P6KE33A P6KE33A Pin Connections Pin 1 2 3 4 8 Trim Function AC-Ground AC-Neutral AC-Line -Vout +Vout Trim Notes: • All dimensions are typical in inches (mm) • Tolerance x.xx = ±0.01 (±0.25) 0.01 µF/25V 3.15A/ 250 VAC Notes: 1. C1 is a high frequency, low resistance electrolytic capacitor. Refer to the suppliers speciﬁcations for capacitance/current ratings. 2. Voltage derating on all capacitors should be 80% or higher. 3. C2 eliminates high frequency noise. 4. The power supply includes an internal TVS. If the user requires a tighter OVP threshold, an external TVS may be connected as shown. MicroPower Direct We Power Your Success - For Less! 292 Page Street Ste D Stoughton, MA 02072 • TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropowerdirect.com

下载 PDF

MPM-25S-24

1. 物料型号： - 型号系列：MPM-25S Series - 具体型号包括：MPM-25S-05、MPM-25S-12、MPM-25S-15、MPM-25S-24、MPM-25S-48

2. 器件简介： - 描述：25W输出功率的通用输入、微型、PC安装式AC/DC电源。 - 特点：全球通用85-264VAC输入、EN 60950认证、可调输出、满足EN55022 B级、超过200,000小时MTBF、紧凑型PC安装机箱。

3. 引脚分配： - 引脚1：AC-Ground - 引脚2：AC-Neutral - 引脚3：AC-Line - 引脚4：-Vout - 引脚8：+Vout - Trim：Trim

4. 参数特性： - 输入电压范围：85-264VAC - 输入频率：47-63Hz - 输出电压和电流：根据型号选择指南 - 输出电压精度：±2.0% - 线路调整率：±0.5% - 负载调整率：根据型号选择指南 - 纹波和噪声（20 MHz）：50 mV Pk-Pk - 保持时间：115VAC时20毫秒，230VAC时80毫秒 - 温度系数：±0.02%/°C - 短路保护：连续（自动恢复） - 过载保护：典型输出功率的110%

5. 功能详解： - 该系列电源提供25W输出功率，具有全球通用的输入电压范围，满足多种安全和电磁干扰标准，具有高MTBF和紧凑的尺寸，适合PC安装。

6. 应用信息： - 适用于需要高效率、高可靠性和紧凑型设计的AC/DC电源转换的应用场合。

7. 封装信息： - 尺寸：2.75 x 1.88 x 0.92英寸（70.0 x 48.0 x 23.5毫米） - 材料：非导电黑色塑料（UL94-V0） - 重量：5.65盎司（160克）

MPM-25S-24 价格&库存

-> 查询更多价格&库存

很抱歉，暂时无法提供与“MPM-25S-24”相匹配的价格&库存，您可以联系我们找货

免费人工找货

搜索历史

MPM-25S-24

相关技术文章