MM121650

.1 .6 Dia .2 6 5+/-0.1 Dia .6 11 SMA-Female Dia. 3.8 (6.4) Dia. 3.2 Dia. 2.2+/-0.1 Preliminary Specification of COAXIAL CONNECTOR Written by H. Kitaguchi Preliminary SPEC No. : NMM04-PL0006C Checked by M. Atokawa Part Number : MM121650 Date 28/Feb./2014 SPECIFICATION Revised A: 30/Sep./’14 OM, B: 10/Jun./’16 MA C: 6/Jan./’19 II 1. MECHANICAL C>B> Automatic measurement probe for LSC-Male. MM121662 and MM121661 are used as calibration adapter. LSC-Female a. Di 1.5 12.5 3.3 20.2+/-0.3 15 3 6 Scale: Free Tolerance Unless Otherwise Specified: +/- 0.5 Unit: mm Figure.1 Construction 2. RATING: Item Specification 30Vr.m.s. maximum DC to 6GHz 50 -40C to +85C 500 M minimum No evidence of break down in AC300Vr.m.s, 1minute 70mΩmax. Voltage Rating Nominal Frequency Range Nominal Impedance Temperature Rating Insulation Resistance C> Withstanding Voltage Initial Contact Resistance (without conductor resistance) A> Voltage Standing Wave Ratio (V.S.W.R.) A> Insertion Ioss A> Durability Meet the requirements of following spec. 1.4 max. (DC to 3GHz) 1.8 max. (3GHz to 6GHz) 0.6dB max. (DC to 3GHz) 0.8dB max. (3GHz to 6GHz) 250k cycles 1/3 Preliminary Specification of COAXIAL CONNECTOR Preliminary SPEC No. : NMM04-PL0006C Part Number : MM121650 Written by Checked by Date H. Kitaguchi M. Atokawa 28/Feb./2014 3. USE THIS PRODUCTS 3.1 The directions for attachment to measurement fixture. The probe must be attached to fixture at the two screw holes in probe flange. (Figure 2) Screw Hole Figure.2 Screw hole position C> 0+/-0.4mm (Acceptable engagement range) Unmating Mating Figure.3 Acceptable engagement range to LSC-Male 2/3 (17.86 to 19.36) 17.7 to 19.2 (Using Area) 20.2 3.2 The tolerance of position against MM7829-2700. Probe has the centering function by itself, +/-0.4mm is permitted against the hole center of LSC-Male. Please avoid needless force to SMA-Female connector to come back the original position when disengagement of probe. The engagement strokes from the bottom surface of flange to the tip of probe is 17.7mm to 19.2mm. (Figure 3) Preliminary Specification of COAXIAL CONNECTOR Preliminary SPEC No. : NMM04-PL0006C Part Number : MM121650 Written by Checked by Date 3.3 The slant angle tolerance of probe against LSC-Male. (Figure 4) To have the stable measurement, MM121650 slant angle must be 0+/-2degree. 0+/-2degree Figure.4 Probe Shape Operation Manual for Auto Measurement probe (MM121650) 3/3 H. Kitaguchi M. Atokawa 28/Feb./2014