HN-1510

Built on the heritage of the original FHSS family of modems and combining the advanced features of the WIT2410 OEM module, there is a HN 10 Series modem that suits every need, from the relative comfort of an office to the harsh conditions on the factory floor to the unpredictable weather of an outdoor location. Based on 2.4GHz frequency hopping spread spectrum technology, all HN 10 Series modems provide extraordinary range while providing immunity to jamming and multipath fading. All backed by extensive experience in wireless technology. All HN 10 Series standalone modems feature a high data rate (460Kbps over the air) and long range (over 5 miles using HN 10 external gain antennas). Both point-to-point and pointto-multi-point network configurations are supported. HN510 HN-1010 HN-1510 HN 10 Series HN-510 HN1010 HN-1510 HN2010 HN-3010 2.4 GHz StandAlone Modems HN-2010 HN-3010 HN-510 HN-1010 HN-1510 HN-2010 HN-3010 The HN-510 has the same components as its ruggedized siblings in a desktop-style enclosure that provides compact size and weight with a built-in rechargeable battery pack. Simply connect to a PC’s RS-232 port using the 510’s DB-9 connector and it’s ready to go. Front panel LEDs give complete power and communications status at a glance. The HN-1010 is enclosed in a NEMA 4X and I.P. 66 rated housing and can operate outdoors from -30OC to +70OC. The unit features a 9 pin I/O connector for data, power, and flow control. Transmit and receive data are RS485 compatible differential signals while the flow control lines are single-ended RS-232. This interface can drive up to 250 feet of cable and can be converted to plain RS-232 using the HopNet 3500 data/power adapter. The HN-1510 features a rugged enclosure for indoor industrial applications. The HN-1510 has a standard DB-9 connector for I/O and all data and flow control lines are RS-232 signals. Power is supplied via a separate 2-pin connector. The HN-1510 also provides a 4 LED readout for power and status indications. The HN-2010 is a dual wireless modem repeater that can be used to create complex extended range networks, either point-topoint or point-to-multi-point. Half and full duplex I/O rates from 1200bps to 230.4Kbps are supported. The HN2010 is housed in a NEMA 4X and I.P. 66 rated enclosure for outdoor operation between -30OC and +70OC. A standard DB-9 data connector is provided to allow configuration of the repeater. Because two wireless modems are used back-toback, the full throughput of the data channel is available. Single modem, store and forward repeaters reduce the throughput of the entire system and add latency. The HN-3010 is a compact stand-alone modem with an integrated patch antenna. Housed in a NEMA 4X and I.P. 66 enclosure, the HN3010 is a cost-effective, one-piece, pole-mounted transceiver. The HN-3010 has an operating temperature range of -30OC to +70OC. A single 9 pin connector provides data, flow control, and power. Data signals are differential RS-485 compatible, while the flow control lines are RS232. Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved. 2010 HN-10 Series 10/11/16 1 of 2 www.murata.com Specifications HN-510 HN1010 HN-1510 Frequency Band HN-2010 HN-3010 2401 – 2483 MHz Licensing Unlicensed under FCC Part 15, ETSI 300.328 Number of Channels 75 Hopping Patterns User configurable, 64 patterns (networks) available I/O Data Rate Up to 230.4 Kbps asynchronous RF Channel Rate 460 Kbps Line-of-Sight Range >5 Miles with 9 dB omni antenna RF Bandwidth 750 KHz Modulation Type GFSK Output Impedance 50 ohms Network Protocol ARQ: CSMA/CA or TDMA Transmit Power +18dBm +18 dBm +18 dBm +18 dBm Receive Sensitivity -93 dBm -93 dBm -93 dBm -93 dBm EIRP: +24 dBm -99 dBm Power Requirements 5Vdc 750mA max. 9Vdc – 24Vdc 160mA typ. @ 9 Vdc 750mA surge 9Vdc – 24Vdc 160mA typ. @ 9Vdc 750mA surge 13Vdc – 24Vdc 500mA min. @ 13Vdc 9Vdc – 24Vdc 160mA typ. @ 9Vdc 750mA surge Serial Data Interface Async. RS-232 Async. RS-485/RS-232 Async. RS-232 Async. RS-232 Async. RS-485/RS-232 HN-1010 HN-1510 HN-2010 HN-3010 Mechanical Specifications HN-510 Antenna Case Materials External External External 2 External Integrated patch Plastic Aluminum Aluminum Aluminum UV stabilized polyamide NEMA 4X, IP 66 Dimensions(mm) NEMA 4X, IP 66 NEMA 4X, IP 66 130 x 95 x 25 213 x 142 x 53 200 x 145 x 51 213 x 145 x 76 175 x 160 x 61 275g 820g 725g 1590g 570g Reverse SMA TNC TNC TNC n/a DB-9 Conxall model# 3282-9SG-528 DB-9 DB-9 Conxall model# 3282-9SG-528 2-Pin DIN Conxall model# 16282-2SG-311 In data connector Conxall model# 16282-2SG-311 In data connector HN-1010 HN-1510 HN-2010 HN-3010 Weight Antenna Connector Data Connector Power Connector Environmental Specifications HN-510 Temperature Range Humidity 0OC to + 50OC -30OC to + 70OC 95% at + 40OC, non-condensing Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved. 2010 HN-10 Series 10/11/16 2 of 2 www.murata.com