SFP-O3D-XLR

Datasheet Datasheet 155 Mbps SFP Transceiver SFP-O3D-XLR Features Designed for SFF-8472 and SFF-8074i compliance (SFP) 100 - 155 Mbps data rates - SONET OC-3/STM-1 - Fast Ethernet Class 1 laser (Tx): 1550 nm 170 km distance Digital Diagnostics (SFF-8724) Commercial temperature rating General Operations Parameter Supply Voltage Total Current Power Supply Noise Rejectiona Operating Temperature of SFP Caseb Storage Temperature Data Rate OC-3/STM-1 a) 20 Hz to 155 MHz b) Maximum Relative Humidity is 85%, non-condensing Symbol Vcc Icc PSR Top Tst DR Min. 3.135 100 -5 -40 100 Max. 3.465 300 70 85 155 Unit V mA mVp-p ºC ºC Mbps Transmitter Specifications (Optical) Parameter Optical Power Average Launch Power (Tx: Off ) Extinction Ratio Eye Mask Optical Jitter Generation Optical Rise Timec Optical Fall Timec Mean Tx Wavelength: 1550 Spectral Width (20 dB) Side Mode Suppression Ratio Dispersion Penalty (150 km) Relative Intensity Noise Reflection Tolerance c) 20% - 80% values Jgen Symbol Pop Poff Min 1 10 1500 30 -24 Max 5 -45 0.002 1000 1000 1580 1 2 -120 - Unit dBm dBm dB UI ps ps nm nm dB dB dB/Hz dB ER SONET/SDH Compliant tr tf λ Δλ SMSR DP RIN rp 1 Datasheet Transmitter Specifications (Electical) Parameter Input Differential Impedence PECL Single-Ended Data Input Swing TxFault_Fault TxFault_Normal TxDisable_Disable TxDisable_Enable Symbol Rin Vin,p-p Vfault Vnormal Vd Ven Min 80 250 2 Vee 2 Vee Max 120 1200 Vcc Vee + 0.5 Vcc Vee + 0.8 Unit Ω mV V V V V Receiver Specifications (Optical) Parameter Receive Powerd Damage Threshold for Receiver Mean Rx Wavelength: 1550e LOS Assert LOS De-assert LOS Hysteresis d) at 10-10 BER, PRBS 223-1 e) Operational over 1200 nm to 1625 nm range Symbol Rsens,low/high Pin,damage λ LOSA LOSD HYS Min -42 (sensitivity) 4 1480 -52 0.5 Max -8 (saturation) 1580 -42 - Unit dBm dBm nm dBm dBm dB Receiver Specifications (Electrical) Parameter PECL Single Ended Data Output Swing Data Output Rise Time Data Output Fall Time Symbol Vout, p-p tr tf Min 185 Max 800 2 2 Unit mV ns ns Timing and Electrical Parameter Tx Disable Negate Time Tx Disable Assert Time Time To Initialize, Including Reset of Tx Fault Tx Fault Assert Time Tx Disable To Reset LOS Assert Time LOS De-assert Time Serial ID Clock Rate RX_LOS Voltage (High) RX_LOS Voltage (Low) LOS Output Voltage-Fault LOS Output Voltage-Normal MOD_DEF (0:2)-High MOD_DEF (0:2)-Low Symbol t_on t_off t_init t_fault t_reset t_loss_on t_loss_off f_serial_clock VLOS fault VLOSnormal Vh Vl Min 10 2 2 Vee 2 Vee Max 5 10 300 100 100 100 100 0.8 Vcc Vee + 0.5 Vcc Vee + 0.5 Unit ms μs ms μs μs μs μs KHz V V V V V V 2 Datasheet Digital Diagnostics Parameter Temperature Voltage Bias Current TX Power RX Power Range -5 to 70 0 to Vcc 0 to 120 1 to 5 -42 to -10 Accuracy ±3 0.1 5 ±3 ±5 Unit ºC V mA dBm dBm Calibration Internal Internal External External External Formula Tc(C)=Tad(16 bit signed twos complement)/256 V(Volts)=Vad(16 bit unsigned integer)*0.1 I(mA)=Islope*Iad(16 bit unsigned integer)+Ioffset TX_PWR(μW)=TX_PWRslope*TX_PWRad(16 bit unsigned integer +TX_PWRoffset RX_PWR(μW)=A0+A1*x+A2*x^2+A3*x^3+A4*x^4 Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Function VeeT TX_FAULT TX_DISABLE MOD_DEF2 MOD_DEF1 MOD_DEF0 NC LOS Notes TX GND Open Collector Internally Pulled High Serial Data Input Serial Clock Input Internally Grounded Not Connected Open Collector RX Ground RX Ground RX Ground RX Data Negative RX Data Positive RX GND RX Power TX Power TX GND TX Data Positive TX Data Negative TX GND VeeR VeeR VeeR RXDRXD+ VeeR VccR VccT VeeT TXD+ TXDVeeT Ordering Information Wavelength (nm) Description Distance Range (km) 60 - 170 Connector Data Rate (Mbps) SFP-O3D-XLR SFP FE/OC3 Transceiver 100 - 155 1550 Dual LC White 3 Bail Latch Color Model Datasheet Outline Drawing - Units in mm(inch) Regulatory Compliances RoHS directive; China RoHS; California RoHS Law, USA and Canada UL listing; 21CFR 1040.10 and 1040.11; SFP MSA SFF-8074i; SFF-8472; Telecordia GR-468; GR-253/STM G.957 compliance Warnings Handling Precautions: This device is susceptible to damage as a result of electrostatic descharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indeirect radiation. MRV has more than 50 offices throughout the world. Addresses, phone numbers and fax numbers are listed at www.mrv.com. Please e-mail us at sales@mrv.com or call us for assistance. MRV Los Angeles 20415 Nordhoff St. Chatsworth, CA 91311 800-338-5316 818-773-0900 MRV Boston 295 Foster St. Littleton, MA 01460 800-338-5316 978-952-4700 MRV International Business Park Moerfelden Waldeckerstrasse 13 64546 Moerfelden-Walldorf Germany Tel. (49) 6105/2070 Fax (49) 6105/207-100 All statements, technical information and recommendations related to the products herein are based upon information believed to be reliable or accurate. However, the accuracy or completeness thereof is not guaranteed, and no responsibility is assumed for any inaccuracies. Please contact MRV Communications for more information. MRV Communications and the MRV Communications logo are trademarks of MRV Communications, Inc. Other trademarks are the property of their respective holders. MRV-OP-SFPO3DXLR-011309 3020038-001 Rev. A2 Copyright ©2009 MRV Communications, Inc. All Rights Reserved.